Руководство по эксплуатации Code Alarm CA 110

Краткое содержание страницы № 1

CA 110 Owners Manual

Краткое содержание страницы № 2

Your System has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. Press and release the LOCK button of your key chain transmitter one time. The parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming th

Краткое содержание страницы № 3

PASSIVE ARMING: If the passive arming feature has been selected: Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. The dash mounted LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point is opened during the 30 second arming cycle, arming will be suspended.

Краткое содержание страницы № 4

DISARMING THE SYSTEM: As you approach the vehicle, press and release the DISARM button on the keychain transmitter. The parking lights will flash 2 times, the siren will chirp 2 times, and the dash mounted LED will turn off. If you have the optional door lock/unlock circuit installed, the doors will unlock. NOTE: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming. Opening any door will suspend

Краткое содержание страницы № 5

parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern. If the LED flashes 2 times... pause, 2 times... pause etc., then an intrusion attempt was made to open the hood, trunk, or by an accessory triggering device. Check the vehicle for indications of forced entry to these openings. If the LED flashes 3 times... pause, 3 times... pause etc., then an intrusion attempt was made to the vehicle doors. Check all doors for indica

Краткое содержание страницы № 6

MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH/ MANUAL OVERRIDE Your system can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. To by-pass the alarm system; 1. Open the vehicle door. The alarm will sound. 2. Turn the ignition key to the ON position. 3. Within 5 seconds, press and release the valet pushbutton switch. The alarm system will stop sounding

Краткое содержание страницы № 7

ADDITIONAL REMOTE FUNCTION CHANNEL 3 The system has an optional feature, (Channel 3), that can be connected to the Trunk Release. To operate channel 3, press and hold the UNLOCK button of your keychain transmitter for four seconds. ANTI HI-JACK MODE OPERATION 1. a) With the ignition switch on, and the doors closed, press and hold both buttons of your keychain transmitter for 1 second to initiate the anti hi-jack mode or open the door any time the ignition is on. b) If while the ignition is

Краткое содержание страницы № 8

CA-110 SYSTEM FUNCTIONS AT A GLANCE ALARM DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 5 FLASH...PAUSE = INTRUSION ZONE 5 4 FLASH...PAUSE = INTRUSION ZONE 4 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 ALARM SIREN CHIRP INDICATION 1 CHIRP* = ARM 2 CHIRPS* = DISARMED 3 CHIRPS = ARMING WITH ENTRY POINT OPENED 4 CHIRPS = DISARM AFTER INTRUSION ALARM PARKING LAMP INDICATIONS 1 FLASH = ARM 2 FLASH = DISARM 3 FL

Краткое содержание страницы № 9

Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts dir

Краткое содержание страницы № 10