Руководство по эксплуатации ADC 6016

Краткое содержание страницы № 1

Electronic
11. HOW TO CONTACT US
Blood Pressure
Detailed user information about our products
as well as services can be found at:
www.adctoday.com
Printer
TM
For use with ADvantage Advanced Automatic
Blood Pressure Monitors; Models 6014 and 6016.
6014P
Instruction Manual
PLEASE NOTE:
THIS MEDICAL INSTRUMENT MUST BE
USED ACCORDING TO INSTRUCTIONS
American Diagnostic Corporation
55 Commerce Drive, Hauppauge, New York 11788
TO ENSURE ACCURATE READINGS.
Telephone: 631-273-9600
®
Fax: 631-273-9659

Краткое содержание страницы № 2

8. WARRANTY Diagnostic Printer The diagnostic printer 6014P is guaranteed for 2 years from date of purchase. The Instruction Manual warranty does not apply to damage caused by improper handling, accidents, improper use, or alterations made to the device by third parties. Table of Contents Batteries or damage from batteries are not covered under warranty. 1. Introduction 9. INTERNATIONAL QUALITY STANDARDS 2. Printer Parts Meets the requirements of MDD 93/42/EEC (Europe) and U.L. (USA). 3. Set

Краткое содержание страницы № 3

® Malfunction Remedy 1. INTRODUCTION The LED remains flashing while 1. Check whether the batteries are installed with ® TM the printer is switched on The diagnostic printer 6014P is a compact unit for ADC Advantage Advanced the correct polarity. although the batteries are Automatic Blood Pressure Monitors. The enhanced printer covers both character and 2. If the LED is unusually flashing, remove the good. graphic print. High-reliability and high-quality print is assured due to the ultra simple

Краткое содержание страницы № 4

® 3. SETTING UP THE PRINTER 5.1. How to Print a Chart and all Readings a) Connect the printer to the monitor and switch the printer ON. 3.1. Inserting the Batteries b) Press the PRINTER button of the monitor and hold it for at least 3 seconds. The The battery compartment is located on the display will change from “Pr1” followed by “Pr2”. Release the PRINTER button and the underside of the device (See illustration). printer will print all stored measurements with a corresponding chart. a) Remove

Краткое содержание страницы № 5

4.6. Cutting Paper 3.2. Using an AC Adapter Once you finish the printing job, check the paper to It is possible to operate this printer ® see if it is easy to tear off. through the ADC AC adapter • If it is not long enough to tear off, depress the (output 6V DC / 600mA with DIN plug). Make PAPER FEED button to lengthen the paper. certain that you use an AC adapter which ful- 90 ° Note: fills the legal requirements. Paper cutter • Don’t pull out the paper if you would like to cut it. • To cut

Краткое содержание страницы № 6

3.4. Inserting the Paper Roll 4. CARRYING OUT A PRINTING OPERATION • Switch the printer on by sliding the I/O (ON/OFF) switch to the left. 4.1. Power On Before powering the printer, check that the batteries • Lift the top cover by squeezing the sides are inserted properly. with your fingers and pulling up. • Push the O/I ON/OFF switch to the left side in order to power the printer. • Insert the ”under” end of paper roll into the slot • The green LED will light. of the internal compartment. •