Краткое содержание страницы № 1
AD-310 Phase 7
(with Non-Tilting Options)
Installation Manual
4.(,,.-.(
5
&
6&
&
6
%
!
7&
7
6
"
#
6 !
#
$
Краткое содержание страницы № 2
Краткое содержание страницы № 3
2 , 3 4 35 / +) , - . 3 ' # . / 0
Краткое содержание страницы № 4
%#&-%& .%&*$%#'($ */- 0$ %,*)12!*&# !$%&$ . & %&+()% .*/%" &%3 +%#
5
6
#( ."*-%# /$ %%4!(.3%/$*/#5 & .%)(0(%#(/$ %(/ $*""*$( /3*/!*"(/)"!#%#'($ $ %#&-%& . '("" ,% 8
Краткое содержание страницы № 5
Table of Contents
# & ' ############################################################################################################### A B# , @ &
###################################################################################################################### C
# , && D
Краткое содержание страницы № 6
# 2 ################################################################################################################################### CJ B# "
############################################################################################################################# CG 2# /
& ################################################################################
Краткое содержание страницы № 7
SECTION I IMPORTANT INFORMATION A. RECEIVING AND HANDLING The dryer is shipped in a protective stretch wrap cover with protective cardboard corners and top cover (or optional box) as a means of preventing damage in transit. Upon delivery, the dryer and/or packaging, and wooden skid should be visually inspected for shipping damage. If any damage whatsoever is noticed, inspect further before delivering carrier leaves. Dryers damaged in shipment: 1. ALL dryers should be inspected upon receipt an
Краткое содержание страницы № 8
B. SAFETY PRECAUTIONS WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury, or loss of life. WARNING: The dryer must never be operated with any of the back guards, outer tops, or service panels removed. PERSONAL INJURY OR FIRE COULD RESULT. 1. DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. Purchaser/user should cons
Краткое содержание страницы № 9
7. A program should be established for the inspection and cleaning of lint in the heating unit area, exhaust ductwork, and inside the dryer. The frequency of inspection and cleaning can best be determined from experience at each location. WARNING: The collection of lint in the burner area and exhaust ductwork can create a potential fire hazard. 8. For personal safety, the dryer must be electrically grounded in accordance to local codes and/or the National Electrical Code ANSI/NFPA NO. 70-LATEST
Краткое содержание страницы № 10
SECTION II SPECIFICATIONS/DIMENSIONS AND COMPONENT IDENTIFICATION A. SPECIFICATIONS (GAS AND STEAM) MAXIMUM CAPACITY (DRY WEIGHT) 310 lbs 141 kg BASKET (TUMBLER) DIAMETER 62-1/2” 158.75 cm BASKET (TUMBLER) DEPTH 60” 152.4 cm BASKET (TUMBLER) VOLUME 106.5 cu. ft. 3.02 cu. m. DRIVE MOTOR 5 HP 3.73 kw DOOR OPENING (DIAMETER) 36-3/4” w x 43” h 93.3 cm x 109.2 cm DOOR STILL HEIGHT - LEVEL 36-1/2” 92.71 cm COMPRESSED AIR 80 PSI 5.51 bars COMPRESSED AIR CONNECTION 3/8” F.P.T. VOLTAGE AVAILABLE 208-600
Краткое содержание страницы № 11
B. DIMENSIONS AND COMPONENT LOCATION 310 NON-TILT GAS MODEL 7
Краткое содержание страницы № 12
310 NON-TILT STEAM MODEL 8
Краткое содержание страницы № 13
SECTION III INSTALLATION PROCEDURES Installation should be performed by competent technicians in accordance with local and state codes. In the absence of these codes, the installation must conform to applicable American National Standards: ANSI Z223. 1-LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA NO. 70-LATEST EDITION (National Electrical Code) or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-M91 (Natural Gas) or CAN/CGA-B149.2-M91 (Liquid Pr
Краткое содержание страницы № 14
1. Reassembly Instructions For Gas Dryer Shipped In Two (2) Pieces 10
Краткое содержание страницы № 15
a. Reassembly Instructions For Non-Tilt Gas Dryers: Lift the basket (tumbler) section onto the base. 1) The dryer has four (4) support posts assemblies which are located in each corner of the base. On top of each post assembly is a clevis block which must be bolted to the basket (tumbler) section. Use the 4-1/2” diameter x 1-1/8” long bolts and lock washers to bolt each clevis block to the basket (tumbler) section. (Refer to View 1 on the previous page.) 2) Basket (tumbler) power cable reconne
Краткое содержание страницы № 16
2. Reassembly Instructions For Steam Dryer Shipped In Two (2) Pieces 12
Краткое содержание страницы № 17
a. Reassembly Instructions For Non-Tilt Steam Dryers: Lift the basket (tumbler) section onto the base. 1) The dryer has four (4) support posts assemblies which are located in each corner of the base. On top of each post assembly is a clevis block which must be bolted to the basket (tumbler) section. Use the 4-1/2” diameter x 1-1/8” long bolts and lock washers to bolt each clevis block to the basket (tumbler) section. (Refer to View 1 on the previous page.) 2) Basket (tumbler) power cable recon
Краткое содержание страницы № 18
B. LOCATION REQUIREMENTS The non-tilting model dryer requires 18-inches (45.72 cm) of space on each side of the dryer and 24-inches (60.96 cm) of space behind the unit for ease of service. A minimum of 12-inches (30.48 cm) must be allowed between the top of a gas dryer and the ceiling. A ceiling height of 120-inches (304.8 cm) is required for gas dryers, and a ceiling height for 130-inches (330.2 cm) is required for steam dryers. The dryer must be leveled for proper operation. If shimming i
Краткое содержание страницы № 19
C. FRESH AIR SUPPLY REQUIREMENTS When the dryer is operating, it draws in room air, heats it, passes this air through the basket (tumbler), and exhausts it out of the building. Therefore, the room air must be continually replenished from the outdoors. If the make-up air is inadequate, drying time and drying efficiency will be adversely affected. Ignition problems and sail switch “fluttering” problems may result, as well as premature motor failure from overheating. Air supply (make-up air) mu
Краткое содержание страницы № 20
D. EXHAUST REQUIREMENTS NOTE: For 1 door dryers, the 24-inch (60.96 cm) diameter exhaust duct exits from the rear of the base. For 2 door dryers, the 24-inch (60.96 cm) diameter exhaust duct exits from the left side of the base. 1. General Exhaust Ductwork Information Exhaust ductwork should be designed and installed by a qualified professional. Improperly sized ductwork will create excessive back pressure which results in slow drying, increased use of energy, overheating of the dryer, and sh
