Руководство по эксплуатации Kenwood eXcelon KDC-X659

Краткое содержание страницы № 1

KENWOOD
CD-RECEIVER
KDGX659
INSTRUCTION MANUAL
KENWOOD CORPORATION
KDGMP819
KDC-719 ~
KDGX559 ~
$I$$’
COMPACT
0
cl]oolE SIRIUS
DIGITAL NOI0 Satellite Radio
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you
obtain the best performance from your new CD-receiver.
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided

Краткое содержание страницы № 2

Menu system . . ..--.~--..-~~--..---...--.. 25 Safety precautions . . . . . . . . . . . . . . . . . . . . . . 4 Tuner featurgs . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 =e Tuning Mode Menu System Notes on playing MP3 ..-.......... 6 Tuning Security Code About CDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Direct Access Tuning Touch Sensor Tone General features . . . . . . . . . . . . . . . . . . . . . . . . . 9 Station Preset Memory Manual Clo

Краткое содержание страницы № 3

A Warnina pmq _ ) ACAUTION 1 This equipment has been tested and found to Use of controls or adjustmgnts or performance comply with the limits for a Class B digital of procedures other than those specified device, pursuant to Part 15 of the FCC Rules. herein may result in hazardous radration These lrmits are designed to provide exposure. reasonable protection against harmful In compliance with Federal Regulations, Interference In a residential installation. This following are reprod

Краткое содержание страницы № 4

Safety precautions IMPORTANT INFORMATION 1 AWARNING 1 1 ACAUTION_ 1 About the disc changer/CD player to To prevent injury&r fire, take the To prevent damage to Ihe machine, be connected: following precautions: take the following precautions: To connect a disc changer having the “O-N” l Insert the unit all the way in until it is fully l Make sure to ground the unit to a negative switch to this unit, set the “O-N” switch to “N”. locked in place. Otherwise it may fall out of 12V DC power su

Краткое содержание страницы № 5

Lens Fogging 1 NOTE 1 Right after you turn on the car heater in cold l If you experience problem*s during weather, dew or condensatron mwform on installatron, consult your Kenwood dealer. the lens in the CD player of the unit. Called lens fogging, CDs may be impossrble to play. l If the unit fails to operate properly, press the In such a situation, remove the disc and wart Reset button. The unit returns to factory for the condensation to evaporate. If the unit settings when the Reset b

Краткое содержание страницы № 6

Notes on playing MP3 (KDC-X659/ KDC-MP819) This unit can play MPS(MPEG1, 2, 2.5 Audio Layer 3). Note, Entering ID3 tag however, that the MP3 recording media and formats acceptabl% The Displayable ID3 tag is ID3 version are limited. When vyriting MP3, pay attention to the following I.!?” restrictions. For the character code, refer to the List of Codes. Acceptable media The MP3 recording media acceptable to this unit are CD-ROM, CD-R, and CD-RW. Entering file and folder names When using

Краткое содержание страницы № 7

MP3 playing order When a Track Search is executed with file .bO being played . When selected for play, Album Search, Track Search, or for Album Operation of the button CWEfYr- Select, files and folders arg accessed rn the order in which they were file number IU Rlltm” I m Button written by the CD wrrter. Because of this, the order in whrch they are expected to be played may not match the order in which they are actually played. You may be able to set the order In whrch MP3 are to be pl

Краткое содержание страницы № 8

About CDs Handling CDs CD cleaning l Don’t touch the recording surface of the CD. Clean from the Oenter of t& disc and move outward. Removing CDs When removing CDs from this unit pull them l CD-R and CD-RW are easier to damage than out horizontally. a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. CDs that can’t be used l Don’t stick tape etc. on the CD. l CDs that aren’t round can’t be used. Also, don’t use a CD with tape stuck on it.

Краткое содержание страницы № 9

General features .-“.._- - Release button I TurnitqF ON the Power S.A Press the [SRCI button. When the power is ON, the (page 26) IS displayed @ as “CODE ON’ or “CODE OFF’ Turning OFF the Power Press the [SRC] button for at least 1 second. Press the tSRC1 button. DISP/ .I1 NAME.S Source required Display Tuner “TUNER” “CD” CD “CD 2”/“DISC” External disc “AUX” Auxiliary input “ALL OFF” Standby (Illumination only mode) KDC-719 @ For Auxiliary input one of t

Краткое содержание страницы № 10

General features 2 Select the Sound type El Press the [Ql button. c Increasing Volume ““Each time the button is pressed the sound settrng switches. Press the [A] bttton. Sound setting Display Decreasing Volume Flat “FLAT” Press the [VI button. 1 User memory “User Preset” “ROCK” Rock Pops “POPS” Easy “EASY” “TOP 40” Top 40 Turning the volume down quickly. l User memory. The values set on the

Краткое содержание страницы № 11

Function ofthe KDC-MPSlS/KDC-71: Adjustment Item Display Range Bass Center Frequency* “Bass FRQ” 60/70/80/100 or 150 Hz L “Bass” -8-+8 Bass level Fine-tuning so that the System Q value is optimal when setting 1.00/1.25/1.50/2.00 Bass Q Factor* “Bass Q” the speaker type. Bass Extend* “Bass EXT” ON/OFF 1 Enter Standby Middle Center “MID FRQ” 0.5/l .0/l .5/2.0 kHz Press the [SRCI button. Frequency* Select the “ALL OFF” display. “MID” -8-+8 Middle level Middle Q Factor* “Middle Q”

Краткое содержание страницы № 12

General features In Woofer setting mode Function of the KDC-X659/KDC-X5E Display Woofer type “Woofer OFF” “OFF Fine-tuning so that me System Q value is optimal when setting “12in typeA” 12 in. A type the speaker and woofer type. 10 in. A type “1 Oin typea” 1 Enter Standby “12in typeB” 12 in. B type Press the [SRCI button. 10 in. B type “1 Oin typeB” Select the “ALL OFF” display. 12 in. C type “12in typeC” “1 Oin typeC” 10 in. C type 2 Enter Speaker & Woofer Setting mode 8 in

Краткое содержание страницы № 13

4 Select the character type Press the I)II] button. - Switch@@ the display mode. Each time the button &pressed the character type switches as Press the [DISPI button. shown below. Each time the button is pressed the Display mode switches as Character type shown below. Alphabet upper case Display Display mode Alphabet lower case “Display Type A” Upper and lower division display type Numbers and symbols Type that mainly uses the display upper part “Display Type B” Special characte

Краткое содержание страницы № 14

The Reference for the display content is after this operation’s explanation. Switching the information displayed in Standby. 4’Exit Display Control mode Press the [SAI button. 1 Enter Standby E Press the [SRCl button. l The same information can’t be displayed on the Upper part display @ Select the “ALL OFF” display and lower part display. l The Upper part display and Lower part display switching can be 2 Switch the display selected when “Display Type A’ is selected in

Краткое содержание страницы № 15

Lower Part Display In CD/ External disc source Display L Information I Spec8um Analyzer & Graphic “S/ANA+GRAPHIC” Upper Part Display * Spectrum Analyzer & Clock “S/ANA+CLOCK” information Display Spectrum Analyzer “S/ANA” “P-Time” Track Time Album name & Artist name “ALBUM/ARTIST” Disc name “DN PS” “TITLE/ARTIST” Song title & Artist name “DISC-TITLE” Disc title File name “FILE NAME” “TRACK-TITLE” Track title “FOLDER NAME” Folder name Lower Part Display “DN PS” Disc name

Краткое содержание страницы № 16

General features Function of the KDC-X659/KDC-X55: Turning the Non-fading output ON or OFF. Press the [NFI button for at least 1 second. 1 Select Auxiliary input source Each time the button is pressed Non-fading output switches ON Press the [SRCI button. or OFF. Select the “AUX” display. When it’s ON, “NF ON” is displayed. 2 Enter Auxiliary input display setting mode Press the [DISPI button for at least 2 seconds. The presently selected AUX Name is blinks. 3 Select the Auxiliary inp

Краткое содержание страницы № 17

Reattachinn the Facealate Function of the KDC-X659/KDC-X559 I 1 Align the shaft on the unit with the depression on the faceplate. Makes the sound different for the front channel and rear channel. 1 channel is the unit’s internal source, the other channel is the Auxiliary input source sound. Press the [S.Al button for at least 1 second. Each time the button is pressed for at least 1 second Dual Zone 2 Push the faceplate in until it clicks. System switches ON or OFF. The faceplate is l

Краткое содержание страницы № 18

Tuner features Cbgose the tuning mode. . Press the [AUTO] button. Each time the button is pressed the Tuning mode switches as I c shown below. Tuning mode Display Operation Auto seek “Auto 1” Automatic search for a station. Preset station “Auto 2” Search In order of the stations in the Preset memory. seek Manual “Manual” Normal manual tuning control. AUTO/ WC AME Selecting the station. 1 Select tuner source Press the [SRCI button. Select the “TUNER” display. 2 Select the band

Краткое содержание страницы № 19

Puttiwgtations with good reception in the memory Entering the frequency and tuning e automatically. 1 Select the band 1 Select the band for Auto Memory Entry Press the [FM] or [AMI button. Press the [FM] or [AMI button. 2 Enter Direct Access Tuning mode 2 Open Auto Memory Entry Press the [DIRECT] button on the remote. Press the [AMEI button for at least 2 seconds. “- - - -” is displayed. When 6 statlons that can be received are put in the memory 3 Enter the frequency Auto Memory E

Краткое содержание страницы № 20

Tuner features CD/MP3/External disc control features Display SNPS and Select the station. 1 Enter SNPP mode Press the [DNPPI button on the remote. When “SNPP” is displayed, SNPS displays the FMI, FM2, FM3 and AM bands in order. @ If the station has no name. the frequency IS displayed instead. Changing the display order Press the 1~1 or [HI button. F.SEL SCAN DISP Changing the displayed band Press the [FM] or [AM] button. 2 lf the station you want is displayed Press the [OK] button