Краткое содержание страницы № 1
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 1
MAINS POWERED
CARBON MONOXIDE ALARMS
WITH RECHARGEABLE LITHIUM CELL BACK-UP
Model Ei261ENRC
Model Ei261DENRC
WITH DIGITAL DISPLAY
Read and retain carefully for as long as the product is being used. Contains vital information on the
operation and installation. This leaflet should be regarded as part of the product.
If you are just installing the unit, this leaflet must be given to the householder. This leaflet is to be
given to any subsequent us
Краткое содержание страницы № 2
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 2 2
Краткое содержание страницы № 3
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 3 CONTENTS Page 1 IMPORTANT INFORMATION 4 6 2 CARBON MONOXIDE - THE SILENT KILLER 10 3 ALARM POSITIONING 15 4 INSTALLATION 20 5 TESTING 6 HOW TO DISTINGUISH BETWEEN CO ALARM & SMOKE ALARM WARNINGS 22 7 MAINTENANCE 22 24 8 LIMITATIONS OF CO ALARMS 25 9 HOW TO PROTECT YOUR FAMILY 27 10 GETTING YOUR CO ALARM SERVICED 27 11 FIVE YEAR GUARANTEE 12 TECHNICAL SPECIFICATIONS 28 30 13 TROUBLESHOOTING 32 14 ACCESSORIES 3
Краткое содержание страницы № 4
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 4 1. IMPORTANT INFORMATION WARNING: The Alarm should be permanently wired to the mains by a qualified electrician in accordance with IEE wiring regulations (BS7671). Install a Carbon Monoxide (CO) Alarm in every room that contains a fuel burning appliance, particularly rooms where people spend a lot of time e.g. bedrooms, kitchens and sitting rooms. In rooms with an appliance, install (preferably) on the ceiling (300mm from walls and between 1m t
Краткое содержание страницы № 5
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 5 WHAT TO DO WHEN THE ALARM SOUNDS: ? (1) Open the doors and windows to ventilate the area. (2) Turn off all fuel appliances where possible. (The alarm can be silenced immediately by pushing the Test/Hush button). (3) Evacuate the property leaving the doors and windows open. (4) Get medical help immediately for anyone suffering the effects of Carbon Monoxide poisoning (headache, nausea), and advise that Carbon Monoxide poisoning is suspected. (5)
Краткое содержание страницы № 6
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 6 The CO Alarm is no substitute for keeping chimneys and flues clear and in good condition, and all of your ? appliances serviced regularly according to the manufacturer’s instructions. Do not fit alarm until all building work is completed to avoid contamination. 2. CARBON MONOXIDE - THE SILENT KILLER 2.1 WHAT IS CARBON MONOXIDE ? Congratulations on becoming the owner of an Ei Carbon Monoxide Alarm. This will help protect you and your household f
Краткое содержание страницы № 7
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 7 A low level for a long period (e.g. 150 ppm for 90 minutes) can cause the same symptoms (a slight headache) as a high level of CO for a short period (e.g. 350 ppm CO for 30 minutes). Table A shows how exposure to different concentrations of CO generally affects people. Many cases of reported Carbon Monoxide poisoning indicate that while victims are aware they are not well, they become so disorientated they are unable to save themselves by e
Краткое содержание страницы № 8
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 8 2.3 WHAT HAPPENS WHEN YOUR CO ALARM DETECTS CARBON MONOXIDE ? When the Alarm detects potentally dangerous levels of CO, it flashes the red alarm light and then sounds a loud alarm if the CO persists. The digital display (Model Ei261DENRC only) indicates the CO level in parts per million (ppm) CO. Table B below shows how the CO Alarm reacts to different levels of CO gas and exposure time. At higher levels of CO the alarm turns on sooner. The rat
Краткое содержание страницы № 9
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 9 NEVER IGNORE THE ALARM Pre-Alarm: When the alarm detects over 50ppm CO the red light flashes every 2 seconds. This helps locate CO leaks as the unit gives an indication straight away (without this feature the CO level would need to be at 50ppm CO for 90 minutes for the horn to sound). Note the Pre-Alarm signal may be triggered by CO coming for example, from cooking with gas, from car engines or from nearby barbecues. This is usually not a conce
Краткое содержание страницы № 10
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 10 3. ALARM POSITIONING 3.1 IDEALLY A CARBON MONOXIDE (CO) ALARM SHOULD BE INSTALLED IN: - Every room containing a fuel burning appliance - Remote rooms where occupants spend a considerable amount of time - Every bedroom However if the number of CO Alarms is limited, the following points should be considered when deciding where best to fit the alarm(s) - If there is an appliance in a room where people sleep, place a CO Alarm in this room - Locat
Краткое содержание страницы № 11
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 11 - In an enclosed space (e.g. in or below a cupboard) - In a damp or humid area - Directly above a sink or cooker - Next to a door, window, air vent or anywhere that it would be affected by draughts - Next to an extractor fan - Where it would be obstructed, e.g. by curtains or furniture - In an area where the temperature could drop below –10°C or rise above 40°C - Where dirt or dust could block the sensor - Where it could be easily knocked or d
Краткое содержание страницы № 12
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 12 - If there is a partition in the room, the CO Alarm should be located on the same side of the partition as the potential source - In rooms with sloped ceilings, the CO Alarm should be located at the high side of the room (see Figure 3) 3.4 IF LOCATING THE CO ALARM IN A BEDROOM OR IN ROOMS REMOTE FROM A FUEL BURNING APPLIANCE (see Figure 3) - Mount the CO alarm relatively close to the breathing zone of the occupants Whatever position is chose
Краткое содержание страницы № 13
300mm 150mm 1 to 3 m DEAD AIR DON'T LOCATE 1 to 3 m HERE B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 13 CO Alarm Figure 1. Location in room with a fuel burning appliance - 1 to 3m from appliance - Ceiling 300mm (min) from walls - Wall 150mm vertically down from ceiling 13
Краткое содержание страницы № 14
300mm approx 1 to 2m B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 14 CO Alarm CO Alarm Figure 3. Location in bedroom & rooms Figure 2. Location in rooms with remote from the appliance sloped ceilings - 300mm from apex of ceiling - Wall mounted - High side of the room - Breathing level (approx. 1 to 2m above floor) 14
Краткое содержание страницы № 15
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 15 4. INSTALLATION The Alarm is designed to be permanently Figure 4 - Alarm Installation mounted, using its own built-in terminal block to connect it to the mains wiring. The LOCATION FOR TAMPERPROOF SCREW mounting plate can be screwed directly to GAS ENTRY HOLES (see page 16) the ceiling/wall. Alternatively it can be screwed to a standard junction box (BS 4662 single gang accessory box). The alarm requires a current of 60mA. The Alarm must not b
Краткое содержание страницы № 16
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 16 The Alarm must not be connected when the house wiring insulation is being checked with high Voltages i.e. do not use an insulation tester on the alarm. Do not use the CO Alarm on an intermittent basis, or as a portable detector for the spillage of combustion products from fuel burning appliances or chimneys. Mains operated Alarms should be installed and interconnected by a qualified electrician in accordance with the Requirements for Electrica
Краткое содержание страницы № 17
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 17 We strongly recommend that you check for the following before connecting the alarm: • check for Live and Neutral using a two probe tester. • check for Live using a neon tester. • check that the Interconnect wire is NOT connected to Live, Neutral or Earth. Do not use an Earth wire for the Interconnect line. Note:The Alarm does not need to be earthed. However the terminal marked is provided for the convenience of the installer so that an
Краткое содержание страницы № 18
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 18 TERMINAL SCREWS INSERT SCREWDRIVER TO LIFT AND REMOVE WIRE COVER WIRING L - LIVE CONDUIT KNOCK OUT N - NEUTRAL FOR SURFACE WIRING CONDUIT IC - INTERCONNECT WIRING CONDUIT SEALING GASKET KNOCK OUT FOR (MUST BE IN PLACE) MAINS WIRING SURFACE WIRING CONDUIT EARTH (IF PRESENT) RECESSED WIRING AREA Figure 5 - Surface Wiring Figure 6 - Recessed Wiring 11. Connect the mains power to the alarm circuit. Check the green light is on. The CO Alarm is n
Краткое содержание страницы № 19
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 19 4.1 INTERCONNECTING With interconnected alarms, when one unit detects CO all units alarm. All horns will sound but only units detecting CO will flash their red lights. A maximum of twelve Ei261ENRC/261DENRC CO Alarms may be interconnected along with an Ei128RBU & Ei128COV relay module (see “ACCESSORIES” on page 32). Alternatively, up to twelve Ei261ENRC /Ei261DENRC CO Alarms and Ei161RC/Ei164RC/Ei166RC Smoke/Heat Alarms may be interconnected p
Краткое содержание страницы № 20
B16132-R0-261ENRC-UC-ENG 7/11/07 11:52 AM Page 20 A maximum of 250 metres (820 ft) of wire can be used (maximum resistance between detectors 50 Ohms). Connect as shown in Figure 7. Alarms should be interconnected only within the confines of a single family living unit. If they are connected between different units there may be excessive nuisance alarms. Everybody may not be aware that they are being tested etc. If interconnected CO and Smoke/Heat Alarms are all sounding, the LOCATE switch on
