Руководство по эксплуатации Honeywell PROTECTORELAY R8184G

Краткое содержание страницы № 1

R8184G PROTECTORELAY
OIL PRIMARY
HOLE OR KNOCKOUT FOR
RED RESET
APPLICATION
CAD CELL LEADS
BUTTON
The TRADELINE intermittent ignition oil primary control
operates the oil burner, oil valve (if desired) and the ignition
LOW VOLTAGE
TERMINAL STRIP
transformer in response to a call for heat from the thermo-
stat. Through a C554 Cad Cell Flame Sensor, the R8184
monitors the burner flame and shuts down the system on
2
ignition failure or on flame failure during the run cycle. A light
4 x 4 JUNCTION
e

Краткое содержание страницы № 2

L1 (HOT) 1 FAN L2 RELAY T87F/Q539A COOLING TRANSFORMER R C COOLING G CONTROL Y R H JUNCTION BOX R8184G PROTECTORELAY CONTROL LINE VOLTAGE W THERMOSTAT BLACK X T(R) 2 SAFETY 2 SWITCH 1K L1 T(W) LIMIT (HOT) 3 LOCKOUT SAFETY 1 INDICATOR SWITCH 1K2 ORANGE VIOLET BURNER LED HEATER L2 MOTOR R1 SAFETY BILATERAL SWITCH SWITCH OIL VALVE 1K1 TRIAC CAD CELL (OPTIONAL) R2 F IGNITION CAPACITOR WHITE F 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 TO USE R8184 WITH LINE VO

Краткое содержание страницы № 3

CHECK CAD CELL 1. Disconnect power at system switch, circuit breaker or PUSH LEVER DOWN fuse. TO TRIP SAFETY SWITCH 2. Clean cell face with soft cloth. 3. Make sure cell is seated securely in socket. Be careful not to disturb socket position. 4. Reconnect cad cell leads to F-F terminals. 5. Reset safety switch, turn on power and set thermostat WHEN SAFETY SWITCH TRIPS TRIP SAFETY SWITCH BEFORE PERFORMING RESET BUTTON POPS OUT INDICATOR LIGHT COMES ON BURNER MAINTENANCE (TRADELINE ONLY) CAUTION

Краткое содержание страницы № 4

Automation and Control Solutions Honeywell International Inc. Honeywell Limited—Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 www.honeywell.com