Краткое содержание страницы № 1
User's manual
XPB50-AS
XPB50-BS(with pump
Air BubbleTwin-tub Washing Machine
Contents
Before using
Names of the parts.............the 2nd cover
Safety precautions ...............................1
Installation and adjustment ..................3
Introduction of the major functions .......5
Using process
Preparation before washing ................6
The musts in washing .........................7
Usage of the detergent .......................8
Washing sequence ............
Краткое содержание страницы № 2
Before Using Before Using Names of the parts Buzzer Water-filling entrance Outer cover of the spin tub Water inlet selector handle Inner cover of the spin tub Wash selector Spin timer Wash timer Spin tub frame Control panel Overflow filter Spin tub Quick water-filling entrance Cascade outlet Cabinet Water level adjusting lever Power cord Lint filter Valve cover Pulsator Wash tub Drain hose Base frame Meaning and description of the symbols Accessories Contents marked
Краткое содержание страницы № 3
Before Using Before Using Safety precautions Be sure to use three-phase receptacle. Be sure to pull the plug off when there's Earth the earthing terminal of the power failure, or the machine is being receptacle reliably. moved, cleaned or when it is idle. Earth If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. Do not use water hotter than 50 C .
Краткое содержание страницы № 4
Before Using Before Using Safety precautions Do not stretch hands into the working Do not decompose, repair or alter the machine. It is dangerous even if the machine by yourself. rotation is slow. Take special care of the children. Do not put any hot or heavy items Do not wash laundries with volatile ( such as the kettle with hot water ) materials (such as thinner, petrol etc.). on the washing machine. Handicapped or children withou
Краткое содержание страницы № 5
Before Using Before Using Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose(Only for XPB50-BS The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause <10cm incomplete drainage. 2.Do not tramp or pre
Краткое содержание страницы № 6
Before Using Before Using How to change the direction of the drain hoses Figure 1 indicates the ex factory installation Back position of the drain hose. Soft item Extend the drain hose from the side of spin tub Front Put soft items on the ground. Lean the machine Figure 1 down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Take the hose out of the fixing groove. (See to Figure 2). Soft item Figure 2 Embed the drain hose into the groo
Краткое содержание страницы № 7
Using process Using process Introduction of the major function The machine has good comprehensive performance, and nice appearance. In the respect of increasing the clean rate, it creates the air suction washing method. The spinning of the pulsator automatically produces large quantity of bubbles, which can strengthen the activity of the detergent remarkablly. And the rising and exploding of the bubbles produce the effects of absorption and bombardment on the dirt particles in the
Краткое содержание страницы № 8
Using process Using process Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose(Only for XPB50-AS) or put the drain hose up the suitable position( Only for XPB50-BS) Pay attention to followings before washing the laundries Confirm if Clear
Краткое содержание страницы № 9
Using process Using process The musts in washing The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this machine is 5.0 kg. The thickness ,size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonab
Краткое содержание страницы № 10
Using process Using process Usage of the detergent How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color. The whitener shall not touch the laundries directly. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, please dissolve it before using. How to use the washing powder Di
Краткое содержание страницы № 11
Using process Using process Washing sequence Water-filling selector handle Overfilling sign Wash timer Wash selector Water-filling entrance Buzzer Spin timer (To set to below 2 minute, (Soft current, (The buzzer will ring when (to set to below 1 minute, first set to 5 minute then strong current) the washing finishes) first set to 2 minute then turn it back. it can increase turn it back. it can increase the service life of the timer). the service life of the timer). OFF STRONG SI
Краткое содержание страницы № 12
Using process Using process Midway spinning 1.Put the laundries into the spin tub evenly and smoothly. 2.Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland Push The laundries Proper Proper No gland are slanting (2) Close the inner and outer cover of the spin tub. Outer cover of The spin tub Inner cover of The spin tub (3) Spin for 1-2 minutes. 3.Run the foam-removing spinning. (1) Open the outer cover of the spin tub.
Краткое содержание страницы № 13
Using process Using process Rinsing Rinse with water-filing OVERFILL 1.Put the laundries into the wash tub. Select suitable current according to the laundries. If the water flows out of the overfill holes, 2.Adjust the water level that is overfilling Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Rinse Adjust the wash timer to 5-7 minutes to do rinsing. (Repeat the midway
Краткое содержание страницы № 14
Using process Using process Spinning Selection of the spin time list 3 1. Put the laundries into the spin tub evenly and smoothly. Spin time Laundries (minutes) Bed sheet or 2. Press the gland in the tub properly. About 4~5 blanket Close the inner and outer cover of Underwear the spin tub. About 2~4 (knitwear) Swear About 1~2 3. Spin (chemical fiber) Select suitable spin time according Blending thin to the laundries, and do spinning. Within 1 minute laundries Duri
Краткое содержание страницы № 15
Using process Using process Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (
Краткое содержание страницы № 16
Using process Using process Cleaning the overflow filter Too much lint on the overflow filter will influence the normal usage of the machine. Please clean it every two months. 1 Take off the overflow filter. Elastic fixing As indicated in the figure, nip the elastic fixing claw claw and pull it to the direction of the arrow to take it off. 2. Take off the corrugation pipe. Please don't pull the bubble pipe! Dismantle the upper part of the corrugation pipe inside the Water
Краткое содержание страницы № 17
Trouble-shooting Answer to question If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub, please take them out immediately. 1.Dismantle As indicated in the figure, push the point marked with " " to pull the spin tub frame to oblique Spin tub frame upwards to dismantle it. 2.Install After install the back edge of the spin tub frame to proper position, push the four points marked with " " by force to reset it. Spin tub Please
Краткое содержание страницы № 18
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena The reason Is there power failure? The machine does not act.
Краткое содержание страницы № 19
Packing list Name Quantity Storage position User's manual One Inside the document bag Water inlet hose One Inside the accessory bag Water-filling jointer One Inside theaccessory bag Gland One Inside the accessory bag One Lint filter Inside the document bag Twin-tub washing machine One
Краткое содержание страницы № 20
Specification Air bubble twin-tub Air bubble twin-tub wash- washing machine ing machine with pump Type XPB50-AS XPB50-BS Model Rated voltage 115V~,Rated frequency 60Hz Power source High/43L Medium/36L Low/30L Water level Water quantity about 5.0 Rated washing capacity kg 5.0 Rated spinning capacity kg Wash 360 Spin 160 Wash 360 Spin 160 Rated input power W L740 W428 H890 Dimension(mm) New current + bubble Wash pattern 26
