Руководство по эксплуатации Fisher-Price J6982

Краткое содержание страницы № 1

J6982
www.fi sher-price.co.uk

Краткое содержание страницы № 2

Consumer Information Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad. WARNING To prevent serious injury or death from falls and being strangled in the restraint system:  Fall Hazard - It is dangerous to use this product on an elevated surface, since Headrest Pad child’s movement may cause the product to slide or tip over. Use only on a floor. Liner/Pad  Suffocation Hazard - Never use on a soft surface (b

Краткое содержание страницы № 3

Battery Installation Assembly IMPORTANT! Before assembly and each use, inspect this product Hint: We recommend using alkaline batteries for for damaged hardware, loose joints, missing parts or sharp edges. longer battery life. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. 1,5V x 4 Base Tubes “D” (LR20) Lift Lift Base 1  Lift both base tubes. Hubs  Loosen the screws in the battery compartment door a

Краткое содержание страницы № 4

Assembly Seatback Tube Wide Slot Narrow Slot Footrest Tube 5 3  Position the pad onto the frame assembly. The extra, padded portion  Position the footrest tube so that it curves down. should be toward the seat back tube.  Fit the ends of the footrest tube into the wide slots in the hubs.  Position the seat back tube so that it curves down.  Fit the ends of the seat back tube into the narrow slots in the hubs. Seat Back Tube Hubs 6  Fit the upper pocket on the pad around the seat

Краткое содержание страницы № 5

Assembly Headrest Pad Footrest Tube Restraint Belts 7  Fit the lower pocket on the pad around the footrest tube. Fasten the straps underneath the footrest tube to secure the lower portion of the pad. 9  Fit the restraint belts through the slots in the headrest pad. PUSH  Fit the headrest pad to the liner/pad. PUSH Toy Bar Sockets 8  Push down on the pad to be sure it is assembled properly. If the pad falls through the frame, you have not assembled it properly. Please re-read these

Краткое содержание страницы № 6

Set-up WARNING To prevent serious injury or death from falls and being strangled in the restraint system:  Fall Hazard - It is dangerous to use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use only on a floor.  Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffoca- tion in soft surfaces.  Always use the restraint system. Back View  Not recommended for children who

Краткое содержание страницы № 7

Securing Baby Starting Gliding Motion Restraint Belts Restraint Pad  Place your child in the product. Position the restraint pad between your child’s legs.  Fasten both restraint belts to the buckles on each side of the restraint pad. Make sure you hear a “click” on both sides.  Check to be sure the restraint system is securely attached by pulling it away from your child. The restraint system should remain attached. Power/Speed Switch Anchored End Anchored End Free End Free End TIGHTEN L

Краткое содержание страницы № 8

Music Room-to-Room Portability Music Switch  Choose the style of music for baby. Slide the music switch to: Soothing Playful Off  Slide the volume switch to for low volume; for high volume. Note: Low battery power may cause this product to operate erratically (no movement/no sounds) and the product may not turn off. If this should happen, remove and discard all batteries and replace with four, new “D” (LR20) alkaline batteries.  Make sure your child is properly secured in the g