Руководство по эксплуатации Honeywell Fire Lite Alarms

Краткое содержание страницы № 1

Mounting in FACP Main Board Chassis
ANN-RLY Relay Module
Installation Instructions
ANN-RLY module standoffs
The ANN-RLY relay module provides 10 program-
mable Form-C relays when used with a compatible
FACP (Fire Alarm Control Panel). This document
R1 R3 R5 (top) R7 R9
is provided as a quick reference. For more detailed
information, refer to the appropriate FACP installa-
R1 R3 R5 R7 R9
ground
tion manual.
wire
R2 R4 R6 (bottom) R8 R10
Note: I

Краткое содержание страницы № 2

Mounting in FACP Main Board Chassis Using the ANN-MBRLY bracket 1. Placing the ANN-MBRLY mounting bracket flat 3. Install the ANN-RLY Relay Module on the against the inside back wall of the FACP ANN-MBRLY mounting bracket by positioning backbox, position both bracket mounting tabs the four module mounting holes over the four above the two embossed protrusions in the standoffs on the mounting bracket. backbox and slide the tabs down into the protru- 4. Install one of the four supplied mounting s

Краткое содержание страницы № 3

Wiring ANN-RLY Module to FACP Setting DIP Switches Refer to Table 2 and Figure 3 for wiring Each ANN-BUS device requires a unique address. connections. ANN-RLY relay module DIP switch SW1 is used to set the address for the annunciator. As NN-RLY Terminals (TB1) FACP ANN-BUS Terminal A maximum of 8 devices can be connected to the T) erminal 4 (-) (- FACP ANN-BUS communication circuit. ANN- T) erminal 3 (+) (+ BUS device addresses do not need to be sequential T) erminal 2 (A) A (ANN-BUS and can b