Краткое содержание страницы № 1
How to use this file
Print Vendor
Operator’s Manuals
Instructions
Paper Size: � 11x17
� Body - 50 lbs brilliant white offset or equivalent.
� Cover - on pre-printed two tone “Swash” stock.
Press: � Body - 1 color, 2-sided
� Cover - 1 color, 1 sided
Bindery: � Saddle stitch, face trim *if too thick for saddle stitch, tape bind
Covers: � FRONT COVER is present at the beginning of the file.
� BACK COVER is the page immediately after the front cover.
� The part number for this manual (typically a
Краткое содержание страницы № 2
THIS PAGE INTENTIONALLY BLANK (FOR PLACEMENT ONLY - DO NOT PRINT)
Краткое содержание страницы № 3
OPERATOR’S MANUAL Single Stage Snowthrower 522E Models Mfg. No. Description 1695468 522E, Snowthrower 1695514 522E, Snowthrower (CE) 1742166-00 Rev 7/2008 TP 100-4961-00-SW-S
Краткое содержание страницы № 4
Краткое содержание страницы № 5
Table of Contents CONTENTS: Regular Maintenance Safety Rules & Information Lubrication ............................................................16 General ...................................................................2 Troubleshooting & Service Training ...................................................................4 Troubleshooting ....................................................17 Preparation .............................................................4 Chute Removal and Inst
Краткое содержание страницы № 6
Safety Rules & Information Operating Safety Congratulations on purchasing a superior-quality piece of lawn and garden equipment. Our products are designed and manu- factured to meet or exceed all industry standards for safety. Power equipment is only as safe as the operator. If it is mis- used, or not properly maintained, it can be dangerous! Remember, you are responsible for your safety and that of those around you. Use common sense, and think through what you are doing. If you are not s
Краткое содержание страницы № 7
Safety Rules and Information Moving Parts This equipment has many moving parts that can injure you or someone else. However, if you are standing in the operator’s position, and follow all the rules in this book, the unit is safe to operate. The auger and impeller have spinning parts that can amputate hands and feet. Do not allow anyone near the equipment while it is running! DO NOT clear the discharge chute by hand. If the chute becomes plugged, stop the engine, wait for all moving parts to
Краткое содержание страницы № 8
Safety Rules & Information This machine is capable to amputating hands and feet and throwing objects. Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment. The triangle in text signifies important cautions or warnings which must be followed. TRAINING OPERATION 1. Read, understand, and follow all instructions on the 1. Do not put hand
Краткое содержание страницы № 9
Safety Rules 21. Keep in mind the operator is responsible for acci- 8. Always follow the engine manual instructions for stor- dents occurring to other people or property. age preparations before storing the unit for both short 22. Data indicates that operators, age 60 years and and long term periods. above, are involved in a large percentage of power 9. Always follow the engine manual instructions for equipment-related injuries. These operators should proper start-up procedures when returning t
Краткое содержание страницы № 10
SAMPLE SAMPLE Product Identification Identification Numbers Product Identification Tag North American Model / Modéle / Model xxxxxxxx Models Serial / Sèrie / Serie xxxxxxxxxx Briggs & Stratton Power Products Group, L.L.C. Milwaukee, WI 53201 USA ID Tag Part No. xxxxxxx CE Models PRODUCT REFERENCE DATA xxxxxxxxxxxxxxx Serial No. xxxxxxxxxx Model Description Name/Number xxx dB xxxxxxxxxxxxxxxxxxxxxxx kg: xxx xxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxx kW: x.xx Unit MFG Number Unit
Краткое содержание страницы № 11
Product Identification SAFETY DECALS Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the opera- tor of the most important safety precautions. All warning, caution and instructional messages on your snowthrow- er should be carefully read and obeyed. If any of these decals are lost or damaged, replace them at once. They can be purchased from your local dealer. Part No. 724265MA North American - Part No. 1740400MA Part No. 1740428MA Electric Star
Краткое содержание страницы № 12
Assembling the Snowthrower TOOLS REQUIRED A � Knife E F REMOVAL FROM CARTON B C 1. Locate and remove container of oil. D 2. Locate all parts packed separately and remove from carton. C NOTE: Set the fuel stabilizer aside until adding gasoline to the fuel tank. We recommend that fuel stabilizer be added to the fuel each time that gasoline is added to the fuel tank. 3. Remove and discard the packing material from around the snowthrower. 4. Cut down all four corners of the carton and lay the pane
Краткое содержание страницы № 13
Assembling the Snowthrower A A C B B C Figure 3. Z-Hook Installation A. Auger Drive Lever B. Z-Hook Figure 4. Upper Chute Installation C. Auger Drive Cable A. Upper Chute B. T-Knob 2. Attach the auger drive cable (C, Figure 3) to the C. Lower Chute auger drive lever (A) using the Z-hook (B). 3. Remove the T-knob (B, Figure 4) and bolt on the upper chute. 4. Rotate the upper chute (A) to the operating position (past the lower chute stop) A 5. Install the bolt and tighten the T-knob (B). C Engine
Краткое содержание страницы № 14
Controls & Operation SNOWTHROWER CONTROLS A Auger Control B A. Auger Control - This control engages and disen- gages the auger. Pull the control back against handle to engage the auger, (this will pull snowthrower for- ward if auger is in contact with the ground). Release the Auger Control to stop rotation of auger. C Deflector Controls B. Chute Direction Control - The Chute Direction Control (B, Figures 6 & 7) allows the discharge chute to be rotated to throw snow in the desired direction. Snow
Краткое содержание страницы № 15
Controls & Operation ENGINE & STARTING CONTROLS NOTE: This snow thrower does NOT have a throttle for controlling operating speed of engine. The engine gover- B nor maintains operating speed for varying snow removal conditions. A. Electric Start Button - The Electric Start Button (A, Figure 8) activates an electric starter mounted to the engine, eliminating the need to pull the starter han- dle. The Electric Start Button operates on 120 Volts AC, which is provided by connection to the extension C
Краткое содержание страницы № 16
Controls & Operation GENERAL OPERATION WARNING CHECKS BEFORE EACH START-UP OPERATIONAL WARNINGS 1. Make sure all safety guards are in place and all nuts, Clearing The Discharge Chute bolts and clips are secure. To avoid serious injury, do not put your hands 2. Check the fuel supply. Fill the tank no closer than 1/4 into the auger housing or discharge chute. If the to 1/2 inch of top of tank to provide space for expan- auger stalls or chute becomes plugged, use the sion. See your engine Owner’s M
Краткое содержание страницы № 17
Controls & Operation ADDING ENGINE OIL 1. Make sure the unit is level. Use a high quality deter- gent oil classified “For Service SG, SH, SJ, SL, or higher”. A 2. Remove the oil fill cap/dipstick access panel (A, Figure 9). C 2. Remove the oil fill cap/dipstick (B) and wipe with a clean cloth. 3. Insert the oil fill cap/dipstick (B) and turn clockwise to tighten. 4. Remove the oil fill cap/dipstick (B) and check the oil. NOTE: Do not check the level of the oil while the engine B is running. 5. I
Краткое содержание страницы № 18
Controls & Operation 7. Disconnect power cord from household receptacle STARTING THE ENGINE and then from starter switch on snowthrower. Store NOTE: The snowthrower engine is designed to operate cord in a dry, convenient place. at cold temperatures. Avoid operating the snowthrower if 8. To stop engine, turn engine key to the OFF position. air temperature is 40° For warmer since engine may vapor lock and stop running after a short time. Engine Manual (Recoil) Starting Steps will be difficult to s
Краткое содержание страницы № 19
Controls & Operation Always be alert to hidden hazards that might be struck OPERATING THE SNOWTHROWER by the auger. Should a foreign object be struck by the Before operating snowthrower, review the Checks Before auger, immediately stop the engine and inspect machine Each Use under General Operation on page 12 of this for any damage. Repair damage before continuing oper- manual. ation. 1. Rotate the discharge chute to the desired direction. AFTER EACH USE 2. Pull the Auger Control back against th
Краткое содержание страницы № 20
Regular Maintenance WARNING Before beginning any repair stop the engine, remove the key, disconnect the spark plug wire, and wait for all moving parts to stop. LUBRICATION NOTE: The drive pulley end of auger shaft is supported by a sealed ball bearing and requires no lubrication. The ball bearing on other end of auger shaft is also sealed, and will not require lubrication. Lightly Oil � A few drops of oil should be placed on wheel hubs occasionally to keep wheels turning Figure 10. Lubrication
