Краткое содержание страницы № 1
PCM-3350 Series
NS Geode 586-Level PC/104
CPU Module with SVGA/LCD/
LAN Interface
User's Manual
Краткое содержание страницы № 2
Copyright notice This document is copyrighted, 2001. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of the original manufacturer. Information provided in this manual is intended to be accurate and reliable. However, the original manufacturer ass
Краткое содержание страницы № 3
Packing list Before you begin installing your card, please make sure that the following materials have been shipped: 1 PCM-3350 All-in-one single board computer CD-ROM or Disks for utility, drivers, and manuals (PDF format) 1 2.5" IDE flat cable, 44-pin to 44-pin 1 PS/2 keyboard & mouse cable 2 serial port cables 1 parallel cable 1 26-34 pin FDD cable converter 1 floppy cable, for 3.5" FDD only 1 FDD flat cable 1 VGA cable 1 LAN cable
Краткое содержание страницы № 4
Contents Chapter 1 General Information 1 1.1 Introduction....................................................................... 2 1.2 Features ............................................................................. 3 1.3 Specifications .................................................................... 4 1.3.1 Standard SBC functions .............................................. 4 1.3.2 VGA function .............................................................. 4 1.3.4 Ethernet functio
Краткое содержание страницы № 5
2.11 VGA connector (CN9) ................................................... 13 2.11.1 CRT display connector (CN9) ................................. 13 2.12 Main power (+5 V / +12 V) connector (CN11) .......... 13 2.13 PS/2 keyboard/mouse connector (CN12) ................... 14 2.14 FDD connector (CN14) ................................................. 14 2.14.1 Connecting the floppy drive ..................................... 14 2.15 CompactFlash socket (CN16) .................................
Краткое содержание страницы № 6
4.2.5 Power management setup .........................................33 4.2.6 PnP/PCI configuration .............................................. 34 4.2.7 Integrated peripherals ................................................ 35 4.2.8 Change password ...................................................... 36 4.2.9 Save & exit setup ...................................................... 37 4.2.10 Exit without saving .................................................. 37 Chapter 5 PCI Bus Ethern
Краткое содержание страницы № 7
C.6 PC/104 connector (CN6) ............................................... 70 C.7 Parallel port connector (CN7) ...................................... 70 C.8 Backlight connector (CN8)........................................... 71 C.9 VGA connector (CN9) ................................................... 71 C.10 Main power (+5 V) connector (CN11) ........................ 72 C.11 PS/2 keyboard/mouse connector (CN12) ................. 72 C.12 FDD connector (CN14) ................................
Краткое содержание страницы № 8
Figures Figure 1-1: PCM-3350 dimensions ................................................................6 Figure 2-1: Locating connectors (component side) ..................................... 9 Figure 2-2: Locating connectors (solder side) ............................................. 9 Figure 3-1: Contents of the PCM-3350 Series utility disk .............................22 Figure 3-2: BIOS VGA setup screen .............................................................. 23 Figure 4-1: BIOS setup
Краткое содержание страницы № 9
Tables Table 2-1: Connectors ...................................................................................................... 8 Table 2-2: Serial port connections (COM1, COM2) ........................................................ 11 Table 2-3: Serial port default settings ............................................................................ 12 Table B-1: PCM-3350 PC/104 connectors (CN6) ........................................................... 64 Table C-1: Ethernet connector (
Краткое содержание страницы № 10
Краткое содержание страницы № 11
1 General Information This chapter gives background information on the PCM-3350. Sections include: Introduction Features Specifications Board dimensions CHAPTER
Краткое содержание страницы № 12
1.1 Introduction The PCM-3350 is the ultimate cost-effective solution for limited space applications. It is a new NS Geode Biscuit PC with enhanced graphics function. It uses a NS CS5530A chipset which supports TFT LCDs. It offers all the functions of an AT-compatible industrial computers on a single board. The PCM-3350 comes with an embedded high-perfor- mance GX1-300 processor on-board. For maximum performance, the PCM-3350 Series also supports an SDRAM SODIMM socket that can accept up to 128
Краткое содержание страницы № 13
1.2 Features Ultra-compact size single board computer, smaller than a 3½" hard disk drive (96 mm x 90 mm) Onboard NS Geode GX1 300MHz CPU Up to 128 MB system memory, by way of SODIMM (SDRAM) Onboard VGA/18-bit LCD interface Supports CompactFlash card Built-in Enhanced IDE (AT bus) hard disk drive interface Onboard PS/2 keyboard/mouse connector Two serial ports (RS-232) Upgradeable through PC/104 module Green engine with sleep mode and low power consumption +5 V power suppl
Краткое содержание страницы № 14
1.3 Specifications 1.3.1 Standard SBC functions CPU: Embedded Low power NS Geode GX1-300 MHz processor BIOS: AWARD 256 KB Flash memory System memory: One 144-pin SODIMM socket accepts up to 128 MB SDRAM Enhanced IDE interface: Supports up to two EIDE devices. BIOS auto-detect, PIO Mode 3 or Mode 4 transfer, Ultra DMA33 mode (ATA-4) up to 33 MB/sec FDD interface: Supports up to two FDDs/ 2.5" FDD Serial ports: One serial RS-232 port, one serial RS-232/422/485 port Parallel port: One
Краткое содержание страницы № 15
CRT display mode: Non-interlaced CRT monitor resolutions up to 1024 x 768 @ 24 bpp 1.3.4 Ethernet function Chipset: Intel 82559 ER Ethernet interface: PCI 10/100 Mbps Ethernet. IEEE 802.3 U protocol compatible Connection: On-board 2 x 5 2.0 mm connector I/O address switchless setting Built-in boot ROM 1.3.5 Solid state disk Supports CompactFlash cards 1.3.6 Mechanical and environmental Dimensions: (L x W): 96 mm x 90 mm (3.77" x 3.54") Weight: .11 kg (.24 lb) Operating t
Краткое содержание страницы № 16
1.4 Board dimensions Figure 1-1: PCM-3350 dimensions 6 PCM-3350 User's Manual
Краткое содержание страницы № 17
2 Installation This chapter tells how to set up the PCM-3350 hardware. It includes instruc- tions on setting jumpers and connecting peripherals, switches and indicators. Make sure you read all the safety precautions before you begin the installation proce- dure. CHAPTER
Краткое содержание страницы № 18
2.1 Connectors The board has a number of connectors that allow you to configure your system to suit your application. The tables below shows the function of each of the board's connec- tors: Table 2-1: Connectors Label Function CN1 Ethernet connector CN2 LCD connector CN3 COM1 connector CN4 COM2 connector CN5 EIDE HDD connector CN6 PC/104 connector CN7 Parallel port connector CN8 Backlight connector CN9 VGA connector CN11 Main power (+5 V) connector CN12 PS/2 keyboard/mouse connector CN14 FDD co
Краткое содержание страницы № 19
2.2 Locating connectors Warning: Make sure you use the correct component side. Improper installation can cause serious damage to your hardware! Figure 2-1: Locating connectors (component side) Figure 2-2: Locating connectors (solder side) Chapter 2 Installation 9
Краткое содержание страницы № 20
2.3 Safety precautions Warning! Always completely disconnect the power cord from your board whenever you are working on it. Do not make connections while the power is on, because sensitive electronic components can be damaged by a sudden rush of power. Caution! Always ground yourself to remove any static charge before touching the board. Modern electronic devices are very sensitive to static electric charges. Use a grounding wrist strap at all times. Place all electronic components on a static-d
