Краткое содержание страницы № 7
FS-979 User’s Manual Introduction Chapter 1 1.1 FS-979 is the Full-size single board computer with last Intel desktop technology with PICMG form factor. Based on Intel ® 915GV and ICH6R, the board integrates a new Pentium 4 processor 775-pin socket, DDR2 memory socket, and Intel ® Graphic Media Accelerator 900 technology, LAN, AC97 audio, USB2.0 and Serial ATA with RAID function for a powerful rack-mount/wall
Краткое содержание страницы № 8
FS-979 User’s Manual Introduction 1.2 General Specification Form Factor Full-size PICMG Single Board Computer PICMG version 1.0 (Rev. 2.0), PCI version 2.0 compliant CPU Intel ® Pentium 4 processor with LGA775 socket Package type: 775 pin PLGA L2 Cache: 1MB / Front side bus: 800MHz (200MHz x 4) Intel ® Hyper-Threading Technology supported Memory 4 x 240-pin DDR2 400/533MHz SDRAM Maximum DRAM address decode space is
Краткое содержание страницы № 9
FS-979 User’s Manual Introduction Ethernet Interface Chipset Intel ® PRO/100 LAN interface with 82562EZ PHY Or Marvell ® Gigabit LAN interface with E8053 PCIE controller Type 10Base-T / 100Base-TX 82562EZ auto-switching Fast Ethernet Full duplex, IEEE802.3U compliant E8053 10Base-T / 100Base-TX/1000Base-T auto-switching Gigabit Ethernet Full duplex, IEEE802.3U compliant Connector External RJ45 connectors with LED on rear I/O panel Solid
Краткое содержание страницы № 10
FS-979 User’s Manual Introduction 1.3 Intel 82562EZ (LAN) USB2.0 Winbond W83627THF Compact Flash ISA Bridge (Super I/O) SATA ICH6R (Southbridge) ALC201A (Audio) 915G (Northbridge) CH7307B-DE (DVI) LGA775 (CPU) DDR2 (Memory) Component Placement 10
Краткое содержание страницы № 11
PICMG Backplane FS-979 User’s Manual Introduction 1.4 Intel Pentium 4 with 775 pin PLGA processor 6.4GB/s Intel GMA900 Graphics 4 x 240-pin DDR2 400/533MHz up to DVI CH7307B-DE Intel 915G SDVO 4GB GMCH 2GB/s DMI 4 x Serial ATA ports 150MB/s 4 x USB2.0 ports Intel 82562EZ LAN (VDL) AC97 Codec Marvell E8053 LAN (VDG3) PCI-Express x1 PCI 2 x Serial ports 1 x Floppy ports ISA Bridge 8-bit GPIO BIOS with Intel Hype
Краткое содержание страницы № 12
FS-979 User’s Manual (This Page is Left for Blank) 12
Краткое содержание страницы № 13
FS-979 User’s Manual Hardware Setup Chapter 2 2.1 LPT IDE1 CN_VGA VGA RJ45_1 COM1 PS2 CN_ATKB LAN_LED CN_USB1 CN_COM2 CN_DIO CN_USB0 CF (Solder Side) CN_IR S_ATA2 S_ATA4 S_ATA1 S_ATA3 DIMMA_1 CDIN DIMMA_2 DIMMB_1 CN_AUDIO DIMMB_2 NBFAN CN_DVI CPU JFRNT FDD SYSFAN CPUFAN CN_PS CN_12V CN_PWR Connector Loca
Краткое содержание страницы № 14
FS-979 User’s Manual Hardware Setup 2.2 2.2.1 Connector Function Remark CPU LGA775 CPU socket Standard DIMMA_1/2 240 –pin DDR2 SDRAM DIMM socket Standard DIMMB_1/2 240 –pin DDR2 SDRAM DIMM socket Standard IDE1 40-pin primary IDE connector Standard FDD 26-pin slim type floppy connector Standard S_ATA1/2/3/4 7-pin Serial ATA connector Standard CN_PWR 4-pin AT power supply connector Standard CN_12V 4-pi
Краткое содержание страницы № 15
FS-979 User’s Manual Hardware Setup 2.3 Jumper Function JRTC CMOS Operating/Clear Setting JDOM IDE1 Pin-20 voltage setting JCFSEL Compact Flash address setting JCSEL1 COM2 communication mode setting JCSEL2 COM2 communication mode setting JCSEL1 JCSEL2 JDOM JCFSEL JRTC Jumper Reference 15
Краткое содержание страницы № 16
FS-979 User’s Manual Hardware Setup 2.4 2.4.1 FS-979 has a LGA755 CPU socket onboard; please check following steps to install the processor properly. Intel ® Pentium 4 processor Package type: 775 pin PLGA L2 Cache: 1MB FSB: 800MHz (200MHz x 4) Manufacturing: 90nm Intel Hyper Threading Technology supported Check point 1. Lift this bar 3. Place the CPU on the top of the pins 2. Uncover this
Краткое содержание страницы № 17
FS-979 User’s Manual Hardware Setup 2.4.2 FS-979 has four 240-pin DDR2 DIMM support up to 4GB of memory capacity. The memory frequency supports 400/533MHz (100MHz x 4 or 133MHz x 4). Only Non-ECC memory is supported. Dual-Channel technology is supported while applying two same modules on one of each group. Notice: When applying 4GB of memory, due to the memory resource issue, the available memory size would be less than 4GB
Краткое содержание страницы № 18
FS-979 User’s Manual Hardware Setup 2.5 The board’s data of CMOS can be setting in BIOS. If the board refuses to boot due to inappropriate CMOS settings, here is how to proceed to clear (reset) the CMOS to its default values. Jumper: JRTC Type: Onboard 3-pin jumper JRTC Mode 1-2 Clear CMOS 2-3 Normal Operation Default setting JRTC 3 1 18 CMOS Setup
Краткое содержание страницы № 19
FS-979 User’s Manual Hardware Setup 2.6 The Intel ® ICH6R (south bridge chip) supports one enhanced IDE interface, dual channel for two ATAPI devices with ATA100. Based on this function, FS-979 has one 40-pin IDE connector with jumper selectable for pin-20 +5V supported. The jumper JDOM is two-pin type for pin-20 supplied with +5V to apply the DOM (Disk on Module). Jumper: JDOM Type: onboard 3-pin header JDOM Mode ON
Краткое содержание страницы № 20
FS-979 User’s Manual Hardware Setup 2.7 FS-979 has four Serial ATA interfaces with RAID function, the transfer rate of the Serial ATA can be up to 150MB/s. Please go to http://www.serialata.org/ for more about Serial ATA technology information. Based on Intel ® ICH6R, it supports Intel ® Matrix Storage Technology with combination of RAID 0 and RAID 1 modes. The main features of RAID on ICH6R are listed below: 1. Supports fo
