Краткое содержание страницы № 5
Quick Start To attach the FE monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. If necessary, install the display card into your system. For more information, refer to the display card manual. 3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws. For the Mac: Connect the MultiSync FE Macintosh cable adapter (not included) to the monitor connector on
Краткое содержание страницы № 6
Quick Start –continued Figure C.1 Power Button Figure D.1 4 1-6
Краткое содержание страницы № 7
Controls ™ OSM (On-Screen Manager) control buttons on the front of the monitor function as follows: Main Menu Sub-Menu EXIT Exits the OSM menu. Exits to the OSM controls main menu. CONTROL Moves the highlighted Moves the highlighted area / area left/right to select left/right to select one of the one of the sub-menus. controls. CONTROL Has no function. Moves the bar in the – or + –/+ direction to decrease or increase the adjustment. SELECT/ Enters sub-menu. Has no function. SBMODE RESET Rese
Краткое содержание страницы № 8
Controls –continued ® Color Control/AccuColor Control System Color presets selects the desired color setting. The bar is replaced by the color setting choice. Each color setting is adjusted at the factory to the stated Kelvin. If a setting is adjusted, the name of the setting will change from Kelvin to Custom except sRGB mode. Red, Green, Blue: AccuColor Control System decreases or increases the monitor's red, green or blue color guns depending upon which is selected. The change in color will
Краткое содержание страницы № 9
Controls –continued • Use the CONVERGENCE (HOR.) control to adjust the alignment of the lines in the up/ down direction. • Use the CONVERGENCE (VER.) control to adjust the alignment of the lines in the left/right direction. Tools 2 Language: OSM controls menus are available in 6 languages. OSM Position: You can choose where you would like the OSM controls menu to appear on your screen. Selecting OSM Position allows you to manually adjust the OSM controls menu position from among Center, Top left
Краткое содержание страницы № 10
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING ® THE MULTISYNC FE COLOR MONITOR: • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing to qualified service personnel. • Do not spill any liquids into the cabinet or use your monitor near water. • Do not insert objects of any kind into the cabine
Краткое содержание страницы № 11
Recommended Use –continued CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. • Position your monitor no closer than 16 inches and no further away than 24 inches from your eyes. The optimal distance is 20 inches. • Rest your eyes periodi
Краткое содержание страницы № 12
Specifications ® SB Monitor MultiSync FE791 Notes Specifications Monitor Picture Tube Diagonal: 17 inch 90° deflection, 0.25 mm grille pitch, Viewable Image Size: 16 inch medium short persistence phosphor, Radius: 50,000 mm aperture grille CRT, multi-layered, anti-static screen coating, dark-tint screen ® and OptiClear screen. Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync: Separate sync. TTL Level Horizontal sync. Positive/Negative Vertical sync. Positive/Negative Composite sync. (Positive/Ne
Краткое содержание страницы № 13
Specifications –continued ® SB Monitor MultiSync FE991 Notes Specifications Monitor Picture Tube Diagonal: 19 inch 90° deflection, 0.25/0.27 mm grille pitch, Viewable Image Size: 18 inch medium short persistence phosphor, Radius: 50,000 mm aperture grille CRT, multi-layered, anti-static screen coating, dark-tint screen ® and OptiClear screen. Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync: Separate sync. TTL Level Horizontal sync. Positive/Negative Vertical sync. Positive/Negative Composite sy
Краткое содержание страницы № 14
Features TM ® SuperBright Diamondtron CRT : This patented flat aperture grille CRT delivers an exceptional viewing experience with unprecedented brightness and contrast and a virtually flat image that reduces distortion and glare so that what you see on-screen is what you get on your printed output. The state-of-the-art Mitsubishi TM PX-DBF electron gun and tight 0.25mm grille pitch delivers precise focus for crisp, clear text and images. TM SuperBright Mode : With the simple touch of a button,
Краткое содержание страницы № 15
Features –continued Reduced Magnetic Field™ Technology: Reduces magnetic and alternating electric field emissions and static electricity, addressing ergonomic concerns regarding potential risks from extended computer monitor use. Multiple Frequency Technology: Automatically adjusts monitor to the display card’s scanning frequency, thus displaying the resolution required. FullScan™ Capability: Allows you to use the entire screen area in most resolutions, significantly expanding image size. Copyri
Краткое содержание страницы № 16
Troubleshooting No picture • Display card should be completely seated in its slot. • Power Button and computer power switch should be in the ON position. • Signal cable should be completely connected to display card/computer. • Check connector for bent or pushed-in pins. Image is scrolling or unstable • Signal cable should be completely attached to the computer. • Check pin assignments and signal timings of the monitor and your display card with respect to recommended timings and pin assignments
Краткое содержание страницы № 17
References • BBS (978) 742-8706 NEC-Mitsubishi Electronics Display of America Remote Bulletin Board System is an electronic service accessible with your system and a modem. Communica- tion parameters are: 300/1200/2400/9600/14.4k/28.8k/33.6k bps, no parity, 8-data bits, 1 stop bit • Customer Service/ Technical Support (800) 632-4662 Fax (978) 742-7049 • Electronic Channels: Internet e-mail: tech-support@necmitsubishi.com Internet ftp site: ftp.necmitsubishi.com World Wide Web: http://www.necmits
Краткое содержание страницы № 18
Limited Warranty NEC-Mitsubishi Electronics Display of America, Inc. (hereinafter “NMD-A”) warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at NMD-A’s sole option) any part of the enclosed unit which proves defective for a period of three (3) years from the date of first consumer purchase. Spare parts are warranted for ninety (90) days. Replacement parts or unit may be new or refurbished and wil
Краткое содержание страницы № 19
TCO’95 ® MultiSync FE Black Model Congratulations! You have just purchased a TCO’95 approved and labeled product! Your choice has provided you with a product devel- oped for professional use. Your purchase has also contributed to reducing the burden on the environment and also, to the further development of environmentally adapted electronics products. Why do we have environmentally labelled computers? In many countries, environmental labelling has become an established method for encourag- ing
Краткое содержание страницы № 20
TCO’95 –continued toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bio-accumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. TCO’95 demand requires that plastic components weighing more than 25 grams must not contain organically bound chlorine and bromine. Lead** Lead can be found in picture tubes, display screens, sol
Краткое содержание страницы № 1
User's Manual
1. A Version
TM TM
®
SB SB
MultiSync FE791 /FE991
1-1
Краткое содержание страницы № 2
Index Warning.................................................................................................. 1 Contents ............................................................................................... 2 Quick Start ...........................................................................................3 Controls ................................................................................................ 5 Recommended Use ..................................................
Краткое содержание страницы № 3
WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK • DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS IN
Краткое содержание страницы № 4
Contents ® Your new NEC MultiSync FE monitor box* should contain the following: • MultiSync FE Monitor with tilt/swivel base • Power Cord • Captive Signal Cable • User’s Manual Captive Signal Cable ® TM TM SB SB Power Cord MultiSync FE791 /FE991 User’s Manual * Remember to save your original box and packing material to transport or ship the monitor. 2 1-4
