Havis-Shields Flip Down Rear Step Option KK-ST-FLIP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALL INSTRUCTIONS KK-ST-FLIP
FLIP DOWN REAR STEP OPTION
(For Rear Permanent Mount Step order with KK-x-ST-RP)

TOOLS REQUIRED:
Ratcheting wrench Power drill
Standard socket set Drill bit set
Open-end wrench set

HARDWARE:
QTY DESCRIPTION PART #
10 ½” x 1 ½” Hex head bolt GSM33050
4 ½” x 3 ½” Hex head bolt GSM33055
32 ½” Flat washer GSM31012
10 ½” Lock washer GSM31030
4 ½” Nylock nut GSM30020
10 ½” Hex nut GSM30011
2 ¼” Stainless nylock nut GSM30046

SUB ASSEMBLY:
1. Co

ملخص المحتوى في الصفحة رقم 2

• Start with the Frame Brackets and then check for square again. • Proceed to tighten Support Channels to Frame Brackets then Frame Brackets to Step Plate. Note: There are numerous holes in the step brackets for other Vehicle applications. IF FLIP PORTION OF STEP WAS ODERED SEPARATELY USE THE FOLLOWING: INSTALLATION: 1. MOUNT FLIP DOWN STEP: • Remove ½” hardware located on frame brackets of existing step. • Install (4) flip down step adapter plates reusing ½” hardware removed f

ملخص المحتوى في الصفحة رقم 3

KK-ST-FLIP-INST-6-07