ملخص المحتوى في الصفحة رقم 1
Hyperion EOS0610iDUOII Charger - User’s Manual
v1.2 Firmware version. Visit http://media.hyperion.hk/dn/eos for the newest manuals, firmware, and software
Specifications & Features:
• 180W Per Port for 360 Watts Max CHARGE Output
• 0.1A to 10.0A max CHARGE Current in 0.1A steps
• 50W Per Port DISCHARGE with 10A Max Current
• STORE MODE allows fast and simple
charge/discharge to 60% capacity for proper
storage of Lithium Batteries = longer battery life.
• Charges/Discharges 1 to 6 ce
ملخص المحتوى في الصفحة رقم 2
GENERAL SETUP and NOTES The EOS0610iDUOII comes with male 4mm Bullet connectors (aka ‘banana plugs’) attached to the power INPUT cables. These cables are appropriate for attaching directly to most high-quality AC-DC power supply units, such as the BK Precision (USA) model 1692(15V, 40A, 600W). Also included are large Terminal Clips with matching 4mm female bullet connectors, for attaching directly to 12V~24V lead-acid batteries. Output side 4mm Male Connector + Cable assemblie
ملخص المحتوى في الصفحة رقم 3
Press DOWN to SAFETY TIMER - Adjustable between 20 and 300 minutes. An alarm will sound during charging after selected time interval during charging has elapsed. Set the time for about 30% longer than it should take your pack to charge. Keep in mind that a badly balanced pack may take longer than normal to charge, so don’t set this too tight. A Lipo pack at 1C rate might take as much as 120 minutes to charge, so timer of about 160~180 minutes may be appropriate. Note that while other sa
ملخص المحتوى في الصفحة رقم 4
---- BALANCER MODE (Lithium types only) Try it out with a LITHIUM battery pack which has the proper Balance Connector attached. Attach the charger to an appropriate DC power supply, and connect your battery pack’s main and balance connectors to charger as previously described. Press the MODE button until you reach the BALANCER Mode screen. *Press DOWN once to reach the SELECT VOLTAGE screen. This screen simply shows you a very accurate voltage for each cell in the pack, in turn. You
ملخص المحتوى في الصفحة رقم 5
A123 CHG CURRENT (A) setting: The EOS 0610iDUOII does NOT limit max charge rate for A123-type cells or other-brand LiFePO4 based on capacity. For A123-Brand cylindrical Phosphate-based cells it is our position that 4C~4.3C rate is the target MAX, as of this writing. Therefore, 9.2A~10A max for the A123 2300mAh cells, and 4.4A~5.0A for the newer 1100mAh size. Consult battery maker documentation for other brands or later A123 types. NiCd and NiMH: Set BATT TYPE from MEMORY MODE screen as
ملخص المحتوى في الصفحة رقم 6
NET/DUO FAQ * The discharge function is supposed to be 10A Max, but when I discharged my 4S pack I got less current. Why? Both charge and discharge functions are limited by both watts and amperage; whichever comes first. Charge: 180W and 10A maxes per port Discharge: 50W and 10A maxes per port - If you are discharging a pack which starts at 10V, for example, the initial max current(A) would be: 50W/10V=5A (note that as the battery voltage drops during discharge, c
