Bedienungsanleitung A & T International E5812B

Inhaltszusammenfassung zur Seite Nr. 1

Quick start guide
E5812B/E5813B/E5814B/
E1812B/E1813B/E1814B
5.8 GHz cordless telephone/
answering system with
caller ID/call waiting

Inhaltszusammenfassung zur Seite Nr. 2

Battery installation & charging After installing the battery, you may be able to make or receive short calls. For best performance, place the handset in the telephone base or charger to charge for 16 hours before use. You can keep the battery charged by returning the handset to the telephone base or charger after use. When the battery is fully depleted, a recharge takes about 12 hours. The average talk time on a fully charged battery is about five hours, and the standby time is approximate

Inhaltszusammenfassung zur Seite Nr. 3

Telephone base installation 1. Plug the small end of the larger 2. Plug the end of the telephone line power adapter into the power jack at cord into the telephone jack at the the bottom of the telephone base. bot tom of the telephone base. 3. Route cords through slots. DSL filter (Optional for DSL users, see number four in the note section, below.) 4. Plug the large end of the larger power adapter into an electrical outlet Telephone line cord not controlled by a wall switch. 5. Plug th

Inhaltszusammenfassung zur Seite Nr. 4

Quick reference guide Cordless handset DIR /VOLUME+ CID/-VOLUME While in a menu, press to scoll up. While in a menu, press to scoll When in idle mode, press to dis- down. When in idle mode, press play directory entries. While enter- to display call summary entries. ing names, press to advance the While entering names or num- cursor. During a call, press DIR to bers, press to move the cursor to increase listening volume. the left. During a call, press CID to decrease listening volume. OFF

Inhaltszusammenfassung zur Seite Nr. 5

Quick reference guide Telephone base CHARGE/IN USE • Flashes when one of the handsets is in use. • Flashes when the answer- ing system is answering an HANDSET LOCATOR incoming call. • Flashes quickly while an Press to make the handsets incoming call is ringing. beep when there is no hand- • On steady when the hand- set on the telephone base. set is properly positioned to charge in the telephone base. SETUP ANNC. Press to review or change Press to review or record answering system opti

Inhaltszusammenfassung zur Seite Nr. 6

www.telephones.att.com © 2007 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Knowledge Ventures, licensed to Advanced American Telephones. Printed in China. Issue 5 AT&T 06/07. 96-006296-030-100