Inhaltszusammenfassung zur Seite Nr. 1
43-3857.book Page 1 Wednesday, February 18, 2004 12:40 PM
2.4GHz Cordless Phone
with Caller ID and Digital Answering Machine
43-3857
Ten Number Memory Dialing—stores ten
numbers in memory for easy dialing. See “Memory
Dialing” on page 13.
Long Battery Life—the supplied battery pack
(when fully charged) provides about seven hours
of talk time or 14 days of standby time.
20 Channels—automatically selects a clear
channel when you make or answer a call. You can
also manually change channels
Inhaltszusammenfassung zur Seite Nr. 2
43-3857.book Page 2 Wednesday, February 18, 2004 12:40 PM CONTENTS Introduction .......................................... 3 When the Telephone Rings ..................... 21 Viewing the Caller ID Message List ......... 22 Important Information .......................... 3 Deleting Information from the Caller ID FCC Statement .................................... 3 List ........................................................ 22 Surge Protection ........................................ 5 Dele
Inhaltszusammenfassung zur Seite Nr. 3
43-3857.book Page 3 Wednesday, February 18, 2004 12:40 PM WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. CAUTION: TO REDUCE THE RISK OF ELECTRIC .CAUTION. SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER RISK OF ELECTRIC SHOCK ! SERVICING TO QUALIFIED PERSONNEL. DO NOT OPEN The lightning symbol is intended to alert you to The exclamation symbol is intended to the presence of uninsulated dangerous voltage i
Inhaltszusammenfassung zur Seite Nr. 4
FCC Statement 43-3857.book Page 4 Wednesday, February 18, 2004 12:40 PM Your phone is not intended to be used with party- line systems. Connection to party line service is Ô NOTE Ô subject to state tariffs. Contact the state public utility You must not connect your commission, public service commission, or telephone to: corporation commission for information. Ô coin-operated systems We have designed your phone to conform to federal most electronic key regulations, and you can con
Inhaltszusammenfassung zur Seite Nr. 5
43-3857.book Page 5 Wednesday, February 18, 2004 12:40 PM SURGE PROTECTION Your telephone has built-in protection circuits to reduce the risk of damage from surges in telephone line and power line current. These protection circuits meet or exceed the FCC requirements. However, lightning striking the telephone or power lines can damage your telephone. Lightning damage is not common. Nevertheless, if you live in an area that has severe electrical storms, we suggest that you unplug your p
Inhaltszusammenfassung zur Seite Nr. 6
Important Caller ID Information 43-3857.book Page 6 Wednesday, February 18, 2004 12:40 PM IMPORTANT CALLER ID INFORMATION To use Caller ID and Caller ID on Call Waiting, you must be in an area where those services are available and you must subscribe to those services through your local phone company. Where Caller ID is offered, one or more options are generally available: caller’s number only caller’s name only caller’s name and number If you subscribe to Call Waiting ID and Call
Inhaltszusammenfassung zur Seite Nr. 7
43-3857.book Page 7 Wednesday, February 18, 2004 12:40 PM Your telephone connects directly to a modular CAUTION telephone line jack. If your telephone wiring does not have a modular jack, you can update the wiring You must use a ! Class two power yourself using jacks and adapters (available at your source that supplies local RadioShack store or online at 9V DC and delivers at least RadioShack.com), or have the telephone company 350 mA. Its center tip must update the wiring for you
Inhaltszusammenfassung zur Seite Nr. 8
Installation 43-3857.book Page 8 Wednesday, February 18, 2004 12:40 PM 2. Lift the battery pack out of the compartment. 3. Plug the battery pack’s IMPORTANT connector into the socket ! ! in the compartment. The Be sure the battery pack is connector fits only one properly connected before you try to charge it. The way. CHARGE/IN USE indicator lights when the handset is 4. Put the battery pack in on the base even if the the compartment. battery pack is not connected properly. 5. R
Inhaltszusammenfassung zur Seite Nr. 9
43-3857.book Page 9 Wednesday, February 18, 2004 12:40 PM SETTING MENU OPTIONS There are five setup options: AutoTalk, CIDCW (Caller ID on Call Waiting), Area Code, Dial Mode and Language. AutoTalk allows you to answer the phone without pressing the TALK/FLASH button. If the phone rings when AutoTalk is on, simply remove the handset from the base and the phone automatically answers the call. If the phone rings when AutoTalk is off, you must press TALK/FLASH to answer the call. Changin
Inhaltszusammenfassung zur Seite Nr. 10
Installation 43-3857.book Page 10 Wednesday, February 18, 2004 12:40 PM 4. Use the number keys (0 to 9) or CH/DELETE to Ô NOTES Ô enter the three-digit area code. Ô Entering your Area Code 5. Press REMOTE/SELECT. A confirmation tone When the area code has sounds and the displayed area code is entered. already been stored in memory, the stored area 6. Press END or return the handset to the base code will be displayed. To unit to complete the setting. The handset change it, use the CH/
Inhaltszusammenfassung zur Seite Nr. 11
43-3857.book Page 11 Wednesday, February 18, 2004 12:40 PM OPERATION MAKING AND RECEIVING CALLS Even when you turn off the base’s ringer, you can still make or receive calls using this phone. Telephones on the same line and the handset (if its ringer is not turned off) still ring when there is an incoming call. Action Handset On Base Handset Off Base Pick up the handset Press TALK/FLASH, Ô NOTE Ô (Auto Talk: On),Ô or any number, /TONE/ To pick up the handset < or #/> (Auto Talk: Ref
Inhaltszusammenfassung zur Seite Nr. 12
Operation 43-3857.book Page 12 Wednesday, February 18, 2004 12:40 PM ADJUSTING THE HANDSET RINGER AND EARPIECE VOLUME Handset Ringer Tone and Volume Press VOL or VOL repeatedly in standby mode to select one of five ringer tones and volume combinations. Earpiece Volume Press VOL or VOL repeatedly during a call to change the earpiece volume of the handset. This setting will remain in effect after the telephone call Ô NOTES Ô has ended.Ô Earpiece Volume When you press VOL in Tempor
Inhaltszusammenfassung zur Seite Nr. 13
43-3857.book Page 13 Wednesday, February 18, 2004 12:40 PM TRAVELING OUT-OF-RANGE During a call, as you begin to move your handset too far from your base unit, noise increases. If you pass the range limits of the base unit, your call will terminate within one minute. SELECTING A DIFFERENT CHANNEL If you encounter interference while using your phone, you can manually change the phone’s channel for clear operation. This function works only when the phone is in use. Press CH/DELETE. Scanni
Inhaltszusammenfassung zur Seite Nr. 14
Memory Dialing 43-3857.book Page 14 Wednesday, February 18, 2004 12:40 PM 1. Press MEM. Select Memory is displayed. 2. Press VOL or VOL, or enter a number (0- 9) to select the memory location where you would like to store the number. 3. Press MEM or REMOTE/SELECT. 4. Press MEM or REMOTE/SELECT. A cursor flashes indicating that the display is ready for the name to be entered. If Edit MemoryXX appears, the selected memory location is already stored. Then you must either edit the entry in
Inhaltszusammenfassung zur Seite Nr. 15
43-3857.book Page 15 Wednesday, February 18, 2004 12:40 PM Use PAUSE/REDIAL to enter a pause in the dialing sequence. The display shows a P.Ô Ô NOTE Ô Each pause counts as one digit and The pause feature is useful represents a two second delay of time for long distance calling, between the digits as they are sent. credit card dialing, or sequences that require a Use CH/DELETE to delete digits as needed. pause between digits. 8. Press MEM or REMOTE/SELECT. You will hear a confirm
Inhaltszusammenfassung zur Seite Nr. 16
Memory Dialing 43-3857.book Page 16 Wednesday, February 18, 2004 12:40 PM If You Make a Mistake while Entering a Name Use /TONE/< or #/> to move the cursor to the incorrect character, press CH/DELETE to erase up to the wrong entry. Then enter the correct character. To delete all characters, press and hold CH/DELETE. For example, to enter John; Ô Ô NOTE Ô 1. Pick up the handset. Press MEM. If the next character uses the same number key, you 2. Enter a number or press VOL or VOL to m
Inhaltszusammenfassung zur Seite Nr. 17
43-3857.book Page 17 Wednesday, February 18, 2004 12:40 PM 2. Press VOL or VOL, or enter a number (0- 9) to select the memory location you would like to dial. Ô Ô NOTES Ô 3. Press TALK/FLASH. Talk and the volume If you press REMOTE/ setting appear on the display. Then the SELECT before TALK/ displayed number is dialed. FLASH, you can confirm the name and the Memory Dialing from Talk Mode number stored in the 1. Press TALK/FLASH. Talk and the volume selected memory setting appears
Inhaltszusammenfassung zur Seite Nr. 18
Memory Dialing 43-3857.book Page 18 Wednesday, February 18, 2004 12:40 PM The screen appears with the memory location number that you have selected in the display. 3. Press MEM or REMOTE/SELECT. 4. Press VOL or VOL to select Edit MemoryXX. Then press MEM or REMOTE/ SELECT. Store Name is displayed. The cursor flashes indicating that the display is ready for the name to be edited. When a name has not been stored, the cursor appears at the beginning of the second line. 5. Use the number
Inhaltszusammenfassung zur Seite Nr. 19
43-3857.book Page 19 Wednesday, February 18, 2004 12:40 PM ERASING A STORED NAME AND PHONE NUMBER 1. Press MEM. Select Memory is displayed. 2. Press VOL or VOL, or enter a number (0- 9) to select the memory location you would like to erase. 3. Press MEM or REMOTE/SELECT. The screen appears with the memory location number that you have selected in the display. 4. Press MEM or REMOTE/SELECT. 5. Press VOL to move the pointer down to Delete MemoryXX. 6. Press MEM or REMOTE/SELECT. The con
Inhaltszusammenfassung zur Seite Nr. 20
Memory Dialing 43-3857.book Page 20 Wednesday, February 18, 2004 12:40 PM ONE-TOUCH SPEED DIAL You can store your most frequently dialed number in the One-touch Speed Dial location. The One- touch Speed Dial allows you to dial a number with one key press. (There is no need to press TALK/ FLASH. The phone will automatically dial the number stored.) STORING AND EDITING THE SPEED Ô NOTES Ô DIAL Storing and Editing the 1. When the phone is in the standby mode, press Speed Dial and hold SPE
