Inhaltszusammenfassung zur Seite Nr. 1
LCD TELEVISION
Operating Guide for 26HDL52
IMPORTANT SAFETY INSTRUCTIONS ................................................................................ 1- 6
ACCESSORIES…………………..………………………………………………………………………7
HOW TO SETUP YOUR NEW HITACHI LCD TELEVISION………………............................8- 26
HOW TO USE REMOTE CONTROLLER TO CONTROL YOUR LCD TV............................ 27-30
ON-SCREEN DISPLAY...................................................
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INSTRUCTIONS SAFETY POINTS YOU SHOULD KNOW ABOUT YOUR HITACHI LCD TELEVISION Our reputation has been built on the quality, performance, and ease of service of HITACHI LCD Televisions. Safety is also foremost in our minds in the design of these units. To help you operate these products properly, this section illustrates safety tips which will be of benefit to you. Please read it carefully and apply the knowledge you obtain from it to the proper operation of your HITACHI
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 15. Televisions are designed to comply with the recommended Follow all warnings and instructions marked on this television. safety standards for tilt and stability. 1. Read these instructions. Do not apply excessive pulling force to the front, or top, of the 2. Keep these instructions. cabinet which could cause the product to overturn resulting in 3. Heed all warnings. product damage and/or pers
Inhaltszusammenfassung zur Seite Nr. 4
SAFETY INSTRUCTIONS This LCD TV has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Before using this product, please read and understand the Safety Instructions thoroughly to ensure correct usage, and follow all the instructions. About the Symbols Various symbols are used in this manual, the user’s manual and on the product itself
Inhaltszusammenfassung zur Seite Nr. 5
SAFETY INSTRUCTIONS(continued) Be cautious of the power cord connection. Incorrect connection of the power cord could result in fire or electrical shock. • Do not touch the power cord with a wet hand. • Check that the connecting portion of the power cord is clean (with no dust), before using. Use a soft and dry cloth to clean the power plug. • Insert the power plug into a power outlet firmly. Avoid using a loose, unsound outlet or contact failure. • Do not cut off the fitted p
Inhaltszusammenfassung zur Seite Nr. 6
SAFETY INSTRUCTIONS(continued) Be careful in moving the LCD Television. Neglect could result in an injury or damage. • Do not move the LCD TV during use. Before moving, disconnect the power plug and all external connections. • You are advised to move the LCD TV with two persons. • Avoid any impact or shock to the LCD TV; particularly take care of glass screen. Do not put anything on top of the LCD Television. Placing anything on the LCD TV could result in loss of balanc
Inhaltszusammenfassung zur Seite Nr. 7
SAFETY INSTRUCTIONS(continued) • Prevention of an obstacle to Radio receivers This LCD TV has been designed pursuant to the international EMI standards. This is to prevent a problem to Radio receivers. - Keep the LCD TV away from Radio. - Adjust Radio antennas in order for the monitor not to receive interference. - The antenna cable of Radio should be kept away from the LCD TV. - Use a coaxial cable for antenna. You can check if this LCD TV influences Radio receivers by turning off
Inhaltszusammenfassung zur Seite Nr. 8
ACCESSORIES Check to make sure you have the following accessories before disposing of the packing material. REMOTE POWER CORD D-SUB MINI 15-PIN AUDIO/VIDEO S-VIDEO CABLE CONTROL CABLE CABLE 2. 3. 4. 5. BATTERIES USER’S GUIDE EASY GRAPHIC WARRANTY CARD GUIDE 1. 6. 7. 8. 9. CAUTION: Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the fro
Inhaltszusammenfassung zur Seite Nr. 9
HOW TO SETUP YOUR NEW HITACHI LCD TELEVISION To take measures to prevent the LCD Television from tipping over and prevent possible injury it is important to mount the unit in a stable place. *Keep the LCD Television four inches away from the wall except those hung to the wall mount bracket. NOTES: 1. Do not block the ventilation holes of the LCD Television. Blocking the ventilation holes might cause fire or defect. 2. If you purchased the wall mount bracket option, please ask
Inhaltszusammenfassung zur Seite Nr. 10
HOW TO SETUP YOUR NEW HITACHI LCD TELEVISION VIEWING The major benefit of the HITACHI LCD Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing. The best picture is seen by sitting directly in front of the TV and about 5 to 11 feet from the screen. During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or t
Inhaltszusammenfassung zur Seite Nr. 11
HOOKUP CABLES Most video/audio connections between components can be made with shielded video and audio cables that have phono connectors. For best performance, video cables should use 75-Ohm coaxial shielded wire. Cables can be purchased from most stores that sell audio/video products. Below are illustrations and names of common connectors. Before purchasing any cables, be sure of the output and input connector types required by the various components and the length of each cable.
Inhaltszusammenfassung zur Seite Nr. 12
ANTENNA CONNECTIONS TO REAR PANEL JACKS VHF (75-Ohm) antenna/CATV (Cable TV) When using a 75-Ohm coaxial cable system, connect the outdoor antenna or CATV coaxial cable to the NTSC TUNER terminal (75-Ohm)and/or DTV TUNER terminal (75-Ohm). 11 English
Inhaltszusammenfassung zur Seite Nr. 13
FRONT PANEL CONTROLS FRONT VIEW 26” LCD TV ① POWER light indicator To turn the LCD TV ON, press the main power button located on the BACK left side of the TV. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The LCD TV is now ready for remote on/off operation. Indicating Lamp Power Status Operating Off Off When the MAIN POWER is set OFF. Lights Red Off (Stand-by) When the MAIN POWER is set ON and the Front Key or Remote
Inhaltszusammenfassung zur Seite Nr. 14
TOP PANEL CONTROLS TOP VIEW 26” LCD TV ③ POWER button This power button is for power on the LCD television or change to standby mode. ④ CHANNEL selector Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as the cursor down (▼) and up (▲) buttons when in MENU mode. ⑤ VOLUME level Press these buttons to adjust the sound level. The volume level will be displayed on the TV screen. These buttons
Inhaltszusammenfassung zur Seite Nr. 15
REAR PANEL MAIN POWER SWITCH & AC INPUT 26” LCD TV ①-1 Main power button POWER CORD ① AC IN input ① AC IN input This TV is designed to operate on 120VOLTS 60Hz AC current. Insert the TV power cord into a 120VOLTS 60Hz outlet. ①-1 Main power button: This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN POWER” to” ON” condition (lights red) for stand-by mod
Inhaltszusammenfassung zur Seite Nr. 16
SIDE PANEL JACKS 26” LCD TV ② S-VIDEO ( VIDEO 4) Provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability. ③ VIDEO (VIDEO 4) By using the VIDEO button of the remote control, you can select VIDEO 4.Use the video inputs to connect external devices, such as camcorders. ④ L / MONO / R (VIDEO 4) Connect audio of external devices.(if you have mono sound, insert the audio cable into th
Inhaltszusammenfassung zur Seite Nr. 17
REAR PANEL JACKS 26” LCD TV ⑥ DVI –INPUT Stand for Digital Visual Interface. Use for high quality PC display. ⑦ S-VIDEO (VIDEO 3) Provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability. ⑧ VIDEO (VIDEO 3) By using the VIDEO button of the remote control, you can select VIDEO3. Use the video inputs to connect external devices, such as VCRs, camc
Inhaltszusammenfassung zur Seite Nr. 18
⑫ SUBWOOFER Output Connect this SUB WOOFER OUT output to the external audio component input. ⑬ AUDIO Output These jacks provide fixed audio signal which are used for recording. ⑭ MONITOR Output (S VIDEO) This jack provides S video signal which are used for recording. (Please refer to monitor output table as below) ⑮ MONITOR Output (VIDEO) This jack provides video and audio signals which are used for recording. (Please refer to monitor output table as below)
Inhaltszusammenfassung zur Seite Nr. 19
CONNECTING EXTERNAL SOURCES The exact arrangement you use to connect the PC, VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your LCD TV is dependent on the model and features of each component. Check the owner’s manual of each component for the location of video and audio inputs and outputs. The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your particular assortment of components and features. For best
Inhaltszusammenfassung zur Seite Nr. 20
CONNECTING EXTERNAL SOURCES CONNECTING HDTV SOURCES HDTV input sources, such as a digital cable box, digital satellite receiver, or digital terrestrial receiver box, can be connected as desired, using the appropriate cable system. 1. Connect the HDTV source device using the appropriate cable pair, in the following order of preference: Component cable and audio cable (Video 1 or Video 2) 2. Connect all power sources before activating the LCD TV. 3. Turn on the LCD TV. 4. Press the butt
