Inhaltszusammenfassung zur Seite Nr. 1
OPERATOR’S
MANUAL
Turf Tiger
Models: STT52V-27CH
STT61V-27CH
STT61V-27KA
STT61V-29DFI
STT61V-29DFI-LE
STT61V-35BVAC
STT-29DFI
STT-35BVAC
Congratulations on owning a Scag mower! This manual contains the operating
instructions and safety information for your Scag mower. Reading this manual
can provide you with assistance in maintenance and adjustment procedures to
keep your mower performing to maximum effi ciency. The specifi c models that
this book covers are listed on the inside cover.
Inhaltszusammenfassung zur Seite Nr. 2
WARNING FAILURE TO FOLLOW SAFE OPERATING PRACTICES MAY RESULT IN SERIOUS INJURY OR DEATH. • Read this manual completely as well as other manuals that came with your mower. • DO NOT operate on steep slopes. To check a slope, attempt to back up it (with the cutter deck down). If the machine can back up the slope without the wheels slipping, reduce speed and use extreme caution. • Under no circumstances should the machine be operated on slopes greater than 15 degrees. ALWAYS FOLLOW OSHA APP
Inhaltszusammenfassung zur Seite Nr. 3
R Table of Contents Table of Contents SECTION 1 - GENERAL INFORMATION ...................................................................................1 1.1 INTRODUCTION ...........................................................................................................................................1 1.2 DIRECTION REFERENCE ...........................................................................................................................1 1.3 SERVICING THE ENGINE AND DRIVE TRA
Inhaltszusammenfassung zur Seite Nr. 4
R Table of Contents SECTION 5 - TROUBLESHOOTING CUTTING CONDITIONS ...............................................21 SECTION 6 - ADJUSTMENTS .................................................................................................24 6.1 PARKING BRAKE ADJUSTMENT ............................................................................................................24 6.2 TRAVEL ADJUSTMENTS ................................................................................................
Inhaltszusammenfassung zur Seite Nr. 5
R Table of Contents BDP-16A HYDRAULIC PUMP ASSEMBLY .....................................................................................................72 BDP-16A HYDRAULIC PUMP ASSEMBLY WITH COOLING FAN(29DFI & 35BVAC)) .................................74 BELECTRICAL SYSTEM (KOHLER & BRIGGS & STRATTON) ....................................................................76 ELECTRICAL SYSTEM - 27HP KAWASAKI .........................................................................................
Inhaltszusammenfassung zur Seite Nr. 6
R Table of Contents IV
Inhaltszusammenfassung zur Seite Nr. 7
R Section 1 GENERAL INFORMATION USE ONLY SCAG APPROvED ATTACHMENTS AND 1.1 INTRODUCTION ACCESSORIES. Your mower was built to the highest standards in the Attachments and accessories manufactured by companies industry. However, the prolonged life and maximum other than Scag Power Equipment are not approved for efficiency of your mower depends on you following the use on this machine. See Section 8-1. operating, maintenance and adjustment instructions in this manual. If additional informati
Inhaltszusammenfassung zur Seite Nr. 8
R Section 1 1.4 SYMBOLS SYMBOL DESCRIPTION SYMBOL DESCRIPTION Choke Transmission Parking Brake Spinning Blade 48071S On/Start Spring Tension on Idler Off/Stop Oil Falling Hazard Thrown Object Hazard Fast Slow Continuously Variable - Linear Cutting Element - Basic Symbol Pinch Point Cutting Element - Engage 481039S Hour meter/Elapsed Operating Hours Cutting Element - Disengage Thrown Object Hazard Read Operator's Manual Keep Bystanders Away 2
Inhaltszusammenfassung zur Seite Nr. 9
R Section 2 SAFETY INFORMATION 2.1 INTRODUCTION DANGER Your mower is only as safe as the operator. Carelessness or operator error may result in serious bodily injury The signal word “DANGER” denotes that an extremely or death. Hazard control and accident prevention are hazardous situation exists on or near the machine that dependent upon the awareness, concern, prudence, and could result in high probability of death or irreparable injury proper training of the personnel involved in the o
Inhaltszusammenfassung zur Seite Nr. 10
R Section 2 3. DO NOT allow children to ride or play on the 10. Be sure the interlock switches are functioning machine, it is not a toy. correctly. 4. Clear the area to be mowed of objects that could be 11. Fuel is flammable; handle it with care. Fill the fuel picked up and thrown by the cutter blades. tank outdoors. Never fill it indoors. Use a funnel or spout to prevent spillage. Clean up any spillage 5. DO NOT carry passengers. before starting the engine. 6. DO NOT operate the machine und
Inhaltszusammenfassung zur Seite Nr. 11
R Section 2 2. Reduce speed and exercise extreme caution on 14. Take all possible precautions when leaving the slopes and in sharp turns to prevent tipping or loss machine unattended, such as disengaging the of control. Be especially cautious when changing mower, lowering the attachments, setting the parking directions on slopes. brake, stopping the engine, and removing the key. 3. Stay two cut widths away from slopes, drop offs, 15. Disengage power to the attachments when ditches and retain
Inhaltszusammenfassung zur Seite Nr. 12
R Section 2 22. Use care when approaching blind corners, shrubs, Lower the roll bar only when absolutely necessary. trees, or other objects that may obscure vision. 1. To lower the roll bar, remove the hairpin cotter pins 23. NEVER leave the machine running unattended. and remove the two (2) lock pins. See Figure 2-2. 2. Lower the roll bar to the down position. 2.5 ROLL-OVER PROTECTION SYSTEM 3. To raise the roll bar, lift the bar to the upright position. 4. Install the two (2) lock pins throu
Inhaltszusammenfassung zur Seite Nr. 13
R Section 2 WARNING o 20 o Failure to properly inspect and maintain the seat 15 belt can cause serious injury or loss of life. o 10 o 5 1. Check the full length of the seat belt webbing for cuts, wear, fraying, dirt and stiffness. See Figure 2-3. Figure 2-4. Slope Angle Graph 2. Check the seat belt webbing in areas exposed to ultra violet rays from the sun or extreme dust or dirt. If the original color of the webbing in these WARNING areas is extremely faded and/or is packed with dirt, th
Inhaltszusammenfassung zur Seite Nr. 14
R Section 2 2.6 MAINTENANCE CONSIDERATIONS & STORAGE WARNING 1. Never make adjustments to the machine with the Hydraulic fl uid is under high pressure and can engine running unless specifically instructed to do penetrate skin causing injury. If hydraulic fl uid so. If the engine is running, keep hands, feet, and is injected into the skin, it must be surgically clothing away from moving parts. removed within a few hours by a doctor or gangrene may result. 2. Disengage drives, lower implem
Inhaltszusammenfassung zur Seite Nr. 15
R Section 2 2.9 SAFETY AND INSTRUCTIONAL DECALS WARNING INSTALL BELT COVER BEFORE OPERATING MACHINE READ OPERATOR'S MANUAL 483402 483407 483402 483407 FORWARD R F REVERSE 481568 WARNING WARNING Operation of this equipment 483406 may create sparks that can start fires around dry vegetation. A spark arrestor may be required. The operator should contact local fire agencies for laws or regulations relating to fire prevention requirements. 483900 483900 (supplied with California 483633 models on
Inhaltszusammenfassung zur Seite Nr. 16
R Section 3 SPECIFICATIONS 3.1 ENGINE General Type ................................................................................................Heavy Duty Industrial/Commercial Gasoline Model: Scag Model STT52V-27CH, STT61V-27CH .......................................................................Kohler Command CH740S Scag Model STT61V-27KA ............................................................................................................ Kawasaki FD750D Scag Model STT61V-29DFI-SS,
Inhaltszusammenfassung zur Seite Nr. 17
R Section 3 3.3 POWER HEAD Drive System ............... Hydraulic Drive with Two Variable Displacement Pumps and Two Cast-Iron High Torque Motors Hydrostatic Pumps .....................................................................Two Hydro-Gear™ 16 cc/rev. Pumps with Dump Valves Drive Wheel Motors: ......................................................Two Parker Model TG 15 cu. inch Cast-Iron High Torque Motors Steering/Travel Control ..........................................................
Inhaltszusammenfassung zur Seite Nr. 18
R Section 3 3.5 HYDRAULIC SYSTEM Hydraulic Oil Filter ........................................................................................................ 10 Micron Spin-on Element Type Hydraulic Reservoir .....................................................................................................................Nylon; 3 Quart Capacity 3.6 WEIGHTS AND DIMENSIONS 52v 61v 72vS Length....................................................................
Inhaltszusammenfassung zur Seite Nr. 19
R Section 4 OPERATING INSTRUCTIONS 2. Mower Deck Switch (Figure 4-1). Used to engage and disengage the mower drive system. Pulling up CAUTION on the switch will engage the deck drive. Pushing down on the switch will disengage the deck drive. Do not attempt to operate this mower unless you 3. Engine Choke Control (Figure 4-1). Used to start have read this manual. Learn the location and a cold engine. Not used on the 29DFI. purpose of all controls and instruments before 4. Engine Throttl
Inhaltszusammenfassung zur Seite Nr. 20
R Section 4 6. Hourmeter (Figure 4-1). Indicates the number of 14. Cutting Height Adjustment (Figure 4-1). Used to hours the engine has been operated. It only operates set the cutter deck at the desired cutting height. when the engine is running. Has preset maintenance 15. Deck Release Lever (Figure 4-1). Used to lock the reminders for engine and hydraulic system oil cutter deck in the transport position. Push the foot changes. Will start flashing scheduled maintenance pedal forward and
