Bedienungsanleitung Snapper 1691530

Inhaltszusammenfassung zur Seite Nr. 1

INSTALLATION
INSTRUCTIONS
MFG. NO. 1691530
HORN KIT FOR
FRONT-CUT RlDERS
Mounting configuration
for Hvdro units onlv.
Figure 1.
Ref. Pati
my. Description
NO.
NO.
HORN ASSY., (Included in Ref. No. K)
1
A 1679968
NUT, Flange Whizlock, l/4-20
1
8 1930641
1 CAPSCREW, Hex. 1/4-20x 5/8
C 1921969
932747 1 TIE, Cable
D
NUT, Flange Whizlock, 5/16-l 8
E 1931277 1
1 CAPSCREW. Taptite, 5/16-18x 1.00
F 1927477
1 WIRE ASSY.. (Blackl
G 1700095
1700094 1 WIRE ASSY. (Red)
H
CONNECTOR, Wire, Self-Stripping
1
I 16

Inhaltszusammenfassung zur Seite Nr. 2

NOTE Not all hardware supplied with horn kit will be used for this installation. Discard excess hardware. Refer to figure 1 to familiarize yourself with the assembly. NOTE On newer gear models, battery is not located in rear compartment (see figure 3). This allows installation by either of the following methods. Figure 3. Early Gear Models HORN INSTALLATION - Early Gear Models A. Horn B. Wire 1. Install the two mounting plates (A, figure 2) together and install onto the shift cable mounting brac

Inhaltszusammenfassung zur Seite Nr. 3

b. Remove this existing screw, and install new 5/ 16- 4. Route the 45-inch black wire (A, figure 6) up into 18 x 1 screw (F), being sure the retainer is in steerine column thmuah hole in frame. original position. c. Place the horn assembly into position onto the screw and install the flange whizlock nut(E). The horn should appear as in figure 4. 4. ,Connect the 45-inch wire(C) to either horn terminal CD). Route the wire, under the footrest as shown. 5. Go to HORN BUTTON INSTALLATION - All Models