Inhaltszusammenfassung zur Seite Nr. 1
Operator’s Manual
20" Mulching Push
Lawn Mower
MODEL 107
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if
any). If a spark arrester is used, it should be maintained in effective work
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS Content Page Important Safe Operation Practices ...................................................................... 3 Slope Gauge ......................................................................................................... 6 Assembling Your Lawn Mower .............................................................................. 7 Know Your Lawn Mower........................................................................................ 8 Operating Your Lawn Mo
Inhaltszusammenfassung zur Seite Nr. 3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—HEED ITS WARNING. WARNING: Engine exhaust, some of its constituents, and certain vehicle components con
Inhaltszusammenfassung zur Seite Nr. 4
20. Never operate mower without proper trail shield, 5. Keep children away from hot or running engines. They discharge cover, grass catcher, blade control handle or can suffer burns from a hot muffler. other safety protective devices in place and working. 6. Never allow children under 14 years old to operate a Never operate mower with damaged safety devices. power mower. Children 14 years old and over should Failure to do so, can result in personal injury. read and understand the operation
Inhaltszusammenfassung zur Seite Nr. 5
3. Check the blade and engine mounting bolts at frequent 8. Never attempt to make a wheel or cutting height intervals for proper tightness. Also, visually inspect blade adjustment while the engine is running. for damage (e.g., bent, cracked, worn) Replace blade 9. Grass catcher components, discharge cover, and trail with the original equipment manufacture’s (O.E.M.) blade shield are subject to wear and damage which could only, listed in this manual. “Use of parts which do not expose moving
Inhaltszusammenfassung zur Seite Nr. 6
USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY. SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST 15° WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious
Inhaltszusammenfassung zur Seite Nr. 7
SECTION 3: ASSEMBLING YOUR LAWN MOWER To Remove Unit From Carton Remove staples, break glue on top flaps, or cut tape Carriage Bolt at carton end and peel along top flap to open carton. Remove loose parts included with your unit (i.e., Saddle Washer operator’s manual, etc.). Upper Cut along corners and lay carton down flat. Handle Lower Remove packing material. Handle Roll or slide unit out of carton. IMPORTANT: This unit is shipped WITHOUT Hand GASOLINE. Make sure to service engi
Inhaltszusammenfassung zur Seite Nr. 8
With the spark plug wire disconnected and Converting to Side Discharge grounded, hold the blade control handle against the Your mower has been shipped as a mulcher. To upper handle, and pull the starter rope out of the convert it to a side-discharge mower, lift the engine. Release the blade control handle. Slip the mulching plug. Slide the two hooks on the side- starter rope into the rope guide. Tighten the wing discharge deflector under the hinge pin on the nut. See Figure 4. mulch
Inhaltszusammenfassung zur Seite Nr. 9
SECTION 5: OPERATING YOUR LAWN MOWER Pull rope with a rapid, continuous, full arm stroke. WARNING: Keep hands and feet away Keep a firm grip on starter handle. Return it slowly from the chute area on cutting deck. The to the rope guide. If you encounter any problems, blade will be rotating whenever the engine is refer to the Trouble Shooting Guide for helpful running. information. Be sure no one other than the operator is standing near the lawn mower while starting Stopping Engine and B
Inhaltszusammenfassung zur Seite Nr. 10
SECTION 6: MAKING ADJUSTMENTS WARNING: Do not at any time make any Carburetor adjustment to your lawn mower without first stopping the engine and disconnecting the WARNING: If any adjustments are made to spark plug wire. the engine while the engine is running (e.g. carburetor), keep clear of all moving parts and heated surfaces (e.g. muffler). Handle Height Your mower is shipped with the handle in the higher Minor carburetor adjustments may be required to height position.To lower the handl
Inhaltszusammenfassung zur Seite Nr. 11
SECTION 7: MAINTAINING YOUR LAWN MOWER WARNING: Always stop engine and To remove blade: disconnect spark plug wire before cleaning, Remove the bolt and blade bell support which hold lubricating or doing any kind of maintenance the blade and adapter to the engine crankshaft. work on lawn mower. See Figure 11. Remove the blade and the adapter from the crankshaft. Lubrication WARNING: Periodically inspect the blade adapter for cracks, especially if you strike a Blade Control foreign object. R
Inhaltszusammenfassung zur Seite Nr. 12
Maintain engine oil as instructed in the engine Cutting Deck manual. The underside of the mower deck should be Service air cleaner every 25 hours of operation cleaned after each use to prevent a build-up of under normal conditions. Clean every few hours grass clippings, leaves, dirt or other matter. If this under extremely dusty conditions. Poor engine debris is allowed to accumulate, it will invite rust performance and flooding usually indicates that the and corrosion, and may pr
Inhaltszusammenfassung zur Seite Nr. 13
SECTION 9: TROUBLE SHOOTING GUIDE Trouble Possible Cause(s) Corrective Action Engine fails to start 1. Blade control handle disengaged. 1. Engage blade control handle. 2. Spark plug wire disconnected. 2. Connect wire to spark plug. 3. Fuel tank empty, or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Blocked fuel line. 4. Clean fuel line. 5. Faulty spark plug. 5. Clean, adjust gap or replace. 6. Engine flooded. 6. Wait a few minutes to restart. Do not prime. Engine runs erratic 1. Spar
Inhaltszusammenfassung zur Seite Nr. 14
SECTION 10: PARTS LIST MODEL 107 1 5 13 2 4 3 6 46 8 10 7 15 11 8 46 9 16 12 17 28 27 29 18 35 20 22 19 32 21 24 23 45 30 33 26 25 38 33 34 20 22 36 38 37 19 40 39 24 23 27 26 21 25 41 43 42 44 14
Inhaltszusammenfassung zur Seite Nr. 15
Model 107 Ref. No. Part No. Description Ref. No. Part No. Description 647-0004 Control Handle Assembly 738-0507B Shoulder Bolt 1. 26. 710-1270 Oval C-Sunk Screw 15262B Pivot Bar 2. 27. 712-0324 Hex Lock Nut 682-3024 Handle Bracket Assembly RH 3. 28. 746-0883 Control Housing 4. 682-3025 Handle Bracket Assembly LH* 720-0295 Foam Grip 29. 738-0585 Stake Bolt 5. 749-0705A Upper Handle 30. 732-0731 Torsion Spring 6. 710-1205 Rope Guide 31. 14578 Height Adjust. Assembly RH 7. 710-1174 Carriage Bolt 14
Inhaltszusammenfassung zur Seite Nr. 16
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC with d. MTD LLC does not extend any warranty for products respect to new merchandise purchased and used in the sold or exported outside of the United States, its United States, its possessions and territories. possessions and territories, except those sold through MTD LLC’s authorized channels of export distribution. MTD LLC warrants this product against defects for a period of e. Parts that are not
