Inhaltszusammenfassung zur Seite Nr. 1
For Serial Nos.
600,000 & Higher
Part No. 109-2279 Rev B.
Inhaltszusammenfassung zur Seite Nr. 2
WARNING POTENTIAL HAZARD ♦ This product is a piece of power equipment. WHAT CAN HAPPEN ♦ Failure to follow safe operating practices can result in serious operator injury or even death. HOW TO AVOID THE HAZARD ♦ Keep all shields, guards, and safety devices (especially the grass discharge system) in place and in proper working condition. ♦ Stop engine and wait for all moving parts to stop. Remove spark plug wire(s) or remove key before adjusting, servicing, or performing
Inhaltszusammenfassung zur Seite Nr. 3
® EXMARK PARTS PLUS PROGRAM EFFECTIVE DATE: September 1, 1995 Program If your Exmark dealer does not have the Exmark part in stock, Exmark will get the parts to the dealer the next business day or the part will be FREE* Guaranteed!! How the Program Works 1. If dealer does not have part in stock for a "down" unit at the time of request by customer, the dealer contacts his distributor by 1:00 p.m., local time, and requests Exmark ® Parts Plus shipment of six (6) line items or
Inhaltszusammenfassung zur Seite Nr. 4
CONGRATULATIONS on the purchase of your Exmark Mower. This product has been carefully designed and manufactured to give you a maximum amount of dependability and years of trouble-free operation. OPERATOR'S MANUAL This manual contains assembly, operating, maintenance, adjustment, and safety instructions for your Exmark mower. BEFORE OPERATING YOUR MOWER, CAREFULLY READ THIS MANUAL IN ITS ENTIRETY. By following the operating, maintenance, and safety instructions, you will
Inhaltszusammenfassung zur Seite Nr. 5
TABLE OF CONTENTS 1. SAFETY PAGE 1.1 Safety Alert Symbol............................................................................1 1.2 Training ..............................................................................................1 1.3 Preparation......................................................................................1-3 1.4 Operation ........................................................................................4-7 1.5 Ma
Inhaltszusammenfassung zur Seite Nr. 6
1. SAFETY 1.1 SAFETY ALERT SYMBOL This SAFETY ALERT SYMBOL is used both in this manual and on the machine to identify important safety messages which must be followed to avoid accidents. This symbol means: ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! The safety alert symbol appears above information which alerts you to unsafe actions or situations and will be followed by the word DANGER, WARNING, or CAUTION. DANGER: White lettering / Red background. Indicates an imminently
Inhaltszusammenfassung zur Seite Nr. 7
1.3.4 Thoroughly inspect the area where the equipment is to be used and remove all stones, sticks, wires, bones, and other foreign objects which may damage the equipment or cause personal injury to the operator or bystanders. WARNING POTENTIAL HAZARD ♦ Engine exhaust contains carbon monoxide, which is an odorless deadly poison. WHAT CAN HAPPEN ♦ Carbon monoxide can kill you. HOW TO AVOID THE HAZARD ♦ Do not run engine indoors or in a small confined area where dangerous carb
Inhaltszusammenfassung zur Seite Nr. 8
DANGER POTENTIAL HAZARD ♦ In certain conditions gasoline is extremely flammable and highly explosive. WHAT CAN HAPPEN ♦ A static charge can ignite gasoline vapors. A fire or explosion from gasoline can burn you, others, and cause property damage. HOW TO AVOID THE HAZARD ♦ Purchase and store gasoline only in an approved container. ♦ Always place gasoline containers on the ground away from your vehicle before filling. ♦ Do not fill gasoline containers inside a vehicle or on
Inhaltszusammenfassung zur Seite Nr. 9
1.4 OPERATION Although hazard control and accident prevention partially are dependent upon the design and configuration of the equipment, these factors are also dependent upon the awareness, concern, prudence, and proper training of the personnel involved in the operation, transport, maintenance, and storage of the equipment. It is essential that all Operator Safety Mechanisms be connected and in operating condition prior to use for mowing. WARNING POTENTIAL HAZARD ♦ Operating en
Inhaltszusammenfassung zur Seite Nr. 10
DANGER POTENTIAL HAZARD ♦ Mowing on wet grass or steep slopes can cause sliding and loss of control. WHAT CAN HAPPEN ♦ Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning. HOW TO AVOID THE HAZARD ♦ Do not mow slopes when grass is wet. ♦ Do not mow near drop-offs or near water. ♦ Do not mow slopes greater than 15 degrees. ♦ Reduce speed and use extreme caution on slopes. ♦ Avoid sudden turns or rapid
Inhaltszusammenfassung zur Seite Nr. 11
WARNING POTENTIAL HAZARD ♦ There is no rollover protection when the roll bar is down. WHAT CAN HAPPEN ♦ Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning. HOW TO AVOID THE HAZARD ♦ Keep the roll bar in the raised and locked position and use seat belt. ♦ Lower the roll bar only when absolutely necessary. ♦ Do not wear seat belt when the roll bar is down. ♦ Drive slowly and carefully. ♦ Raise the ro
Inhaltszusammenfassung zur Seite Nr. 12
1.4.16 This mower was designed for one operator only. Keep all others away from mower during operation. 1.4.17 Do Not mow with the discharge deflector raised, removed, or altered unless there is a grass collection system or mulch kit in place and working properly. 1.4.18 Be aware of the mower discharge and direct discharge away from others. 1.4.19 Do Not operate the mower under the influence of alcohol or drugs. 1.4.20 Use extra care when approaching blind corners, shrubs, trees, or
Inhaltszusammenfassung zur Seite Nr. 13
WARNING POTENTIAL HAZARD ♦ Hydraulic fluid escaping under pressure can penetrate skin and cause injury. WHAT CAN HAPPEN ♦ Fluid accidentally injected into the skin must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result. HOW TO AVOID THE HAZARD ♦ Make sure all hydraulic fluid hoses and lines are in good condition an all hydraulic connections and fittings are tight before applying pressure to hydraulic system. ♦ Keep
Inhaltszusammenfassung zur Seite Nr. 14
PART NO. 109-1196 LOCATION: Top Front of RH Tank PART NO. 103-4930 LOCATION: Right of Choke Control on RH Tank PART NO. 103-4892 LOCATION: Right of Throttle Control on RH Tank PART NO. 107-2102 PART NO. 98-5954 LOCATION: RH Inside Surface LOCATION: Under Mower Deck of Upper Roll bar Belt Shield(s) PART NO. 1-303508 LOCATION: Front Right Corner Top of Mower Deck PART NO. 1-523552 LOCATION
Inhaltszusammenfassung zur Seite Nr. 15
PART NO. 103-9287 LOCATION: Left of Center on Mower Deck, Under Floor Pan PART NO. 103-7491 LOCATION: On Top LH Side of Mower Deck PART NO. 103-9116 LOCATION: Bottom of Back Side of Seat PART NO. 1-513748 LOCATION: Bottom of Floorpan PART NO. 107-2112 PART NO. 1-653147 LOCATION: Top Center of Floorpan LOCATION: Lefthand Side of Cutting Height Adjustment Plate 2. SPECIFICATIONS 2.1 MODEL NUMBER: Se
Inhaltszusammenfassung zur Seite Nr. 16
2.3.2 Type of Fuel: Regular unleaded gasoline, 87 octane or higher. 2.3.3 Fuel Filter: Replaceable in-line Briggs and Stratton P/N 493629 2.3.4 Fuel Shut-Off Valve: in-line, 1/4 turn 2.4 ELECTRICAL SYSTEM 2.4.1 Charging System: Flywheel Alternator 2.4.2 Charging Capacity: 15 amps 2.4.3 Battery Type: BCI Group U1 2.4.4 Battery Voltage: 12 Volt 2.4.5 Polarity: Negative Ground 2.4.6 Fuses: Two 20 amp blade type 2.4.7 Safety Interlock System: PTO must be disengaged,
Inhaltszusammenfassung zur Seite Nr. 17
2.7 HYDROSTATIC GROUND DRIVE SYSTEM 2.7.1 Hydrostatic Pumps: Two Hydro Gear BDP-10A variable displacement piston pumps. 2.7.2 Wheel Motors: Two Hydro Gear wheel drive motors with 1 1/4” tapered shafts. 2.7.3 Hydraulic Oil: Use Mobil 1 15W-50 Synthetic Motor Oil. 2.7.4 Hydraulic Oil Capacity: 2.1 qt. (2.0 L.) 2.7.5 Hydraulic Filter: Replaceable cartridge type. P/N 1-513211: 10 microns, 18 psi bypass (Summer use above 32 ° F (0°C)) P/N 1-523541: 40 microns, 18 psi bypass (Wint
Inhaltszusammenfassung zur Seite Nr. 18
2.10.2 Overall Length: 48” Deck 52” Deck 60” Deck Roll Bar - Up 73.9 in. 75.5 in. 77 in. (187.7 cm) (191.8 cm) (195.6 cm) Roll Bar - Down 79.6 in. 81.2 in. 82.4 in. (202.2 cm) (206.2 cm) (209.3 cm) 2.10.3 Overall Height: Roll Bar - Up Roll Bar - Down 69.4in. (176.3 cm) 51.3 in. (130.3 cm) 2.10.4 Tread Width: (center to center of tires, widthwise) 60” Deck 48” Deck 52” Deck Drive Wheels 34.9 in. 34.9 in. 39.8 in. (88.6 cm) (88.6 cm) (101.1 cm) Front Casters 32.7 in. 34.1
Inhaltszusammenfassung zur Seite Nr. 19
FIGURE 2 MOTION CONTROL POSITIONS By moving both levers an equal amount forward or back from the neutral position the machine can be caused to move forward or backward in a straight line. Movement of the left lever forward will cause the left drive wheel to rotate in a forward direction. Movement of the right lever forward will cause the right drive wheel to rotate in a forward direction. To stop forward travel, pull the levers back to the neutral positi
Inhaltszusammenfassung zur Seite Nr. 20
3.1.4 PTO Engagement Switch: Located on the right tank. Switch must be pulled out to the “ROTATE” position to engage the blades. Switch is pushed in to the “STOP” position to stop the blades. 3.1.5 Choke Control: Located on the right fuel tank. Choke is used to aid in starting a cold engine. DO NOT run a warm engine with choke in the “ON” position. Moving the choke lever forward will put the choke in the “ON” position and moving the choke lever to the rear will put the choke
