Inhaltszusammenfassung zur Seite Nr. 1
Models
20112X92E0
20112X92E1
MOWER
INSTRUCTION BOOK
This Instruction Book contains information for several models.
Read and keep this book for future reference.
This book contains important information on
SAFETY, ASSEMBLY, OPERATION, MAINTENANCE & STORAGE.
PRODUCT INFORMATION
The owner must be certain that all the product information is in-
cluded with the unit. This information includes the INSTRUCTION
BOOKS, the REPLACEMENT PARTS and the WARRANTIES.
This information must be included to make
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS Warranty .................................................. 2 Maintenance..................................... 12-14 Safety Rules ......................................... 3-5 Service and Adjustments....................... 15 Product Spec i fi ca tions ........................... 5 Storage............................................. 15-16 Assembly/Pre-Operation ...................... 6-8 Troubleshooting ................................ 16-17 Operation.........................
Inhaltszusammenfassung zur Seite Nr. 3
OWNER'S INFORMATION This instruction book is written for a person unit is correctly assembled. The owner must with some mechanical ability. Like most ser- carefully check the unit according to the in- structions in this manual before it is fi rst used. vice books, not all the steps are described. Steps on how to loosen or tighten fasten- RESPONSIBILITY OF THE OWNER ers are steps anyone can follow with some The responsibility of the owner is to mechanical ability. Read and follow these fo
Inhaltszusammenfassung zur Seite Nr. 4
• See manufacturer’s instructions for • Be alert and turn machine off if chil dren proper operation and installation of enter the area. accessories. Only use accessories ap- • Before and while walking back wards, proved by the manufacturer. look behind and down for small chil dren. • Stop the blade(s) when crossing grav el • Never allow children to operate the drives, walks, or roads. machine. • Stop the engine (motor) whenever you • Use extra care when approaching blind leave the equip men
Inhaltszusammenfassung zur Seite Nr. 5
• Never attempt to make wheel height • Mower blades are sharp and can cut. adjustments while the engine is running. Wrap the blade(s) or wear gloves, and • Grass catcher components are sub ject to use extra caution when ser vic ing them. wear, dam age, and de te ri o ration, which • Do not change the engine governor set- could expose moving parts or allow objects ting or overspeed the engine. to be thrown. Frequently check com po - • Maintain or replace safety and instruc- nents and replace w
Inhaltszusammenfassung zur Seite Nr. 6
Parts packed separately in carton Parts Bag Contents (not shown full size) (1) Control Bar (1) Rope Guide (1) Upper Handle (1) Lower Handle (2) Wire Ties (1) Engine Zone Control (4) Wheels (1) Discharge Guard (1) Upstop Bracket Cable ASSEMBLY / PRE-OPERATION TOOLS REQUIRED FOR AS SEM BLY CAUTION: Do not operate this mower without the discharge guard or an entire A socket wrench set will make as sem bly approved grass catcher in place. These easier. Standard wrench sizes are listed. guards
Inhaltszusammenfassung zur Seite Nr. 7
1. Position lower handle on housing so ASSEMBLE WHEELS cut-off fl at is forward as shown. Cutting height is determined by as sem - 2. Align holes in handle with holes in bling the wheels in one of four possible housing as shown and as sem ble 3/8- positions on the mower hous ing. All 16 x 3/4 hex bolts, fl at wash ers, and wheels must be in the same height posi- locknuts. Tight en se cure ly. tion for even cutting. 3. Repeat for opposite side of mower. 1. For each wheel, assemble shoul de
Inhaltszusammenfassung zur Seite Nr. 8
INSTALL CONTROL BAR Upper Control bar handle 1. Position control bar so fl attened sec- tion with hole is on opposite side of Up-stop handle as up-stop bracket. bracket 2. Insert one end of control bar into handle hole on inside of handle. Care- fully push in on opposite end of control bar and insert into hole on opposite Engine side of handle. zone control cable INSTALL STARTER ROPE 1. Put threaded end of rope guide Control bar through hole in side of upper handle above lower hand
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION KNOW YOUR LAWN MOWER READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER. Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your lawn mower or in literature supplied with the product. Learn and understand their meaning. Operator presence control bar Engine oil cap with dipstick Starter handle Muffl er Air fi lter H
Inhaltszusammenfassung zur Seite Nr. 10
BEFORE STARTING ENGINE The operation of any ADD OIL lawn mower can result Your lawnmower is shipped without oil in in foreign objects thrown the engine. For type and grade of oil to into the eyes, which can use, see “EN GINE” in the Maintenance result in severe eye dam- section of this manual. age. Always wear safety glasses or eye CAUTION: DO NOT overfi ll engine with shields while operating your lawn mower oil, or it will smoke heavily from the muffl er or performing any ad just men
Inhaltszusammenfassung zur Seite Nr. 11
MOWING TIPS CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can CA UTION: Do not use de-thatcher attract moisture which leads to separation blade attachments on your mower. Such and for ma tion of acids during storage. Acidic attachments are hazardous, will damage gas can damage the fuel system of an engine your mower and could void your warranty. while in storage. To avoid engine problems, • Under certain conditions, such as very the fuel system sho
Inhaltszusammenfassung zur Seite Nr. 12
MAINTENANCE BEFORE AFTER EVERY EVERY EVERY BEFORE EACH EACH 10 25HOURS 100 STORAGE USE USE HOURS ORSEASON HOURS Check for Loose Fasteners Clean / Inspect Grass Catcher * CheckTires Check DriveWheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery ** Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel sys
Inhaltszusammenfassung zur Seite Nr. 13
Blade adapter Key Crankshaft LAWN MOWER keyway Always observe safety rules when per- forming an y main te nance. Lockwasher TIRES Blade • Keep tires free of gasoline, oil, or insect control chemi cals which can harm rubber. • Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. Blade bolt Hardened BLADE CARE washer Trailing edge Crankshaft For best results, blade must be kept sharp. Re place a bent or dam aged blade. CA UTION: Use only a replace
Inhaltszusammenfassung zur Seite Nr. 14
ASSEMBLE ONE OF THESE LOW POINTS TO CHANGE ENGINE OIL Screw TOWARDS NARROW EDGE OF ELEMENT 1. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 2. Be sure lawn mower is on level sur- face. NOTE: Oil will drain more freely when warm. Catch oil in a suitable container. 3. Remove bottom oil drain plug. 4. After oil has drained completely, Lip Element Cup Body replace oil drain plug and tighten se- ASSEMBLE SO LIP curely. EXTENDS OVER ED
Inhaltszusammenfassung zur Seite Nr. 15
SERVICE AND ADJUSTMENTS WARNING: To avoid serious injury, before per forming an y service or ad just ments: 1. Release control bar and stop engine. 2. Make sure the blade and all moving parts have completely stopped. 3. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. LAWN MOWER ENGINE TO ADJUST CUTTING HEIGHT ENGINE SPEED See “TO ADJUST CUTTING HEIGHT” in Your engine speed has been factory set. Do the Operation sec tion of this manual.
Inhaltszusammenfassung zur Seite Nr. 16
NOTE: Fuel stabilizer is an acceptable OTHER al ter na tive in minimizing the formation • Do not store gasoline from one season of fuel gum deposits during stor age. to another. Add stabilizer to gasoline in fuel tank or • Replace your gasoline can if your can storage con tain er. Always follow the mix starts to rust. Rust and/or dirt in your gasoline will cause problems. ratio found on stabilizer container. Run • If possible, store your unit indoors and engine at least 10 min utes a
Inhaltszusammenfassung zur Seite Nr. 17
TROUBLESHOOTING - See appropriate section in manual unless directed to a qualifi ed service center. PROBLEM CAUSE CORRECTION Loss of power 1. Rear of mower housing or 1. Raise cutting height. blade dragging in grass. 2. Cutting too much grass. 2. Raise cutting height. 3. Dirty air fi lter.
Inhaltszusammenfassung zur Seite Nr. 18
¨ PARTS AND SERVICE This product has been expertly engineered and carefully manufactured to rigid quality standards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. For Parts and Service, contact our authorized distributor: call 1-800-849-1297 • For replacement parts, have available the following information: a. Model Number / Manufacturer's I.D. Number b. Description of part. For Technical Assistance: call 1-800-829-5886
