Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Copyright 1998 Paradyne Corporation. All rights reserved. Printed in U.S.A. Notice This publication is protected by federal copyright law. No part of this publication may be copied or distributed, transmitted, transcribed, stored in a retrieval system, or translated into any human or computer language in any form or by any means, electronic, mechanical, magnetic, manual or otherwise, or disclosed to third parties without the express written permission of Paradyne Corporation, 8545 126th Ave. N
Inhaltszusammenfassung zur Seite Nr. 3
Contents About This Guide Document Purpose and Intended Audience . . . . . . . . . . . . . . . . . . . . . . . . . iii Document Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii Product-Related Documents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iv 1 Introduction What is the Multiuser Feature? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Feature List . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
About This Guide Document Purpose and Intended Audience This guide describes how to install and use the COMSPHERE 6700 Series Network Management System (NMS) Multiuser feature. It is assumed that you have a basic understanding of modems and their operation, are knowledgeable about data communications, and are familiar with Windows terminology and conventions. You or your LAN administrator should also have knowledge of TCP/IP. Document Summary Section Description Chapter 1 Introduction. Provides
Inhaltszusammenfassung zur Seite Nr. 5
About This Guide Product-Related Documents Document Number Document Title 3000-A2-GA31 COMSPHERE 3000 Series Carrier, Installation Manual 3610-A2-GB46 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, User’s Guide 3610-A2-GB48 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, Time Division Multiplexer, Multichannel Multipoint, and Digital Bridge Options Supplement 3610-A2-GB49 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, Dial Backup Module Option
Inhaltszusammenfassung zur Seite Nr. 6
About This Guide Product-Related Documents Document Number Document Title 3000-A2-GA31 COMSPHERE 3000 Series Carrier, Installation Manual 3610-A2-GB46 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, User’s Guide 3610-A2-GB48 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, Time Division Multiplexer, Multichannel Multipoint, and Digital Bridge Options Supplement 3610-A2-GB49 COMSPHERE 3600 Series Data Service Units, Models 3610 and 3611, Dial Backup Module Option
Inhaltszusammenfassung zur Seite Nr. 7
Introduction 1 What is the Multiuser Feature? The COMSPHERE 6700 Multiuser feature gives you the ability to connect multiple Windows workstations together to form a network of NMS users. With this feature, each user’s workstation has a complete graphical interface that interacts with the NMS as if it were a single user workstation. The Multiuser feature consists of two separately orderable packages: Server and Client. You can install the Multiuser Server and Client packages on the COMSPHERE 6700
Inhaltszusammenfassung zur Seite Nr. 8
Introduction Sample Multiuser Network Topologies When using the Multiuser feature, one workstation must be configured as the NMS server where the NMS database resides and the control channels are connected. The server is also the point of interface with all NMS devices. All other networked workstations must be configured as an NMS client, which executes only the user interface portion of the NMS. Figures 1-1, 1-2, and 1-3 show some sample Multiuser feature network topologies. Figure 1-1. Multius
Inhaltszusammenfassung zur Seite Nr. 9
Introduction Figure 1-2. Multiuser Serial Network (Using SLIP and/or PPP) Figure 1-3. Multiuser Serial Gateway or Ethernet Modem (Using SLIP and/or PPP) 6700-A2-GB21-20 February 1998 1-3
Inhaltszusammenfassung zur Seite Nr. 10
Introduction Multiuser Feature Package Contents The Multiuser feature package includes the following: Server: Multiuser server software on one or more 3 1/2″ disks One COMSPHERE 6700 Series Network Management System Multiuser Feature User’s Guide One COMSPHERE 6700 Series Network Management System Network Configuration Guide Client: Multiuser client software on one or more 3 1/2″ disks One COMSPHERE 6700 Series Network Management System Multiuser Feature User’s Guide One COMSPHERE 67
Inhaltszusammenfassung zur Seite Nr. 11
Installation 2 Hardware Requirements The following are the hardware requirements for installation of the Multiuser feature server and client software: Server 486 processor, 66 MHz or higher PC (or compatible computer) 16 MB of RAM (32 MB of RAM recommended) Hard disk with 15 MB of free space and a minimum of 14 ms access time Super VGA (800 x 600 resolution) or higher with 256 colors Video accelerator card One of the following network interfaces: — NDIS-compliant network adapter — OD
Inhaltszusammenfassung zur Seite Nr. 12
Installation This configuration is sufficient for a network of 1–512 local and remote devices. If the number of devices increases, use the following table as a guideline for upgrading your hardware configuration: Number of Devices Processor Required Memory Required 513–1024 486 (66 MHz) 16 megabytes 1025–1536 486 (90 MHz) 16 megabytes 1537–4000 Pentium (133 MHz) 32 megabytes Client 486 processor, 66 MHz or higher PC (or compatible computer) 16 MB of RAM (32 MB of RAM recommended) Hard disk
Inhaltszusammenfassung zur Seite Nr. 13
Installation Supported Network Adapters To use the Multiuser feature on Ethernet, Token Ring, or FDDI, you must install a supported network adapter board. Supported boards are listed in Table 2-1. Table 2-1. Support Network Adapter Boards (1 of 2) Interface Vendor Modem Ethernet 3COM 3C501 Ether Link 3C503 Ether Link II 3C505 Ether Link Plus 3C507 Ether Link 16 3C509 Ether Link III 3C523 Ether Link/MC TP 3C527 Ether Link/MC 32 Allied Telesis AT-1500 Network Adapter Hewlett-Packard HP27247/HP2725
Inhaltszusammenfassung zur Seite Nr. 14
Installation Table 2-1. Support Network Adapter Boards (2 of 2) Interface Vendor Modem Token Ring IBM 16/4 Token Ring Adapter Xircom All PT Models Madge Smart 16/4 RingNode adapter Proteon p139X p189X p1990 Raycone 16/4 Token Ring Adapter Other (NDIS Driver Required) FDDI Any (NDIS Driver Required) Software and Installation Requirements You must have one of the following sets of software installed before you install the Multiuser feature server or client software: COMSPHERE 6700 Series NMS Rel
Inhaltszusammenfassung zur Seite Nr. 15
Installation Installation Worksheet Before installing and configuring the Multiuser feature, you need some system and network information. Use the following form to collect the necessary information before you start the installation process. Retain this form as a record of this information. Examples are shown in brackets [ ]. Multiuser Feature Installation and Configuration Information General Where to install the software [c:\pcnms]: Location of network drivers [c:\pcnms]: Software Serial Numb
Inhaltszusammenfassung zur Seite Nr. 16
Installation Installing the Multiuser Feature To install the Multiuser feature server or client software, start from the Program Manager window. NOTE: NMS is designed to be the primary application program running on a personal computer. If you use NMS with other applications, it is your responsibility to ensure compatibility. Procedure 1. Insert Disk #1 into Drive A. 2. From the Program Manager window, choose File. 3. From the File menu, choose Run. 4. In the Command Line field, type A:\INSTAL
Inhaltszusammenfassung zur Seite Nr. 17
Installation 7. Choose Yes. The Destination Directory window appears. The Destination Directory window allows you to place the NMS software into a specific directory. A single directory within a single partition is required. 8. Enter a subdirectory location or choose the default setting of C:\PCNMS. 9. Choose Continue. The Confirmation window appears. 10. Choose Install to confirm the installation of the NMS software into the specified directory. The Completion status window appears. 6700-A2-GB2
Inhaltszusammenfassung zur Seite Nr. 18
Installation This window displays a bar indicating the percentage of completion for the current installation. In addition, the names of the files being installed appear above the bar until the installation is complete. The Installation Completed! window appears. 11. Choose OK to return to Windows. 12. To start NMS, choose the NMS icon from the COMSPHERE 6700 Program Group window. Configuring the Multiuser Feature After installation, use the Network Configuration application option to customize y
Inhaltszusammenfassung zur Seite Nr. 19
Index C S client sample topologies hardware requirements, 2-2 Ethernet modem, 1-3 package contents, 1-4 LAN network, 1-2 serial gateway, 1-3 serial network, 1-3 E serial gateway, sample topology, 1-3 Ethernet, supported network adapters, 2-3 serial network, sample topology, 1-3 Ethernet modem, sample topology, 1-3 server hardware requirements, 2-1 F package contents, 1-4, 2-1 software requirements, 2-4 FDDI, supported network adapters, 2-3 supported network adapters, 2-3 I T inst
