Inhaltszusammenfassung zur Seite Nr. 1
CID 2903 Caller ID
with Call Waiting
43-2903
Owner’s Manual
Please read before using this equipment.
Inhaltszusammenfassung zur Seite Nr. 2
WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. CAUTION RISK OF ELECTRIC ! SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICE- ABLE PARTS INSIDE. REFER SERVIC- ING TO QUALIFIED PERSONNEL. This symbol is intended to alert you to the presence of uninsu- lated dangerous voltage within the product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock
Inhaltszusammenfassung zur Seite Nr. 3
Contents Important Information ........................ 4 Features ............................................... 8 Preparation ........................................ 10 Installing Batteries/Setup ............. 10 Connecting AC Power ................. 13 Connecting the CID ..................... 14 Connecting to a Single-Line Phone ................ 14 Connecting to an Answering Machine .............. 15 Mounting the CID ......................... 16 Adjusting the Display Contrast .... 17 Op
Inhaltszusammenfassung zur Seite Nr. 4
Troubleshooting ................................ 29 Care ............................................. 30 Important Information To use this Caller ID (CID), you must be in an area where Caller ID service is available, and you must subscribe to the service. Where Caller ID is offered, one or more of the following options are generally available: • caller's number only • caller's name only • caller's name and number Your CID displays the caller's name only if that option is available in y
Inhaltszusammenfassung zur Seite Nr. 5
FCC INFORMATION We have designed your CID to conform to federal regulations, and you can connect it to most telephone lines. However, each CID (and each device, such as a telephone or answering machine) that you connect to the telephone line draws power from the line. We refer to this power draw as the device's ringer equivalence number or REN. The REN is on the bottom of the Caller ID. If you use more than one telephone or other device on the line, add up all of the RENs. If the tota
Inhaltszusammenfassung zur Seite Nr. 6
• most electronic key telephone systems In the unlikely event that your CID causes problems on the phone line, the phone company can temporarily disconnect your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC. Also, the phone company can make changes to its lines, equipment, operations, or procedures that c
Inhaltszusammenfassung zur Seite Nr. 7
operating properly. To eliminate interference, you can try one or more of the following corrective measures: • Reorient or relocate the TV or radio's receiving antenna. • Increase the distance between the equipment and the radio or TV. • Use outlets on different electrical circuits for the equipment and the radio or TV. Contact your local RadioShack store if the problem continues. LIGHTNING Your CID has built-in protection circuits to reduce the risk of damage from surges in telephone a
Inhaltszusammenfassung zur Seite Nr. 8
Features Your RadioShack CID 2903 Caller ID (CID) is the latest in telephone technology. The CID displays the caller's telephone number (and name, if available in your area) and the current date and time, as provided by your local phone company to Caller ID service subscribers. (The date and time are set with your first incoming Caller ID call.) Your Caller ID stores and displays up to 80 single (number only) or multiple (name and number) Caller ID records, and includes these featu
Inhaltszusammenfassung zur Seite Nr. 9
Call Waiting Indicator — displays the Caller ID information for Call Waiting calls. Call Summary — displays the number of calls you received. Message Waiting — displays when you have a voice mail message (if you subscribe to the message waiting service from your local phone company). Note: The Message Waiting feature does not work with stutter dial tone service. Check with your telephone company for the type of service you have. VIP Call List — lets you save up to 10 caller ID records i
Inhaltszusammenfassung zur Seite Nr. 10
Preparation INSTALLING BATTERIES/ SETUP Your CID requires four AAA batteries (not supplied) to protect its memory when AC power fails or is disconnected. For the longest life and best performance, we recommend RadioShack alkaline batteries. Cautions: • Use only fresh batteries of the required size and recommended type. • Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities. Follow thes
Inhaltszusammenfassung zur Seite Nr. 11
When replacing the batteries, make sure the CID is unplugged from the telephone line and AC power, and unplug both modular line cords from the back of the CID. Note: When replacing the batteries, have fresh ones on hand before you begin. If you do not install the new batteries within 2 minutes after removing the old ones, you will lose the time, date, and area code stored in the CID. (The Caller ID information, however, remains stored in the CID's memory.) 1. Use a Phillips screwdrive
Inhaltszusammenfassung zur Seite Nr. 12
REVIEW 9 9 9 9 to set the digit. The second 3 3 3 3 flashes. Notes: • If you make a mistake while setting the area code, press DELETE. The cursor moves to the previous digit of the area code. Then repeat Step 4 to reset the area code. • If you do not press any key within 2 minutes in this step or Step 5, the CID automatically sets the area code to 000. If this happens, press and hold REVIEW 8 8 8 8 and 9 9 9 9 simultaneously until 6( 6( 6( 6(7777 $5($ $5($ $5($ $5($ &2 &2 &2 &2' ' ' '
Inhaltszusammenfassung zur Seite Nr. 13
7. Close the cover and secure it with the screw. When %$7 %$7 %$7 %$71# 1# 1# 1#/2 /2 /2 /2: : : : flashes or the display dims, replace the batteries. Warning: Dispose of dead batteries promptly and properly; do not bury or burn them. Caution: Always remove old or weak batteries. Batteries can leak chemicals that can damage your CID. Note: If you replaced the batteries, reconnect the phone line, AC adapter, and the phone. CONNECTING AC POWER Cautions: You must use a Class 2 power source
Inhaltszusammenfassung zur Seite Nr. 14
• Always connect the AC adapter to the CID before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the CID. To power the CID, plug the supplied AC adapter's barrel plug into the DC9V 200mA jack on the back of the CID. Then connect the other end of the adapter to a standard AC outlet. CONNECTING THE CID The CID connects to any modular phone jack and your phone. You can also connect it to an answering machine. Connecting to a
Inhaltszusammenfassung zur Seite Nr. 15
Connecting to an Answering Machine 1. Disconnect the phone line cord from the answering machine's jack. Then plug it into the CID's LINE jack. 2. Plug one end of the supplied line cord into the CID's PHONE jack. 3. Plug the cord's other end into the answering machine's jack. 4. Set your answering machine to answer after two or more rings (see “Receiving and Storing Calls” on Page 17). Two or more rings gives the CID time to record the call information that the phone company sends betwe
Inhaltszusammenfassung zur Seite Nr. 16
MOUNTING THE CID You can place the CID directly on a flat surface with the supplied stand. Or, you can mount it on a wall. Follow these steps to mount the CID on a wall. 1. Turn the CID over, then press in the upper tabs and remove the stand. 2. Select a location near the phone line jack and mark the mounting screw 3 locations 2 /4 inch (69 mm) apart on the wall. 1 3. Drill two /8-inch (3.5 mm) holes in the wall at the marked locations. 4. Thread a screw into each hole until 1 the head
Inhaltszusammenfassung zur Seite Nr. 17
5. Align the two screws with the keyholes on the bottom of the CID. Slide the CID down onto the screws to secure it. ADJUSTING THE DISPLAY CONTRAST Your CID has four display contrast settings. To lighten or darken the display, repeatedly press CONTRAST on the back of the CID. &&&&2175 2175 2175 2175$ $ $ $6 6 6 67777 and the level 4 44 4,5 5 5 5, 6 6 6 6, or 7 7 7 7 briefly appear. Operation RECEIVING AND STORING CALLS Caller ID is a service provided by your telephone company. When y
Inhaltszusammenfassung zur Seite Nr. 18
The display also shows if caller information is not available or if the number is blocked by the sender (see “Displayed Call Information” on Page 20). Your CID saves up to 80 call records, then replaces the oldest call record with each new one. The indicator displays during an incoming call, and 1( 1( 1( 1(: : : :####&$ &$ &$ &$////////+ ++ +6 6 6 6, ,, , appears. The Caller ID record appears for about 20 seconds, then the Caller ID and new Caller ID record totals appear. Note: If you
Inhaltszusammenfassung zur Seite Nr. 19
flash, indicating that a new call is being received. If the indicator displays while the phone is ringing and you see 35,9 35,9 35,9 35,9$ $ $ $7777(((( &$ &$ &$ &$////////( (( (5 5 5 5, the caller is blocking their name and telephone number from being sent. If you receive more than one call from the same phone number, 5(3($ 5(3($ 5(3($ 5(3($7777 &$ &$ &$ &$//////// counter and the number of calls appear. If your phone company sends information indicating that the incoming call is long d
Inhaltszusammenfassung zur Seite Nr. 20
Notes: • If no call information is stored, 12 12 12 12 &$ &$ &$ &$////////6 6 6 6 appears when you press REVIEW 8 8 8 8 or 9 9 9 9. • If you do not press a button within 20 seconds, the CID automatically returns to the time and date display. • After you review all calls, (1' (1' (1' (1' 2) 2) 2) 2) /,6 /,6 /,6 /,67777 appears. Press REVIEW 8 8 8 8 or 9 9 9 9 to view the calls again. DISPLAYED CALL INFORMATION Display Description Appears as new calls ;; ;; ;; ;;####727$ 727$ 727$ 727$///
