Inhaltszusammenfassung zur Seite Nr. 1
UV8020
Installation and Operation Manual
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
CONTENTS Thank you for choosing a Phase Linear product. We hope you will find the instructions in this owner’s manual clear and easy to follow. If you take a few minutes to look through it, you’ll learn how to use all the features of your new Phase Linear UV8020 Mobile Multimedia Receiver for maximum enjoyment. Preparation............................................................................................................................ 1 Installation .................................
Inhaltszusammenfassung zur Seite Nr. 4
ii
Inhaltszusammenfassung zur Seite Nr. 5
UV8020 PREPARATION Congratulations on your purchase of the Phase Linear What’s in the Box UV8020 Mobile Multimedia Receiver. WARNING! To prevent damage to the mechanism inside 1. Left and Right Double DIN Mounting Brackets this unit, avoid impact to the TFT monitor. It’s a good idea to read all of the instructions before beginning 2. Double DIN Sleeve the installation. We recommend having your Phase Linear 3. Remote Control with Battery UV8020 installed by a reputable installation shop. 4. T
Inhaltszusammenfassung zur Seite Nr. 6
UV8020 INSTALLATION ISO DIN Installation CAUTION: For proper operation of the CD player, the This unit is designed to fit into a 2.0 DIN dashboard opening, chassis must be mounted within 30° of horizontal. Make found in many imported cars. The unit has threaded holes in sure the unit is mounted within this limitation. TAB the chassis side panels which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount the
Inhaltszusammenfassung zur Seite Nr. 7
UV8020 The 4 tabs on the trim ring will snap into four holes on top and CAUTION! Be careful not to damage the car wiring. bottom of the mounting sleeve. 5. Complete wiring as illustrated in the wiring diagram on page 3. Once the wiring is complete, reconnect the battery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch. TRIM RING MOUNTING SLEEVE OPTIONAL MOUNTING TRIM RING SLEEVE Replacing the Fuse The fuse is located next to the wirin
Inhaltszusammenfassung zur Seite Nr. 8
UV8020 WIRING DIAGRAM Rear View Video Camera AutoAntenna - BATTERY External Power Amplifier 4 REARL GREEN/BLACK(-) GREEN(+) WHITE/BLACK(-) WHITE(+) FRONTL GREY/BLACK(-) FRONTR GREY(+) PURPLE(+) REARR PURPLE/BL PURPLE/BLACK(-) ACK(-) IGNITIONSWITCH ACC RED FILTER/FUSE (15A) BATT YELLOW + BLACK GND ANT.CONT BLUE/WHITE PINK (-) PRKSW GREEN/WHITE GREEN/WHITE (+) (+) REVERSE B BLU LUEE SUB SUBWOOFER WOOFER RED REAR R WHITE REAR L RED FRONT R WHITE FRONT L Rear Video 1 VIDEO OUT 1 YELLOW Rear Video 2
Inhaltszusammenfassung zur Seite Nr. 9
UV8020 CONTROLS AND INDICATORS 1. POWER/MUTE Press to turn the unit on. Press and hold to turn the unit off. UV8020 MultiMedia Receiver When on, press to silence the receiver. Press again to resume the previous volume level. 2. SRC Press to select playing mode (SD, AV IN, DISC, Tuner). 3. VOL– Press to adjust the volume lower. 4. VOL+ Press to adjust the volume higher. 5. OPEN/EJECT 10 Press to activate the automatic mechanical system and move the TFT monitor down to reveal the CD and SD C
Inhaltszusammenfassung zur Seite Nr. 10
UV8020 REMOTE CONTROL Table 1: Remote Control Functions Button Function 8 12 MODE 23 4 Name Ref# DVD VCD TUNER CD/MP3 1 11 SUBTITLE MENU 1 Enters the main menu of the disc 2 9 TITLE 2 Enters the title menu of the 20 6 BAND REPT A-B disc 22 7 MUTE 3 Toggles audio output on/off Toggles audio output on/off Toggles audio output on/off Toggles audio output on/off 13 10 DVD SETUP OSD TIME 4 Turns the power on/off Turns the power on/off Turns the power on/off Turns the power on/off POWER/ 29 28 AUDIO
Inhaltszusammenfassung zur Seite Nr. 11
UV8020 Table 1: Remote Control Functions Button Function Name Ref# DVD VCD TUNER CD/MP3 24 Decreases monitor tilt Decreases monitor tilt Decreases monitor tilt Decreases monitor tilt angle angle angle angle 25 Increases monitor tilt angle Increases monitor tilt angle Increases monitor tilt angle Increases monitor tilt angle OK 26 Confirms Entry Confirms Entry Confirms Entry Confirms Entry 1, 2, 3, 4, 5, 27 Directly accesses chapter Directly accesses track 6, 7, 8, 9, 0, (press 10+ to move for-
Inhaltszusammenfassung zur Seite Nr. 12
UV8020 USING THE TFT MONITOR Open/Close TFT Monitor Image Setting Open TFT Monitor Table 2 shows the video output mode for each playing source. Press the EJECT button on the front panel (5) or remote control (23) to slide the monitor panel down and reveal the Table 2: Video Output Modes disc and SD card slots. Close TFT Monitor Playing Source Video Output Modes Press the EJECT button on the front panel (5) or remote AM/FM TUNER RGB Mode control (23) to close the monitor panel. DVD RGB Mode
Inhaltszusammenfassung zur Seite Nr. 13
UV8020 OPERATING INSTRUCTIONS The Audio menu will automatically exit after a few seconds of Power On / Off Volume Adjustment inactivity. To exit quickly, touch the bottom left corner of the To increase or decrease the volume level, press the VOL-/+ Press the / button (1) on the unit (or the button (4) on screen. buttons on the unit (3, 4) or on the remote control (15, 16). the remote control) to turn the unit on. When the volume level reaches “0” or “40”, a beep sounds, Setup Menu (SET)
Inhaltszusammenfassung zur Seite Nr. 14
UV8020 NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the reset is complete. 10
Inhaltszusammenfassung zur Seite Nr. 15
UV8020 DVD SETUP MENU During disc play, press the DVD SETUP button (29) on the Table 4: System Setup Menu Table 4: System Setup Menu remote control to access the SYSTEM SETUP menu. ASPECT RATIO 4: 3 PS With 16:9 display, AUDIO LAN- ENGLISH Choose from the left and right GUAGE audio languages FRENCH SYSTEM LANGUAGE VIDEO sides are cut off. contained on the DVD If you are SPANISH 4:3 LB With 16:9 display, watching a disc the top and bot- recorded in multi- PORTUGUESE tom are cut off. ple lan
Inhaltszusammenfassung zur Seite Nr. 16
UV8020 TUNER OPERATION Recalling a Station Tuner TFT Display Seek Tuning 1. Select a band (if needed). To seek the next higher station: 2. Touch an on-screen preset button (4) to select the 2 14 8 7 • Touch the >>| button on screen. corresponding stored station. • Press the >>| button (18) on remote control. SRC To seek the next lower station: 1 87.50 15 • Touch the |<<| button on screen. 87.50 P 2 101.10 • Press the |<< button (17) on the remote control. 1 1 87.50 3 98.90 5 EQ USER 2 101.10 Ma
Inhaltszusammenfassung zur Seite Nr. 17
UV8020 DVD/VCD VIDEO OPERATION also change the source by touching the top left corner to Stopping Playback NOTE: When properly installed, DVD video cannot be display the “SOURCE” menu. Select “DISC” to access DVD Touch the button on screen or on the remote control (14) to displayed on the main TFT screen unless the parking mode. stop disc play. brake is applied. If you attempt to play a DVD while the vehicle is moving, the TFT screen displays “DO NOT To resume playback, touch the /|| butto
Inhaltszusammenfassung zur Seite Nr. 18
UV8020 • TITLE: Press to display the title or chapter list. Use the To delete the list, highlight “CLEAR” and then press OK. • 1/4 ENG – English is the selected subtitle language Press PROG to exit the programmed playback screen. , , or cursor buttons or the numeric buttons to out of 4 possible choices enter a title or chapter number, and then press OK to • OFF – There are no alternate angles recorded for Remote Control Direct Track Entry play. this scene To select a track directly, use th
Inhaltszusammenfassung zur Seite Nr. 19
UV8020 Table 6: Disc Symbols Symbol Meaning Number of voice languages recorded. The number inside the icon indicates the number languages on the disc (maximum of 8). Number of subtitle languages available on the disc (maximum of 32). Number of angles provided (maximum of 9). Aspect ratios available. “LB” stands for Let- ter Box and “PS” stands for Pan/Scan. In the example on the left, the 16:9 video can be converted to Letter Box video. Indicates the region code where the disc can be playe
Inhaltszusammenfassung zur Seite Nr. 20
UV8020 DVD/CD AUDIO OPERATION Instructions for TFT control and Insert/Eject are the same for • RDM: Touch to activate/deactivate Random play mode. Programmed Playback DVD and CD operation. Please see the DVD/Disc Video • : Touch to suspend playback. Touch again to resume 1. Press the PROG button (34) on the remote control to Operation section for information about these topics. playback. access the programmed playback screen: The UV8020 will play music or other audio files from the Controlli
