Inhaltszusammenfassung zur Seite Nr. 1
™
Clean & Clear Plus Cartridge Filters Owner's Manual
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Table of Contents
SECTION I. FILTER INSTALLATION ................................................................................... 1
SECTION II. FILTER OPERATION AND CLEANING ........................................................... 3
SECTION III. TROUBLE SHOOTING ....................................................................................... 7
Inhaltszusammenfassung zur Seite Nr. 2
2. Be certain to install electrical controls (e.g., on/off switches, timers, control systems, etc.) at least five (5) feet from the filter. This permits one to stand clear of the filter during system start up. 3. Allow sufficient clearance around the filter to permit visual verification that the clamp is properly installed around the tank flanges, see Figure A. a. Tap the clamp with a mallet or similar tool to ensure uniform loading during clamp tightening. Figure A. 4. Allow sufficient space a
Inhaltszusammenfassung zur Seite Nr. 3
If doubt exists as to the pressure to which the system will be subjected, install an ASME approved automatic Pressure Relief or Pressure Regulator in the circulation system for the lowest working pressure of any of the components in the system. SECTION II. FILTER OPERATION AND CLEANING WARNING THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM (e.g., FILTER LID, PUMP, FILTER, VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED. PRESSURIZED A
Inhaltszusammenfassung zur Seite Nr. 4
3. The pressure gauge is the primary indicator of how the filter is operating. Maintain your pressure gauge in good working order. WARNING Your filter is a piece of machinery, do not tamper with it, attempt to disassemble it or otherwise adjust it unless you fully understand it's operation. Serious injury or death can occur if the equipment is improperly handled. Consult a pool service professional for maintenance and service assistance. 4. Clean your filter when pressure reads between 8-10 p.s.
Inhaltszusammenfassung zur Seite Nr. 5
Inhaltszusammenfassung zur Seite Nr. 6
1. Turn the pump off, shut off any automatic controls to ensure that the system is not inadvertently started during servicing. 2. Open the filter High Flow™ manual air relief valve (and the waste drain valve or plug, if your system has one). 3. Remove hair and lint strainer pot lid and clean basket. Replace basket and secure lid. 4. Disconnect air relief valve drain hose if installed. 5. Release tank clamp assembly and remove tank lid. 6. Remove top manifold and cartridge element separate
Inhaltszusammenfassung zur Seite Nr. 7
13. Replace tank top and carefully follow instructions in Section B, Clamp Installation Instructions. 14. Replace drain plug and reinstall air relief valve drain hose if used. E. REPLACING FILTER CARTRIDGES Filter cartridge element life will vary with pool conditions such as bather load, wind, dust, etc. You can expect an average cartridge life of 3 years under normal conditions. 1. To replace cartridge element follow steps in Section D, Cleaning Filter, eliminating step D.7. F. CLEANING THE HIG
Inhaltszusammenfassung zur Seite Nr. 8
B. Until the water initially put into the pool has been completely filtered, short filter cycles in between cleanings are normal. In most cases pool owners are dismayed by the undesirable color and appear- ance of water in a newly filled pool. Plaster dust can be responsible for short filter cycles, requiring frequent cleaning. C. If pressure drops on gauge, check skimmer basket and pump basket first for debris. If the baskets are clean, shut off power to pump and turn off any automatic controls
Inhaltszusammenfassung zur Seite Nr. 9
SECTION IV. TECHNICAL DATA A. FLOW RATES Pressure loss vs. Flow 8 7 6 5 4 3 2 1 0 0 102030 405060708090 100 110 120 130 150 Flow (gpm) Clean and Clear Plus Cartridge Filter Series - All models Clean & Clear Plus Cartridge Filters Recommended Flow Rate Fs low Rate GPM Turnover Capacity in Gallon Filter Area Vertical* P# roduct # Model sq. ft. Clearance R. es.Cs omm6s hour8s hour 12 hour 10 60310C0 CP24 2. 4 50 6 in 909030 2,4040 3,20 64,80 10 60340C0 CP32 3. 2 60 2 in 10 2 10 2 40 3,2050 7,60 86
Inhaltszusammenfassung zur Seite Nr. 10
Inhaltszusammenfassung zur Seite Nr. 11
B. CLEAN & CLEAR PLUS TANK ASSY., contd. Replacement Parts Item No. Part No. Description Item No.Part No. Description 1 53003201 Gauge, pressure, ¼ in. 12 195610 Washer, small I.D. 2 98209800 High Flow™ manual air relief valve 12a 195611 Washer, large I.D. (HFMARV) 13 194997 Nut, machined 3 98201200 Hose and retainer clips for 13a 195612 Spring HFMARV (Optional accy.) 14 55035000 Baffle, bulkhead assy. 4 56636900 Spring, compression Ê 14 190039 Baffle, bulkhead assy. 4 178616 Spring, compress
Inhaltszusammenfassung zur Seite Nr. 12
Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 P/N 178558 12 REV. J 6-27-03
