Resumen del contenido incluido en la página 1
R53S and R53A Recycling Mower
with Auto-drive, ES, and VS
Code 448E, 449E
Serial No. 290000101 and Up
Manual Part No. 1 1 1-2842 Rev B
Resumen del contenido incluido en la página 2
mo wing conditions . Cor rect operation and maintenance will ensure a long and satisfactor y ser vice life . Prior to Introduction despatc h from our factor y ev er y effor t is made to ensure that y our mo w er is deli v ered in perfect condition. T hank y ou for purc hasing a Ha yter mo w er . T he T hroughout this handbook all references to left and follo wing pag es are designed to help y ou g ain safe and right are as view ed from behind the handlebar , in the efficient ser vice from y our
Resumen del contenido incluido en la página 3
Contents Safety Impr oper l y using or maintaining this mo w er can Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 r esult in injur y . T o r educe the potential f or injur y , Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 compl y with these safety instr uctions. General La wn Mo w er Saf
Resumen del contenido incluido en la página 4
• If petrol is spilled, do not attempt to star t the engine – Ex ercise extreme caution when on slopes . but mo v e the mo w er a w a y from the area of spillag e – Mo w across the face of slopes , nev er up and and a v oid creating any source of ignition until petrol do wn and ex ercise extreme caution when v apors ha v e dissipated. c hanging direction on slopes . • R e place all fuel tank and container caps securely . – Alw a ys be sure of y our footing on slopes . • R educe speed on slopes a
Resumen del contenido incluido en la página 5
• R e place faulty silencers . 90 dB A, based on measurements of identical mac hines per EN ISO 11201 and EN 836. • If the fuel tank has to be drained, do this outdoors . • Do not c hang e the engine g o v er nor settings or Sound Power o v erspeed the engine . Operating an engine at ex cessi v e speed can increase the hazard of personal Code 448E: T his unit has an equi v alent contin uous injur y . A-w eighted sound po w er lev el of 98 dB A, based on • Be careful during adjustment of the la w
Resumen del contenido incluido en la página 6
1 12-8760 1. Thrown object hazard—keep bystanders a safe distance from the machine. 2. Cutting/dismemberment of hand or foot—stay away from moving parts. 108-0992 1. Read the Operator ’ s 4. Install the fuse. Manual. 2. Remove the fuse box 5. Replace the fuse box decal. cover . 3. Remove the fuse box 6. Start the engine. cover . 1 14-2820 1. W arning—read the 4. Cutting/dismemberment Operator ’ s Manual . hazard of hand or foot, cutterblade—stay away 108-7450 from moving parts. (Model 448E only)
Resumen del contenido incluido en la página 7
Setup Important: R emo v e and discard the pr otecti v e plastic sheet that co v er s the engine. Unfolding the Handle 1. Mo v e the handle rearw ard and hold the upper handle in place ( Figure 2 ). Figure 4 2. Slo wl y pour oil into the oil fill tube until the oil lev el reac hes the Full line on the dipstic k ( Figure 4 ). Do Figure 2 not o v erfill. (Max. fill: 0.6 l, type: SAE 30 deterg ent oil) 2. Tighten the upper handle knob as tight as y ou can Note: If y ou o v erfill the engine , pour
Resumen del contenido incluido en la página 8
2. Install the fuse ( Figure 6 ). Figure 7 Important: Use onl y the charger supplied with the mo w er . 2. Connect the c harg er plug to the mains electricity supply and c harg e it for 24 hour s . Figure 6 3. Disconnect the c harg er plug from the mains electricity supply . Note: Y our mo w er comes with a fuse in y our 4. Disconnect the c harg er from the mo w er wire o wner’ s pac k et. har ness . 3. Install the batter y co v er with the 2 screws that y ou W hen the batter y no long er holds
Resumen del contenido incluido en la página 9
Install the Mulch Plug or Grass Bag Y ou m ust cor rectly install the m ulc h plug (for m ulc hing or side-disc harging) or the g rass bag (for bag ging), or the engine will not star t . T he mo w er has a safety switc h, located at the bottom of a c hannel on the top , right rear of the mo w er , that prev ents the mo w er from operating without a m ulc h plug or g rass bag . T his prev ents the mo w er from thro wing debris at the operator through the rear c hute . F or the switc h to detect t
Resumen del contenido incluido en la página 10
Product Overview Operation Filling the Fuel T ank Unleaded petr ol is extr emel y flamma ble and explosi v e. A fir e or explosion fr om unleaded petr ol can bur n y ou and other s. • T o pr ev ent a static charge fr om igniting the unleaded petr ol, place the container and/or mo w er dir ectl y on the g r ound bef or e filling , not in a v ehicle or on an object. • Fill the tank outdoor s when the engine is cold. W ipe up spills. Figure 13 • Do not handle unleaded petr ol when 1. Cutting height
Resumen del contenido incluido en la página 11
Note: T o raise the mo w er , mo v e all 4 cutting height Checking the Engine Oil Level lev ers forw ard; to lo w er the mo w er , mo v e them all Ser vice Inter v al : Before eac h use or daily rearw ard. 1. R emo v e the dipstic k, wipe it clean, and fully install the dipstic k ( Figure 17 ). Figure 18 Adjusting the Upper Handle Height Y ou ma y raise or lo w er the upper handle to a position comfor table for y ou. Figure 17 Note: Y ou cannot raise the upper handle higher than the angle of the
Resumen del contenido incluido en la página 12
Figure 20 Figure 22 3. Tighten the upper handle knob as tight as y ou can ( Figure 21 ). Figure 23 2. Hold the engine stop lev er ag ainst the handle and immediately star t the engine using either the ignition Figure 21 k ey or the recoil star ter (Figure 24 ). Starting the Engine Important: T he mo w er has a safety s witch that pr ev ents y ou fr om star ting the mo w er unless y ou fir st install the mulch plug or the g rass ba g secur el y on the mo w er . 1. Install the m ulc h plug ( Figur
Resumen del contenido incluido en la página 13
T raveling Forward T o operate the auto-dri v e , simply w alk with y our hands on the upper handle and y our elbo ws at y our sides , and the mo w er will automatically k ee p pace with y ou ( Figure 25 and Figure 26 ). G009647 Figure 27 Figure 25 Mulching the Clippings If the g rass bag is on the mo w er , remo v e it (refer to R emo ving the Grass Bag) before m ulc hing the clippings . If the side disc harg e c hute is on the mo w er , remo v e it and loc k the side disc harg e door (refer to
Resumen del contenido incluido en la página 14
Note: T he lo w er rope guide releases the star ter Collecting Grass rope when y ou pull the recoil star t handle . Use the g rass bag when y ou w ant to collect g rass and 3. Inser t the g rass bag handle into the g roo v es at the leaf clippings from the la wn. top of the mo w er (Figure 31 ). If the side disc harg e c hute is on the mo w er , remo v e it Important: T he mo w er has a safety s witch that and loc k the side disc harg e door (refer to R emo ving the pr ev ents y ou fr om star ti
Resumen del contenido incluido en la página 15
Installing the Side Discharge Chute 1. Unloc k the side disc harg e door (Figure 35 ). Figure 35 Figure 33 2. Lift open the side disc harg e door (Figure 36 ). 3. Inser t the m ulc h plug ( Figure 34 . Figure 36 3. Install the side disc harg e c hute and close the door onto the c hute ( Figure 37 ). Figure 34 Side-discharge Use the side disc harg e for cutting v er y tall g rass . If the bag is on the mo w er , remo v e it and inser t the m ulc h plug (refer to R emo ving the Grass Bag) before F
Resumen del contenido incluido en la página 16
Removing the Side Discharge Chute set the front wheels at 51 mm and the rear wheels at 64 mm. T o remo v e the side disc harg e c hute , rev erse the ste ps abo v e . Cutting Leaves Important: Lock the side discharge door after y ou • After cutting the la wn, ensure that half of the la wn close it ( Figur e 38 ). sho ws through the cut leaf co v er . Y ou ma y need to mak e more than one pass o v er the lea v es . • If there are more than 130 mm of lea v es on the la wn, set the front cutting he
Resumen del contenido incluido en la página 17
Maintenance Note: Deter mine the left and right sides of the mac hine from the nor mal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval After the first 5 hours • Change the engine oil. • Check the engine oil level. • Ensure that the engine stops within 3 seconds after releasing the engine stop lever . Before each use or daily • Clean grass clippings and dirt from under the mower . • Replace the air filter; replace it more frequently in du
Resumen del contenido incluido en la página 18
Lubrication Lubricating the Wheel Gears Ser vice Inter v al : Y early 1. R emo v e the wheel bolt in the center of eac h r ear wheel and remo v e the rear wheels . Figure 42 2. Apply engine oil to the inner and outer sides of the g ear as sho wn in Figure 40 . Figure 40 3. Install the rear wheels . Lubricating the Upper Handle Ser vice Inter v al : Y early Lubricate the left and right sides of the upper handle with a lo w-viscosity silicone spra y lubricant yearly or as needed. 1. Spra y the out
Resumen del contenido incluido en la página 19
Engine Maintenance Replacing the Air Filter Ser vice Inter v al : Ev er y 25 hours R e place the air filter yearly; re place it more frequently in dusty operating conditions . R efer to Pre paring for Maintenance . 1. Use a screw dri v er to open the air filter co v er ( Figure 43 ). Figure 45 3. Tip the mo w er onto its side , with the air filter up , to drain the used oil out through the oil fill tube Figure 43 (Figure 46 ). 2. R e place the air filter ( Figure 44 ). Figure 44 Figure 46 3. Ins
Resumen del contenido incluido en la página 20
Electrical System Maintenance Charging the Battery Ser vice Inter v al : Y early or before storag e R efer to Charg e the Batter y in the Setup section. Replacing the Fuse If the batter y does not c harg e or the engine does not tur n with the electric star ter , the fuse ma y be blo wn. R e place it with a 40-amp plug-in type fuse . R efer to Figure 47 Install the Fuse in the Setup section. 5. Install the dipstic k securely . 6. Dispose of the used oil properly at a local recycling center . 20
