ページ1に含まれる内容の要旨
AP400
10" Contractors Saw
(Model 36-978/36-979)
One H.P. Single-
Stage Dust
Collector
Dépoussiéreur
à étage unique
de 1 HP
Colector de polvo
monoetápico de
un H.P.
Instruction Manual
Manuel d’Utilisation
Manual de Instrucciones
FRANÇAIS (15) ESPAÑOL (27)
www.deltamachinery.com
A15097 - 01-13-06
Copyright © 2006 Delta Machinery (800) 223-7278 - US
(800) 463-3582 - CANADA
ページ2に含まれる内容の要旨
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SAFETY GUIDELINES - DEFINITIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 GENERAL SAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ADDITIONAL SPECIFIC
ページ3に含まれる内容の要旨
SAFETY GUIDELINES - DEFINITIONS It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used to help you recognize this information. Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Indicates a potentially haz ard ou
ページ4に含まれる内容の要旨
GENERAL SAFETY RULES Failure to follow these rules may result in serious personal injury. 1. FOR YOUR OWN SAFETY, READ THE INSTRUCTION 14. USE THE PROPER EXTENSION CORD. Make sure MANUAL BEFORE OPERATING THE MACHINE. your extension cord is in good condition. When using Learning the machine’s application, limitations, and an extension cord, be sure to use one heavy enough to specific hazards will greatly minimize the possibility carry the current your product will draw. An undersized of accid
ページ5に含まれる内容の要旨
ADDITIONAL SPECIFIC SAFETY RULES Failure to follow these rules may result in serious personal injury. DO NOT USE THIS UNIT TO FILTER 7. DO NOT USE THE DUST COLLECTOR to pick METAL DUST. Combining wood and up flammable liquids such as gasoline. Do not use metal dust can create an explosion or the dust collector near flammable or combustible fire hazard. This unit is intended to filter liquids. Explosion and/or fire can occur. non-explosive atmospheres only. 8. KEEP ARMS, HANDS, AND FINGERS
ページ6に含まれる内容の要旨
POWER CONNECTIONS A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and matching receptacle which will accept the machine’s plug. Before connecting the machine to the power line, make sure the switch (s) is in the “OFF” position and be sure that the electric current is of the same
ページ7に含まれる内容の要旨
3. 240 VOLT SINGLE PHASE OPERATION GROUNDED OUTLET BOX The motor supplied with your machine is a dual CURRENT voltage, 120/240 volt motor. It is shipped ready- CARRYING to-run for 120 volt operation. However, it can be PRONGS converted for 240 volt operation. A qualified electrician should do the conversion, or the machine can be taken to an Authorized Delta Service Center. When completed, the machine must conform to the National Electric Code and all local codes and ordinances. GROUNDIN
ページ8に含まれる内容の要旨
FUNCTIONAL DESCRIPTION FOREWORD The Delta AP400 will connect to woodworking machines that accept a 4" diameter hose. The Model AP400 comes with two 30 micron collection bags, and a 4" x 5 ft. collection hose. NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in the manual are representative only and may not depict the actual labeling or accessories included. These are intended to illustrate technique only. CARTON CONTENTS 12 56 1
ページ9に含まれる内容の要旨
UNPACKING AND CLEANING Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol. Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine. After cleaning, cover the unpainted surfaces with a good quality household floor paste wax. ASSEMBLY For your own safety, do not
ページ10に含まれる内容の要旨
SIDE SUPPORTS A 1. Place the dust collector base (A) Fig. 5, in an upright B position as shown. 2. Align the two holes in the wider end of the side support (B) Fig. 5 with the two holes (C) in the C base. 3. Insert a 5/16-18x3/4" hex head screw (A) Fig. 6 thru each hole in the side support and base. Fig. 5 4. Place a 5/16" lockwasher onto the hex head screw. 5. Thread a 5/16-18 hex nut onto the hex head screw and tighten securely. 6. Repeat this process for the remaining side support. 7. Fi
ページ11に含まれる内容の要旨
SUPPORT 1. Place the support (A) Fig. 10 inside the two side supports (B). NOTE: MAKE SURE SUPPORT IS ATTACHED TO THE SIDE SUPPORTS CLOSEST TO THE MOTOR. 2. Align the four holes in the support with the four holes in the side supports as shown in Fig. 10. 3. Insert a 5/16-18x3/4" hex head screw (A) Fig. 11, thru the side supports and the support. 4. Place a 5/16" lockwasher on the hex head screw. 5. Thread a 5/16-18 hex nut on the hex head screw and tighten securely. Fig. 9 6. Repeat this
ページ12に含まれる内容の要旨
FILTER AND DUST COLLECTION C BAGS TO DRUM A B 1. Thread a 5/16-18 hex nut (A) Fig. 13, onto the end of bag support rod (B). Thread rod into hole (E) and tighten nut (A) against motor assembly to hold support rod (B) upright. Height of support rod can be adjusted after the filter bag is in place. The hook in the support rod (B) should be positioned over the drum. This can be accomplished by rotating the support rod until the hook is positioned over the E drum (C) Fig. 13. Fig. 13 B 2. Ho
ページ13に含まれる内容の要旨
DUST INTAKE HOSE TO MOTOR AND BLOWER ASSEMBLY E C Disconnect machine from power source A before connecting or disconnecting an air intake hose to or from the blower and motor assembly. The dust collector is supplied with a 4" flexible dust intake hose. Place the intake cap holder (E) on the dust collector as shown in Fig. 17. NOTE: DO NOT COVER THE INTAKE PORT WITH THE INTAKE CAP WHEN ATTACHING THE HOSE TO THE INTAKE PORT. Fig. 17 To assemble the dust collection hose to the motor and b
ページ14に含まれる内容の要旨
When using this dust collector, do not pick up anything that is burning, smoldering or smoking, such as matches, cigarettes, or hot ashes. Do not use to vacuum combustible explosive materials, such as coal, grain or other finely divided combustible material. Do not use to vacuum hazardous, toxic, or carcinogenic materials such as asbestos, pesticide or lead-based paint debris. TROUBLESHOOTING For assistance with your machine, visit our website at www.deltamachinery.com for a list of service
ページ15に含まれる内容の要旨
FRANÇAIS 15
ページ16に含まれる内容の要旨
LES INSTRUCTIONS IMPORTANTES DE SURETE Lire et comprendre toutes instructions d'avertissements et opération avant d'utiliser n'importe quel outil ou n'importe quel équipement. En utilisant les outils ou l'équipement, les précautions de sûreté fondamentales toujours devraient être suivies pour réduire le risque de blessure personnelle. L'opération déplacée, l'entretien ou la modification d'outils ou d'équipement ont pour résultat la blessure sérieux et les dommages de propriété. Il y a de cer
ページ17に含まれる内容の要旨
RÈGLES DE SÉCURITÉ GÉNÉRALES L’inobservation de ces règles peut conduire à des blessures graves. 1. POUR SA SÉCURITÉ PERSONNELLE, LIRE LA NOTICE calibre suffisant pour l’alimentation nécessaire à la machine. Un D’UTILISATION, AVANT DE METTRE LA MACHINE EN cordon d’un calibre insuffisant entraînera une perte de tension MARCHE, et pour aussi apprendre l’application et les limites de d’où une perte de puissance et surchauffe. Voir le tableau sur la machine ainsi que les risques qui lui sont par
ページ18に含まれる内容の要旨
RÈGLES DE SÉCURITÉ SPÉCIFIQUES SUPPLÉMENTAIRES 7. NE PAS UTILISER LE DÉPOUSSIÉREUR pour ramasser L’inobservation de ces règles des liquides infl ammables comme l’essence. Ne pas utilis- peut conduire à des blessures graves. er le dépoussiéreur près de liquides infl ammables ou com- bustibles. Cela peut se solder par une explosion et/ou un NE PAS UTILISER CET APPAREIL incendie. POUR FILTRER LA POUSSIÈRE DE MÉTAL. La combinai- 8. ÉLOIGNER LES BRAS, MAINS, ET DOIGTS DU VENTI- son de poussières
ページ19に含まれる内容の要旨
RACCORDEMENTS ÉLECTRIQUES Un circuit électrique séparé doit être utilisé pour les machines. Les fils de ce circuit doivent être au moins de calibre 12. Ce circuitdoit être protégé par un fusible temporisé de 20 A. Si on utilise un cordon prolongateur, ce cordon doit être à trois fils, avoir unefiche à trois broches et une prise de courant à trois cavités, mise à la terre qui correspond à la fiche de la machine. Avant debrancher la machine, s’assurer que l’interrupteur (les interrupteurs) se t
ページ20に含まれる内容の要旨
3. FONCTIONNEMENT MONOPHASÉ À 240 VOLTS GROUNDED OUTLET BOX CURRENT Le moteur fourni avec la machine est un moteur biten- CARRYING sion de 120/240 volts. Il est livré, prêt à fonctionner, PRONGS sous tension de 120 volts. Toutefois, il peut être con- verti au fonctionnement sous 240 volts. Un électricien professionnel devrait effectuer la conver- sion ou utiliser les services d’un centre de réparations agréé Delta. Suite à la conversion, la machine doit être conforme au Code électrique nation
