Heath Zenith Replacement Motion Sensor P6036の取扱説明書

ページ1に含まれる内容の要旨

TEST
ON-TIME
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
10 51 TEST
Replacement
AUTO
ON-TIME
Motion Sensor Put the ON-TIME switch in the 1,
5, or 10min ute position.
ModelP6036
10 5 1 TEST
MANUAL MODE
Features
• Turns on lightingwhen motion is detected.
Manual mode only works at night
• Automaticallytur nslighting off.
because daylight returns the sen-
• Photocell keeps the lighting off during daylight
sor toA

ページ2に含まれる内容の要旨

❒ After screwing the sensor into the wall plate, INSTALLATION connect the junction box wires to the Light For under eave installation, the sensor head Control wires by twisting together and securing must be rotated as shown in the next two steps with wireconnectors . for proper operation and to avoid the risk of elec- tricalshoc k. Red Sensor Wire to BlackLamp Wire Whiteto White For eavemount only: Junction ❒ Swing the sensor head

ページ3に含まれる内容の要旨

❒ Loosen the clamp screw Clamp TEST AND ADJUSTMENT in the sensor ball joint and Screw ❒ Turn on the circuit breaker and light gently rotate the sensor. switch. ❒ Walk through the cover- Ball 1 NOTE: Sensor has a 1 /2 minute calibration age area noting where Joint period before it will detect motion. When you are when the lights 1 first turned on, wait 1 /2 minutes. turn on (also, the LED will flash several times when ❒ Turn the RANGE control to the mid position and motion is detected)

ページ4に含まれる内容の要旨

TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE Lights will not 1. Light switch is turnedoff . Lights stay on 1. A lamp is positioned too close to the sen- come on. 2. Lightis looseor burned out. continuously. sor or pointed at nearby objects that cause 3. Fuse is blown or circuit breaker is turned heat to trigger the sensor. (Reposition the off. lamp away from the sensor or nearby . Daylight turn-off is in effect (recheck objects