ページ1に含まれる内容の要旨
06/01/08
UNPACKING AND PACKING THE HT-7450 FOR SHIPPING
HT-7450
SERVICE LEVEL: 2
CAUTION! You will need at least two people to complete this procedure, as the chair is very heavy.
Be sure you have enough people to lift and move the chair, to prevent injury.
NOTE: Save all packaging materials - you will need them to package the existing HT-7450 properly
for shipping back to Human Touch.
UNPACKING THE CHAIR
1. Open the top box flaps, then lift up on the flaps to pull the box sides up and off t
ページ2に含まれる内容の要旨
PACKING THE CHAIR FOR SHIPPING BEFORE YOU START: CAUTION! You will need at least two people to complete this procedure, as the chair is very heavy. Be sure you have enough people to lift and move the chair, to prevent injury. You will need the following packaging materials to complete this procedure. List of components for packing (Fig.2): Box shell (1) Box base (1) Remote control Rear- - -end end end f f foam oam spac spacer er (1) (1) Plastic bag (2) box (1) Backrest f f foam oam spac spa
ページ3に含まれる内容の要旨
1. Fully retract the foot and calf massager, remove the head pillow, then remove the backrest from the chair base (see Use and Care manual for assembly instructions). 2. Place the box base on the floor with several feet of clearance on all sides (Fig.3). 3. Using two people, gently lift the chair onto the chair base, placing the rear-end of the chair base onto the foam supports and the footrest in front of the supports. 4. Insert the foam spacer between the footrest and the chair base, with
ページ4に含まれる内容の要旨
8. Insert the backrest into one of the large protective plastic bags. 9. Place the backrest onto the chair base face-up, with the top of the backrest located over the footrest Fig.6). 10. Insert the head pillow into the small plastic bag and place it on top of the backrest. 11. Place the front-end foam spacer at the front of the chair (Fig. 7). Backrest face-up Front-end f f foam oam spac spacer er Footrest (Fig.6) (Fig.7) 4
ページ5に含まれる内容の要旨
12. Place the rectangular cardboard and foam spacer on top of the backrest, with the foam facing down and aligned with the foam on the front-end spacer (Fig.8). 13. Slide the box sides gently over the chair, ensuring that all packaging material stays in place (Fig.9). (Fig.8) (Fig.9) 5
ページ6に含まれる内容の要旨
14. Insert the corner spacers into each corner (Fig.10). 15. Fold the top flaps down and secure the box using shipping bands (Fig.11). (Fig.10) (Fig.11) Please send any questions or comments regarding these instructions to: documentation@humantouch.com ® © 2008 Human Touch , LLC. 6
