Human Touch Massage Chairの取扱説明書

ページ1に含まれる内容の要旨

06/01/08

REPLACING THE BACKREST
H T - 7 4 5 0
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 2
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: 5/32" (4mm) Allen key, Phillips-head screwdriver.
NOTE: SAVE SCREW KNOBS FOR USE DURING REASSEMBLY.
REMOVE THE BACKREST FRO

ページ2に含まれる内容の要旨

INSTALL THE BACKREST ONTO THE CHAIR BASE 1. Align the guides on the lower sides of the backrest with the track on the chair base, then slide the backrest firmly onto the chair base (Fig.3). 2. From the bottom of the backrest, install and hand tighten the two screw knobs. Verify that the two screw knobs are installed and tightened before using the chair. 3. Connect all cables that connect the backrest to the left-hand side of the chair base (Fig.4). Backrest Chair base Screw knob (Fig.4) (Fig.3)