Clam Corp Fish Trap Voyager Special 8208の取扱説明書

ページ1に含まれる内容の要旨

Model No.

-8208-

Specifications
H e ig h t - 72 inches
▪
Length - 93 inches
▪
W i d t h - 72 inches
▪
Weight - 120 lbs.
▪
p/n 108208

Instruction No. 101930































- Clam Customer Service Information -

NOTICE!! - ONCE USED, THIS SHELTER CANNOT BE RETURNED TO THE STORE. IF YOU HAVE
A WARRANTY CLAIM, PLEASE CONTACT CLAM CORP. CUSTOMER SERVICE BY EMAIL
INQUIREY OR DIRECT BY CALLING:

■ Customer Service Hrs: - 9am to 4pm

ページ2に含まれる内容の要旨

- Bill of Materials - 2

ページ3に含まれる内容の要旨

- Assembly Diagram - 3

ページ4に含まれる内容の要旨

- Step One - 4

ページ5に含まれる内容の要旨

- Step Two - 5

ページ6に含まれる内容の要旨

- Step Three - 6

ページ7に含まれる内容の要旨

- Step Four - 7

ページ8に含まれる内容の要旨

- Step Five - Note: Actual Canopy Bracket configuration may vary If your Canopy Brackets have four holes near the upper angled edge rather than three hole configuration shown, use the A,B, & D locations stamped on the four hole bracket. Seating has be omitted for clarity 8

ページ9に含まれる内容の要旨

- Step Six - Slide the Canopy Hoop Poles onto the Canopy Poles until the spring buttons engage the holes near the ends of each Canopy Hoop Pole. Support the first Canopy Hoop Pole as pictured with the Rear Adjustable Spreader Poles (the shorter of the two provided lengths). Lean the two remaining Canopy Hoop Poles against the first. Note: Seating has be omitted for clarity 9

ページ10に含まれる内容の要旨

- Step Seven - Drape the Tent over the supported hoops then go inside and spread out the Canopy Hoop Poles, attaching the Roof Velcro as you go. Orient the Porch Hoop Pole so that the holes face upward and then feed the length of the pole through the three Porch Hoop Sleeves sewn on the Tent. Slide the Porch Hoop Pole onto the Porch Poles, engaging the third hole position. Attach the Porch Hoop Velcro on each side of the Tent. Remove the Rear Adjustable Spreader Poles now supporti

ページ11に含まれる内容の要旨

- Step Eight - To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed, the Porch Hoop Pole will lightly touch the floor. To achieve this condition, start by finding the center of the Molding. From behind the unit, pull the midpoint of the Tent downward and fold the Tent material under the lip of the Base. Then press the midpoint

ページ12に含まれる内容の要旨

- License Holder - If Licensing is required in your area, locate a position on the outside of your tent that you wish to affix the License Holder. Next hold the License Holder in the determined position and use a sharp object to pierce two holes in the tent; going through the grommets of the License Holder. Place the included Snap Buttons through the pierced holes and through the License Holder grommets. Push the Buttons together firmly to secure the holder in place.