ページ1に含まれる内容の要旨
Installing the Desktop Stand
ET 350 Monitor and ET 3250/55 Computers
Tool required
Intended Use
! Phillips No. 2 torque screwdriver
When properly installed using the materials provided,
and according to these instructions, the desktop stand is
Installing the desktop stand
intended to mount the ET 350 monitor and the
ET 3250/55 computers for use on desktop or other flat
The desktop stand is a three-piece assembly:
surface.
! Pivot plate with rubber foot attaches to the bottom
of the unit.
!
ページ2に含まれる内容の要旨
Installing the Desktop Stand 3M Dynapro ET 350 Monitor and ET 3250/55 Computers Attaching the mounting bracket Attaching the angle bracket 1. Thread one of each of the remaining four lock Use the knob provided to attach the angle bracket to washers through one of each of the remaining the mounting bracket. To adjust the viewing angle of four screws. the display up or down, slide the angle bracket up or down in the slot before tightening the knob. 2. Thread the screws and lock washers through
ページ3に含まれる内容の要旨
the period stated in the specification. 3M Touch Systems Copyright makes no additional warranties, express or implied, This manual is © 3M 2002. All rights reserved. including but not limited to any implied warranties of Reproduction of the contents of this copyrighted manual in merchantability or fitness for a particular purpose. whole or in part, by any means, electronic or mechanical, User is responsible for determining whether the 3M Touch for any purpose, without written permission of
ページ4に含まれる内容の要旨
Worldwide Manufacturing Plants 3M Touch Systems For more information on 3M touch products, visit 3M Optical Systems Division 3Mtouch.com or call toll-free 1-800-667-0374. Austin, Texas Methuen, Massachusetts 800 Carleton Court Annacis Island Milwaukee, Wisconsin New Westminster, BC Vancouver, BC, Canada Canada V3M 6L3 © 3M 2002 Abingdon, UK www.3Mtouch.com 13892 (Rev. 1.1)
