ページ1に含まれる内容の要旨
Mac Pro
PCIe Fan
Replacement Instructions
Note: Follow these instructions carefully. Failure to do so could damage your equipment and
First Steps
void its warranty.
1 Shut down computer.
2 Wait 10 minutes.
Warning: Parts inside
computer can be very
hot. Allow computer
to cool down before
continuing.
3 Unplug all external
cables except power
cord.
4 Touch metal PCI cover
on back of computer.
5 Unplug power cord.
Opening the
Computer
1 Hold side access
panel and lift latch on
back of
ページ2に含まれる内容の要旨
Required Tool Phillips #2 screwdriver Removing the Installed PCIe Fan Before you can remove the PCIe fan, you must remove the hard drive in the far-left drive bay. 1 Make sure latch on back panel is up, so that drive is unlocked. 2 Pull hard drive out of drive bay. 3 Locate PCIe fan. © 2009 Apple Inc. All rights reserved. 073-1252 Rev. A 2
ページ3に含まれる内容の要旨
4 Remove 2 screws. 5 Slide fan up and out of computer. Installing the Replacement Fan 1 Slide fan into enclosure so that fan tabs engage with slots on metal cage. 2 Press down until fan clicks into place in connector. 3 Replace 2 screws. 4 Replace hard drive in far-left drive bay. © 2009 Apple Inc. All rights reserved. 073-1252 Rev. A 3
ページ4に含まれる内容の要旨
Closing the Computer 1 Replace access panel. Note: Make sure latch is up before you replace panel. If latch is down, panel will not seat correctly. 2 Push latch down to close and secure access panel. Warning: Never turn on computer unless all its internal and external parts are in place and it is closed. Operating computer when open or missing parts can cause damage or injury. Apple Inc. © 2009 Apple Inc. All rights reserved. This document is protected under U.S. Copyright Law a
