Summary of the content on the page No. 1
ZyWALL 10W
Internet Security Gateway
Quick Start Guide
Version 3.60
December 2002
Summary of the content on the page No. 2
ZyWALL 10W Internet Security Gateway Hardware Installation Rear Panel and Connections Connect a Reset to grounded default Turn off your ZyWALL. wire to configuration Connect to Remove the protective ground the file. See User’s your cable/DSL cover plate from the slot ZyWALL. modem. and insert an optional Guide. PCMCIA wireless LAN card into the slot. Use a Y-cable to connect Never force, bend or twist your administration the wireless LAN card Connec
Summary of the content on the page No. 3
ZyWALL 10W Internet Security Gateway Internet Account Checklist Your ISP (Internet Service Provider) should have given you most of the following information. You do not need to fill in every blank. REQUIRED INFORMATION Your device’s WAN IP Address (if given): __________________ DNS Server IP Address (if given): Primary __________________, Secondary _________________ Encapsulation: Service Type: _______________________ Ethernet Login Server IP Address: ______________ User Na
Summary of the content on the page No. 4
ZyWALL 10W Internet Security Gateway 5. The Internet Protocol TCP/IP Properties screen opens (the General tab in Windows XP). -To have your computer accept a dynamic IP address, click Obtain an IP address automatically. -If you want a static IP address, click Use the following IP Address and fill in the IP address (192.168.1.2 to 192.168.1.254), Subnet mask (255.255.255.0), and Default gateway (192.168.1.1) fields. Click Advanced. Remove any previously installed gateways in the IP Setting
Summary of the content on the page No. 5
ZyWALL 10W Internet Security Gateway Procedure For Web Configurator Configuration 1. Make sure your computer IP address and the ZyWALL IP address are on the same subnet. Refer to the TCP/IP section in your User’s Guide. 2. Launch your web browser and enter “192.168.1.1” as the URL. 3. Enter "1234" (default) as the password and click Login. In some versions, the default password appears automatically - if this is the case, just click Login. You should see a screen asking you to chan
Summary of the content on the page No. 6
ZyWALL 10W Internet Security Gateway Configuring for Internet Access Configuration Using Web Configurator Wizard 1. Click Wizard Setup in the main menu. Follow the online instructions to configure the first wizard setup screen and click Next. 2. Use the information in the previous Required Information table to enter the related fields in 3. In the following screen, repeat step 2 and click the following screen and click Next. Finish to complete the wizard setup. Configura
Summary of the content on the page No. 7
ZyWALL 10W Internet Security Gateway Activating the Wireless LAN The wireless LAN is disabled by default. Before you enable the wireless LAN you should configure some security, for example, setting MAC address filters and/or 802.1X security; otherwise your LAN will be vulnerable upon enabling it. Setting MAC filters Using the SMT Using the Web Configurator 1. Type 3 in the main menu and press ENTER. 1. Click ADVANCED in the main menu and then WIRELESS LAN. 2. Type 5 in Menu 3 – LAN S
Summary of the content on the page No. 8
ZyWALL 10W Internet Security Gateway Troubleshooting PROBLEM CORRECTIVE ACTION None of the LEDs turn Make sure that you have the correct power adapter connected to the ZyWALL and plugged on when you turn on the in to an appropriate power source. ZyWALL. If the error persists, you may have a hardware problem. In this case, you should contact your local vendor. Cannot access the Check the cable connection between the ZyWALL and your computer or hub. Refer to the ZyWALL from the LAN. Re
