Instrukcja obsługi Casio DQR-100U

Streszczenie treści zawartej na stronie nr. 1

WAVE
WAVE
UP(+)
UP(+)
MA0402-EB
Operation Guide DQR-100U
Main unit Sub-unit
1
AB C
°C/ °F RESET
SNZ
ON
OFF
SNZ
5 ON
ALM
OFF
ALM
TEMP.
CLEAR
MAX/MIN
°C/ °F RESET
RESET
SET
TEMP.
CLEAR
9
MAX/MIN
7
8
4 0
RESET
6
3
SET
2
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
2
Alarm Off Alarm On
Current time
(H

Streszczenie treści zawartej na stronie nr. 2

Operation Guide DQR-100U GENERAL GUIDE TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS • This clock is able to receive the time calibration signal transmitted from Main unit Rugby, England. Signal reception is possible within approximately 1,000 kilometers Rugby 1SNOOZE/LIGHT button 1,000 km of the transmitter. • Press this button to illuminate the display for about four seconds. • Even when the clock is within the reception range, signal reception is • Pressing this button while the alarm is soun

Streszczenie treści zawartej na stronie nr. 3

WAVE WAVE UP(+) UP(+) Operation Guide DQR-100U 2. While the screen you want is on the display, use the Alarm Time Set buttons (2) to change the digits that are USING THE CLOCK flashing. Any of the following procedures can be used to set current date and time. • Auto receive of the time calibration signal TEMP. CLEAR • Manual receive of the time calibration signal MAX/MIN Press + to increase Press — to decrease • Manual setting without using the time calibration signal the flashing digits. the f

Streszczenie treści zawartej na stronie nr. 4

Operation Guide DQR-100U USING THE LIGHT THERMOMETER FUNCTIONS Pressing the SNOOZE/LIGHT button (1) turns on the light and illuminates the display for easy reading in the Both the main unit and the sub-unit are equipped with their own temperature sensors. Temperature data measured dark. by the sub-unit is sent by wireless transfer to the main unit. This makes it possible to view both the indoor and outdoor temperature on the main unit display. Important! • Overuse of the light can shorten batter

Streszczenie treści zawartej na stronie nr. 5

Operation Guide DQR-100U • To clear the high temperature and low temperature data memory, press the CLEAR button (8). MAIN UNIT/SUB UNIT COMMUNICATION PRECAUTIONS New data starts to be stored after memory is cleared. Sub Unit Location • Certain environmental conditions can greatly reduce the communication range. • Avoid the following locations for the sub-unit. CLEAR button (8) Inside, among Inside a vehicle Near refrigerators Near a Near high-tension buildings, or near or other household constr