Manual do usuário Audiovox 5BLCR

Resumo do conteúdo contido na página número 1

Model 5BLCR &
5BLCRA
Programming Guide
The 5BLCR is designed to work with most Audiovox two way remote start unit
and may be programmed differently for other models. For the APS-55TW, the
recommended transceiver programming is shown below.
Note: A total of 4 transmitters may be programmed into any receiver channel.
1 Lock
2 Unlock
3 Remote Start/Stop
4 Option
The 5BLCRA is designed to work with most Audiovox two way alarm sys-
tems and may be programmed differently for other models. For the APS

Resumo do conteúdo contido na página número 2

As mentioned above, the program mode refers to a Keyless Entry unit which has no sounding device, you will note mention of a long chirp from the siren. This reference is for those who program this transmitter into a security system or into a unit with a sounding device. TO ENTER THE PROGRAM MODE: 1 Turn the ignition switch to the “ON” position. 2 Within 10 seconds, Press and release the valet/program switch three times. (Siren emits 1 short chirp indicating channel 1 has been entered) 3 Within 1

Resumo do conteúdo contido na página número 3

NOTE: If the program switch is operated again, the circuit will recycle through the program mode. In other words, press 1 time to access the lock function, 2 times to access the unlock function, 3 times to access the start function. When programming is complete, simply turn off the ignition switch to exit the program mode. ERASING TRANSMITTERS IF THEY HAVE BEEN LOST OR STOLEN: NOTE: Before you begin to erase the lost or stolen transmitter(s), have all transmitters available that you wish to r

Resumo do conteúdo contido na página número 4

2 Enter the transmitter program mode. Using any transmitter button press and hold until a long chirp is heard. If a single chirp or multiple chirps, (up to 7 chirps), are heard, the unit is indicating that the transmitter has already been programmed elsewhere in the receiver. Release the transmitter button and within 5 seconds press and hold until a long chirp is heard. This action forces the unit to erase all stored codes of that transmitter. The unit then exits the program mode the siren

Resumo do conteúdo contido na página número 5

3. Remove the discharged battery, making note of the location of the + and - contacts shown, and replace with a new type alkaline 1.5 volt AAA Battery. 4. Making note of the location of the (+) and (-) contacts, insert a new AAA battery alkaline 1.5 volt. 5. Replace battery cover being certain to close the battery case lock clip to prevent accidential opening. 5 128-6690 5 of 8

Resumo do conteúdo contido na página número 6

ORDER FORM FOR TRANSMITTER 5BLCR 5BLCRA Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment according to the instructions below. Specify 5BLCR ______ or 5BLCRA ______ 1) Name:___________________________________________ 2) Address:_________________________________________ 3) City:________________State:________Zip Code:__________ 4 Telephone Number:( )_____________________ 5) Total Nu

Resumo do conteúdo contido na página número 7

THIS PAGE LEFT BLANK INTENTIONALLY 7 128-6690 7 of 8

Resumo do conteúdo contido na página número 8

© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 11788 128-6690 8 128-6690 8 of 8