Краткое содержание страницы № 1
INSTALLATION and SERVICE INSTRUCTIONS
USE and CARE INSTRUCTIONS
A 1346 G
DUAL FUEL
COOKER
distributed by
DèLonghi
Pty Ltd
Краткое содержание страницы № 2
Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please keep this booklet in a safe place. It may be useful in future, either to yourself or to others in the event that doubts should arise relating to its operation. This appliance must be used only for the ta
Краткое содержание страницы № 3
FIRST TIME USE THE OVEN It is advised to follow these instructions: ■ Fit the wire racks as described at chapter “Use and care”. ■ Insert shelves and tray. ■ Switch on the empty oven on max to eliminate grease tracks from the heating elements. ■ Clean the interior of the oven with cloth soaked in water and detergent (neutral) then dry carefully. IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FOR USE OF ELECTRICAL APPLIANCES Use of any electrical appliance implies the necessity to follow a series of
Краткое содержание страницы № 4
IMPORTANT PRECAUTIONS AND RECOMMENDATIONS After having unpacked the appliance, check to ensure that it is not damaged. In case of doubt, do not use it and consult your supplier or a professionally qualified techni- cian. Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, etc.) should not be left around within easy reach of children, as these may cause serious injuries. ■ Do not attempt to modify the technical characteristics of the appliance as this may become dangerou
Краткое содержание страницы № 5
1 1 INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installation instructions. ■ This appliance shall only be serviced by authorized personnel. ■ This appliance is to be installed only by an authorised person. ■ Incorrect installation, for which the manufacturer accepts no responsibility, may cause personal injury of damage. ■ Always disconnect the cooker from mains power supply before carrying out any maintenance operations or repairs. ■ In the room where
Краткое содержание страницы № 6
FEEDER CABLE SECTION CONNECTING THE FEEDER type “H05RR-F” CABLE To connect the feeder cable to the cooker it is 2 230-240 V 3 x 6 mm (**) necessary to: 2 230 -240 V3 4 x 4 mm (**) ■ Remove the 6 screws that hold shield A 2 400 -415 V 3N 5 x 2,5 mm (**) behind the cooker. ■ Open completely the cable clamp D. 2 400 -415 V 2N 4 x 4 mm (**) ■ Position the U bolts onto terminal block (**) – Connection with wall box con- B (fig. 1.1 - 1.2). nection ■ Insert the feeder cable into the cable – Diversity
Краткое содержание страницы № 7
CLEARANCES ■ Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS 5601) Gas Installations code. ■ Installation shall comply with the dimension in Fig 1.3 bearing in mind that Overhead Clearances ■ In no case shall the clearances between the highest part of the cooker be less than 600mm or for an overhead exhaust fan 750mm. All other downward facing combustible surfaces less than 600mm above the cooker surface shall be prote
Краткое содержание страницы № 8
Rear and Side Clearances ■ Where the dimensions from the periphery of the nearest burner to any vertical combustible surface is less than 200mm the surface shall be protected in accordance with the standards to a height of not less than 150mm above the cooking surface for the full width or depth of the cooking surface ■ Where the dimensions from the periphery of the nearest burner to any horizontal combustible surface is less than 200mm, the horizontal surface shall be greater than 10mm below th
Краткое содержание страницы № 9
MOVING THE COOKER WARNING To move the cooker always ensure two people carry out this manoeuvre to prevent damage to the appliance (fig. 1.5). Figure 1.5 WARNING WARNING Be carefull: do not lift the cooker When moving cooker to its final posi- by the door handle (fig. 1.6). tion DO NOT DRAG (fig. 1.7). Lift feet clear of floor (fig. 1.5). Figure 1.6 Figure 1.7 9
Краткое содержание страницы № 10
BACKGUARD Before installing the cooker, assemble the backguard “C” (fig. 1.8). ■ The backguard “C” can be found packed at the rear of the cooker. ■ Before assembling remove any protective film/adhesive tape. ■ Assemble the backguard as shown in figure 1.8 and fix it by screwing the 5 screws “A”. Figure 1.8 C A 10
Краткое содержание страницы № 11
570.5 mm = = ANTI-TILT BRACKET ■ WARNING: In order to prevent accidental tièpping of the appliance, for example by a child climbing onto the open oven door, the stabilizing means must be installed. Please refer to instructions for installation. 1. The anti-tilt bracket has to be attached as shown on figure below, it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws (not supplied). 2. After fixing the anti-tilt bracket, slide cooker into place. Be sure the rear r
Краткое содержание страницы № 12
GAS SUPPLY: ■ The connection must be performed by an authorised person according to the rele- vant standards. ■ Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the gasket has been placed (figures 1.10a- 1.10b). Conical adaptor and gasket are supplied with the appliance (packed with conver- sion kit for use with Natural gas or Propane gas). ■ This appliance is suitable for use with Natural Gas or Propane gas. (Check the “gas ty
Краткое содержание страницы № 13
Figure 1.11 1. After connecting the gas supply, check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak, tighten or replace connections as appropriate. Warning: Do not use any naked flame to check for leaks. 2. Adjust the test point pressure or supply pressure to the value which is appropriate for the gas type. 3. The operation of the appliance must be tested when installation is completed. 4. Turn on the appliance gas controls and lig
Краткое содержание страницы № 14
CONVERSION PROCEDURE (to convert to LPG Propane) REPLACING THE INJECTORS This appliance is suitable for use with Natural gas or Propane gas (check the “gas type” sticker attached to the appliance). A label stating the type of gas used after replacing the injectors must be attached at the rear of the appliance, in proximity of the gas inlet connection. The nominal gas consumption and injector size details are provided in table at page 16. To replace the injectors proceed as follows: ■ Remove pan
Краткое содержание страницы № 15
MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas tap is turned quickly from the maximum to the minimum position. If the burner does not remain lit, increase the minimum gas rate setting. The procedure for adjusting the minimum gas rate setting is described below. ■ T
Краткое содержание страницы № 16
TABLE FOR THE CHOICE OF THE INJECTORS Natural gas Propane gas Test Point Pressure [kPa] 1.0 2.75 Injector Gas Injector Gas Orifice Dia. Consumption Orifice Dia. Consumption BURNER [mm] [MJ/h] [mm] [MJ/h] Auxiliary (A) 0.85 3.60 0.53 3.60 Semi-rapid (SR) 1.12 6.30 0.70 6.30 Rapid (R) 1.45 10.30 0.91 10.80 Triple ring (TC) 1.65 13.30 0.95 11.90 LUBRICATION OF THE GAS TAPS ■ If the gas tap becomes stiff, it is necessary to dismantle it carefully and clean it with petroleum spirit. Specialist hig
Краткое содержание страницы № 17
1 2 USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be con- sidered as inappropriate and therefore dangerous. ■ Do NOT place combustible materials or products on this appliance at any time. ■ Do NOT spray aerosols in the vicinity of this appliance while it is in use. GREASE FILTER (TOP RIGHT AND BOTTOM LEFT OVEN ONLY) ■ A special screen is provided at the back of t
Краткое содержание страницы № 18
USING THE TOP RIGHT AND THE BOTTOM LEFT OVEN FOR THE FIRST TIME (fig. 2.2) ■ Slide off the sliding shelves to the oven wall by unscrewing the 2 screws as in Fig. 2.4. The grill is secured to the rear wall of the oven on a hinge system that allows it to be lowered to allow proper access when cleaning the oven ceiling (fig. 2.3). ■ Clean the inside of the oven with a cloth soaked in water and neutral detergent and dry thoroughly. Figure 2.2 Figure 2.3 18
Краткое содержание страницы № 19
■ Assemble the sliding shelves on the oven wall as in Fig. 2.4.The sliding shelves facilitate the insertion and removal of shelves during cooking; they stop when pulled out to the maximum position. These shelves support all accessory trays and are dishwasher safe. ■ Slide in the grease filter on the back of the oven as in Fig. 2.1. ■ Position the shelf and tray as per Fig. 2.5. ■ Switch on the bottom left oven as described at page 35. ■ Switch on the top right oven as described at pages 39. Fig
Краткое содержание страницы № 20
USING THE TOP LEFT OVEN FOR THE FIRST TIME (fig. 2.6) ■ Clean the inside of the oven with a cloth soaked in water and neutral detergent and dry thoroughly. ■ Assemble the sliding shelves on the oven wall as in Fig. 2.7.The sliding shelves facilitate the insertion and removal of shelves during cooking; they stop when pulled out to the maximum position. These shelves support all accessory trays and are dishwasher safe. ■ Position the shelf and tray as per Fig. 2.8. ■ Switch on the oven as descr
