Краткое содержание страницы № 1
INSTALLATION and SERVICE INSTRUCTIONS
USE and CARE INSTRUCTIONS
DE 60 GW
DUAL FUEL COOKER
distributed by
DèLonghi
Pty Ltd
Краткое содержание страницы № 2
Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please keep this booklet in a safe place. It may be useful in future, either to yourself or to others in the event that doubts should arise relating to its operation. This appliance must be used only for the ta
Краткое содержание страницы № 3
USING THE OVEN FOR THE FIRST TIME You are advised to carry out the following operations: ■ Furnish the interior of the oven. ■ Switch the empty oven ON at maximum temperature for about two hours to eliminate traces of grease and smell from the components. ■ Disconnect the appliance from the electric power supply and clean the interior of the oven with a cloth soaked in water and neutral detergent and dry thoroughly. IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FOR USE OF ELECTRICAL APPLIANCES Use o
Краткое содержание страницы № 4
IMPORTANT PRECAUTIONS AND RECOMMENDATIONS After having unpacked the appliance, check to ensure that it is not damaged. In case of doubt, do not use it and consult your supplier or a professionally qualified technician. Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, etc.) should not be left around within easy reach of children, as these may cause serious injuries. ■ Do not attempt to modify the technical characteristics of the appliance as this may become dan- gerou
Краткое содержание страницы № 5
INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installation instruc- tions. ■ This appliance shall only be serviced by authorized personnel. ■ This appliance is to be installed only by an authorised person. ■ Incorrect installation, for which the manufacturer accepts no responsibility, may cause personal injury of damage. ■ Always disconnect the cooker from mains power supply before carrying out any maintenance operations or repairs. ■ In the room where th
Краткое содержание страницы № 6
CLEARANCES Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS 5601) Gas Installations code. Installation shall comply with the dimension in Fig. 1 bearing in mind that. Overhead Clearances In no case shall the clearances between the highest part of the cooker be less than 600 mm or for an overhead exhaust fan 750 mm. AII other downward facing com- bustible surfaces less than 600 mm above the cooker surface shall be protec
Краткое содержание страницы № 7
LEVELLING THE COOKER The cooker is equipped with 4 levelling feet and may be levelled by screwing or unscrewing the feet with a spanner (fig. 4). It is important to observe the prescriptions of figures 2a, 2b. Figure 2a Figure 3 0 + 8 mm Figure 2b Supplied with the cooker in a separate kit Figure 4 + 8 mm + 15 mm 7 U A O T
Краткое содержание страницы № 8
3 = = 75 Dotted line showing the position of ANTI-TILT BRACKET the cooker when installed Important! To restrain the appliance and pre- vent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tilt bracket. To fit the anti-tilt bracket: 1. After you have located where the cooker is to be positioned, mark on 0 the wall the place where the two +15 screws of the anti-tilt bracket have to be fitted. Please follow
Краткое содержание страницы № 9
Краткое содержание страницы № 10
1. After connecting the gas supply, check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak, tighten or replace connections as appropriate. Warning: Do not use any naked flame to check for leaks. 2. Adjust the test point pressure or supply pressure to the value which is appropriate for the gas type. 3. The operation of the appliance must be tested when installation is completed. 4. Turn on the appliance gas controls and light each burn
Краткое содержание страницы № 11
CONVERSION PROCEDURE (to convert to Natural gas or to ULPG) REPLACING THE INJECTORS This appliance is suitable for use with Natural gas or ULPG (check the “gas type” sticker attached to the appliance). A label stating the type of gas used after replacing the injectors must be attached at the rear of the appliance, in proximity of the gas inlet connection. The nominal gas consumption and injector size details are provided in table at page 13. To replace the injectors proceed as follows: ■ Remove
Краткое содержание страницы № 12
MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas tap is turned quickly from the maximum to the minimum position. If the burner does not remain lit, increase the minimum gas rate setting. The procedure for adjusting the minimum gas rate setting is described below. ■ T
Краткое содержание страницы № 13
TABLE FOR THE CHOICE OF THE INJECTORS Natural gas ULPG Test Point Pressure [kPa] 1.0 2.75 Injector Gas Injector Gas Orifice Dia. Consumption Orifice Dia. Consumption BURNER [mm] [MJ/h] [mm] [MJ/h] Auxiliary (A) 0.85 3.60 0.53 3.60 Semi-rapid (SR) 1.12 6.30 0.70 6.30 Triple ring (TC) 1.65 13.30 0.95 11.90 LUBRICATION OF THE GAS TAPS If the gas tap becomes stiff, it is necessary to dismantle it carefully and clean it with petroleum spirit. Specialist high temperature resistant grease should be
Краткое содержание страницы № 14
USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be consid- ered as inappropriate and therefore dangerous. ■ Do NOT place combustible materials or products on this appliance at any time. USING THE OVEN FOR THE FIRST TIME Operate as follows: ■ Assemble the wire racks on the oven walls using the 2 screws (fig. 13) interposing the catalytic panels A with the arrow up (
Краткое содержание страницы № 15
■ To eliminate traces of grease in Figure 14 manufacture it is necessary to pre- heat the oven at the maximum tem- perature: • For 60 minutes in the posi- tion, for 30 minutes in the position and for another 15 min- utes in the position. ■ Unscrew the fixing screws and slide off the wire racks and the catalytic liners to the oven wall as in fig. 13. The grill is secured to the rear wall of the oven on a hinge system that allows it to be lowered to allow proper access when cleaning the oven cei
Краткое содержание страницы № 16
TELESCOPIC SLIDING SHELF SUPPORTS The telescopic sliding shelf supports make it safer and easier to insert and remove the oven shelves and trays. They stop when they are pulled out to the maximum position. Important! When fitting the sliding shelf supports, make sure that you fit: ■ The slides to the top wire of a rack. They do not fit on the lower wire. ■ The slides so that they run out towards the oven door. ■ Both sides of each pair of shelf slides. ■ Both sides on the same level. ■ Note:
Краткое содержание страницы № 17
To remove the telescopic sliding shelf supports: – Remove the side racks and the catalytic liners by unscrewing the fixing screws (Fig. 18). – Lay down the telescopic sliding shelf support and side racks, with the telescopic slid- ing shelf support underneath. – Find the safety locks. These are the tabs that clip over the wire of the side rack (arrow 1 in Fig. 19). – Pull the safety locks away from the wire to release the wire (arrow 2 in Fig. 19). Cleaning the sliding shelf supports – Wipe the
Краткое содержание страницы № 18
CONTROL PANEL Figure 20 8 P A U T O 7564321 CONTROL PANEL - Controls description 1. Front right burner control knob 2. Rear right burner control knob 3. Rear left burner control knob 4. Front left burner control knob 5. Multifunction oven switch knob 6. Multifunction oven thermostat knob 7. Electronic programmer Pilot lamp: 8. Oven thermostat indicator light Please note: This appliance incorporates a safety cooling fan which you will hear operating whenever the oven or grill are in use. This fan
Краткое содержание страницы № 19
GAS HOB Figure 21 2 3 1 4 GAS BURNERS Natural Gas ULPG MJ/h MJ/h 1. Auxiliary burner (A) 3.6 3.6 2. Semi-rapid burner (SR) 6.3 6.3 3. Semi-rapid burner (SR) 6.3 6.3 4. Triple ring burner (TC) 13.3 11.9 19
Краткое содержание страницы № 20
LIGHTING GAS BURNERS FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION Figure 22 ■ Check that the electricity is switched on to allow spark igni- tion. ■ Make sure that all controls are turned to zero. ■ The gas flow to the burner is controlled by taps with safety cutout device. If the burner flame should go out, the safety cut-off valve will automatically stop the gas flow. The switch for the electric ignition is incorporat- ed in the knobs. ■ You control the flow by turning the knob i
