Руководство по эксплуатации Dakota Digital LED Tail Lights for 1956 Chevy Car LAT-NR200

Краткое содержание страницы № 1

INSTALLATION INSTRUCTIONS
LAT-NR200
LED Tail Lights for 1956 Chevy Car

MAN#650184

Kit Includes:

Installation:
1. Remove the two screws that are in the tail light lens, and
remove the lens.

2. Remove the light bulb.






3. Push and twist to remove the plastic bulb socket from the back side of the
housing.




4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the nut, washer, and aluminum sp

Краткое содержание страницы № 2

7. Insert the wires through the aluminum spacer, with one wire going through each one of the outer holes. Ensure wires are not pinched to avoid shorting! Slide the aluminum spacer over the stud thorough the hole in the center of the spacer, shoulder side toward the back of the tail light bezel. 8. Secure the aluminum spacer with the supplied #6 nut and lock washer. 9. Make sure the original lens gasket is in place and replace the tail light lens. Tighten the screws down

Краткое содержание страницы № 3

10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes