Руководство по эксплуатации Dakota Digital LED Tail Lights for 1968 Chevelle LAT-NR180

Краткое содержание страницы № 1

INSTALLATION INSTRUCTIONS
LAT-NR180
LED Tail Lights for 1968 Chevelle

MAN#650179

Kit Includes:

Installation:
1. Remove the chrome tail light cover. There are four nuts on the back of the housing.
2. Remove the tail light lens.
3. Remove the light bulb.
4. Remove the original bulb connector from the back side of the housing.










5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
6. Remove the nu

Краткое содержание страницы № 2

8. Feed the wires through the large hole in the back plate. Guide the back plate onto the back side of the housing. The flat side of the mounting disk should be toward the outside and the side with the slight raised center should go in towards the housing. This will align the mount in the original housing. 9. Secure the back plate with the supplied #6 nuts. 10. Install the lens and reassemble the housing, insuring all gaskets are intact and in place. MAN#650179

Краткое содержание страницы № 3

11. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 12. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the b