ملخص المحتوى في الصفحة رقم 1
TM
by
Aussie
PORTABLE LP Gas Grill
Assembly and Use Manual
MODEL 2200
For Customer Service, call
1-800-251-7558
®
www.meco.net
© MECO CORPORATION 2004
•READ AND FOLLOW INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY OR USE.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, SERIOUS
BODILY INJURY, AND/OR PROPERTY LOSS.
•FOR OUTDOOR HOUSEHOLD USE ONLY. NOT FOR COMMERCIAL USE.
•SOME PARTS MAY CONTAIN SHARP EDGES - ESPECIALLY WHERE NOTED IN THIS
MANUAL! WEAR PROTECTIVE GLOVES IF NECESSARY.
•THESE
ملخص المحتوى في الصفحة رقم 2
Contents I. IMPORTANT SAFEGUARDS............................................2 3) Grill Cooking...........................................................10 II. Preparation and Grill Set-up..............................................4 4) End of Cooking Session........................................10 III. Attaching the LP Gas Cylinder to the Regulator ..............6 5) Turning Off Your LP Gas Grill................................10 IV. Before Using Your LP Gas Grill.........................
ملخص المحتوى في الصفحة رقم 3
12. Keep any electrical supply cord away from any heated 25. WARNING! Do not move an LP gas grill when in surfaces. Electric cords should be placed away from use or hot. Allow to cool before moving, putting on or walkways to avoid a tripping hazard. removing parts and before cleaning or storing the grill. 13. Combustible materials should never be within 36 in. of the back or sides of your LP gas grill. 26. WARNING! Never touch hot surfaces. Use heat resistant gloves, long-handled tongs, o
ملخص المحتوى في الصفحة رقم 4
39. Your LP gas grill should be cleaned on a regular basis. 42. Do not operate the grill after it malfunctions, or is Refer to Care and Maintenance section in this manual. dropped or damaged in any manner. Contact Consumer Service for advice and replacement of parts. 40. Never douse the grill with water when its surfaces are hot because it may cause grease to splatter causing a 43. The use of accessory attachments not recommended by burn. the grill manufacturer may cause injury and void warr
ملخص المحتوى في الصفحة رقم 5
Right Handle Bar Bottom Shelf Hook FIG. 2 FIG. 3 FIG. 1 Pull Leg Locking Ring Down Open Legs Outward FIG. 6 FIG. 4 FIG. 5 Leg Spring Lock FIG. 9 FIG. 7 FIG. 8 Unlock Strap Open Side Tables FIG. 11 FIG. 10 Remove Hood Handle Open side toward you Handle on outside of grill FIG. 12 FIG. 14 FIG. 13 5
ملخص المحتوى في الصفحة رقم 6
ATTACHING THE LP GAS CYLINDER TO THE REGULATOR STEP 3B. (20 lb Cylinder) NOTE: Your Gas Grill uses a 1 lb. LP Cylinder Hook the 20 lb. Cylinder Disposable LP Cylinder but a 20 Hanger upright to the hanger on the lb. cylinder and 4 ft adaptor hose right side. Connect end of can be purchased separately. hose to Cylinder valve by STEP 1. Turn the Grill Control Knobs turning counter-clockwise to the “OFF” position. (FIG. 15A) and hand tighten. (FIG.16A) FIG. 16A STEP 2. Remove the protective cap
ملخص المحتوى في الصفحة رقم 7
A) If a leak appears at the connection of the Leak Test at Control 1 lb. cylinder/regulator, unscrew the cylinder Valve Nozzle Leak Test at and retighten, but by hand only. Do not use Regulator/Gas tools.) Repeat Leak Test. Cylinder B) If a leak appears at the hose/control vavle, Connections or nozzle connection, tighten the connection FIG. 17C with a wrench. C) If a leak appears at either end of the 20 lb. Leak Test at FIG. 17A cylinder/hose or hose /regulator connection, Hose /Regulator u
ملخص المحتوى في الصفحة رقم 8
REGULATOR ASSEMBLY Use only 1 lb. propane cylinders or 20 lb. propane cylinders with proper adaptor hose as specified above. · Using a hose and regulator assembly that has not Use of other gas cylinders could cause gas leak or fire. been supplied by the manufacturer of this LP gas grill, could result in serious bodily injury or property · Read manufacturer’s instructions and warnings on LP loss. cylinder. · Use only the hose and regulator assembly that has been · Never use an LP gas cylinder
ملخص المحتوى في الصفحة رقم 9
Lighting the Grill Using the Igniter Manual Lighting of the Grill · Open Hood before lighting the grill to prevent an · Open Hood before lighting the grill to prevent an explosion from gas build-up. explosion from gas build-up. · Always inspect the gas hose and regulator assembly · Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or before each use. If the hose is cut, damaged, or shows signs of excessive abrasion or wear, do not shows sign
ملخص المحتوى في الصفحة رقم 10
This could be a result of a blocked burner from grease Grill Cooking drippings or from insects building a nest inside the burner or 1) Place the Ribbed Cooking Surface in the Grill to the left burner opening. You should follow the Burner Maintenance with grease drain over the grease cup. Place the Smooth section of this manual for cleaning the burners. Cooking surface to the right and hook it over the Ribbed Surface. (FIG. 22A) 5) To preheat: With the Grill Hood closed, preheat on high for abou
ملخص المحتوى في الصفحة رقم 11
CARE AND MAINTENANCE Burner Maintenance 5) Control Valve Spring Clip · Check the LP gas grill for gas leaks and Burner obstructions before each use. FIG. 23B · Always turn off the Control Knobs when not in use. Allow grill to cool before handling parts or cleaning. Burners should be removed and cleaned annually, or whenever heavy build-up is found, to ensure that there are no signs of blockage (debris, insects) in either the burner portholes, the primary air inlet, or the neck of the burners.
ملخص المحتوى في الصفحة رقم 12
Cleaning the Grill LP Cylinder Storage CAUTION: SOME OF THE METAL EDGES MAY BE SHARP. BE CAREFUL IN HANDLING. · Never store an LP gas cylinder indoors even if empty. Regularly clean your LP gas grill between use and after If storing the gas grill indoors, disconnect the LP gas extended storage. To prolong the life and condition of your cylinder and store it outdoors out of the reach of grill, the portable unit should be covered if stored outside children. for any length of time, especially du
ملخص المحتوى في الصفحة رقم 13
· Store Leg Shelf back in the bottom of the grill and snap GRILL MOVING AND STORAGE into place. · Grasp the Right side Handle Bar; lift Grill on wheels and roll the grill away to storage area. (FIG. 25) DO NOT ATTEMPT TO CARRY THE GRILL BY GRASPING THE · Do not store the Grill unless it has cooled down and HOOD HANDLE has been cleaned. · Always Lock the Grill Hood with the Strap Lock Store Gas Regulator & Hose before moving and storing this Grill. · To avoid possible injury, be careful wh
ملخص المحتوى في الصفحة رقم 14
TROUBLESHOOTING Solution Problem Possible Cause Burner will not light LP gas cylinder is empty Dispose of empty cylinder and replace with a full one. using a match Excess flow valve tripped in Turn Control Knob to “OFF” position. Wait five minutes. Relight Regulator LP gas grill. If flame remains to be low, turn off gas. Disconnect the Lp gas cylinder from the Regulator. Reconnect the LP gas cylinder to the Regulator. Perform a leak test. Relight grill. This will reset the excess flow valve.
ملخص المحتوى في الصفحة رقم 15
REPLACEMENT PARTS 10 12 11 13 14 16 17 18 15 19 22 20 21 26 23 24 25 PARTS LIST ITEM DESCRIPTION PART # QTY. 1 Leg Shelf 03.6360.00 1 2 Handle 03.6361.00 1 3 6mm x 1 1/8" Threaded Screw 03.6362.00 2 4 Handle Spacer 03.6363.00 2 5 # 6 Lockwasher 03.6338.00 11 6 Regulator Hose Assy 03.6364.00 1 7 Stove Grate 03.6365.00 1 8 Smooth Cooking Surface 03.6366.00 1 9 Ribbed Cooking Surface 03.6367.00 1 10 Control Knob 03.6368.00 2 11 Control Panel 03.6369.00 1 12 6mm x 3/8" Threaded Screw 03.6343.00 10 1
ملخص المحتوى في الصفحة رقم 16
MECO CORPORATION LIMITED WARRANTY This product is warranted to the original consumer purchaser against defects in material and workman- ship under normal outdoor household use and correct assembly (if assembled by the consumer-pur- chaser). The Grill and its components are warranted for a period of one (1) year from the date of pur- chase. Meco Corporation DOES NOT warrant in any way the propane cylinder (see label on cylinder for cylinder manufacturer’s warranty.) The LP cylinder manufacture
