Mitsubishi Electronics MItsubish A Series Computer Link J71UC24の取扱説明書

ページ1に含まれる内容の要旨

Series HMI Connection Manual
Mitsubishi A Series/J71UC24 Computer Link
HMI Factory Setting:
Baud rate: 9600, 8, ODD, 1
Controller Station Number: 0 (Note 1)
Control Area / Status Area: D0/D10

Connection
a. RS-232 (DOP-A/AE/AS, DOP-B Series)
DOP Series Controller
9 pin D-sub male (RS-232)

RXD (2) (3) TXD


TXD (3) (2) RXD


GND (5) (5) SG


(1) CD


(4) DSR[DR]


(6) DTR[ER]



(7) CTS
b. RS-422 (DOP-A/AE Series)
DOP Series Control

ページ2に含まれる内容の要旨

Series HMI Connection Manual c. RS-422 (DOP-AS35/AS38/AS57 Series) DOP Series Controller 9 pin D-sub male (RS-422) R- SDB R+ SDA T+ RDA d. RS-422 (DOP-B Series) DOP Series Controller 9 pin D-sub male (RS-422) RXD- (9) SDB RXD+ (4) SDA TXD+ (1) RDA e. RS-485 (DOP-A/AE Series) DOP Series Controller 9 pin D-sub male (RS-485) TXD+ (3) RDA RXD+ (2) SDA RXD- (1) SDB V1.02 Revision Novemb

ページ3に含まれる内容の要旨

Series HMI Connection Manual f. RS-485 (DOP-AS57 Series) DOP Series Controller 9 pin D-sub male (RS-485) RDA R+ SDA RDB R- SDB g. RS-485 (DOP-AS35/AS38 Series) DOP Series Controller 9 pin D-sub male (RS-485) R+ RDA T+ SDA R- SDB h. RS-485 (DOP-B Series) DOP Series Controller 9 pin D-sub male (RS-485) RDA D+ (1) SDA RDB D- (6) SDB 110 V1.02 Revision November, 2011

ページ4に含まれる内容の要旨

Series HMI Connection Manual Definition of PLC Read/Write Address a. Registers Format Data Type Read/Write Range Note Length Word No. (n) Input Xn X0 – X7FF Word 3 Output Yn Y0 – X7FF Word 3 Link Relay Bn B0 – BFFF Word 3 Internal Relay Mn M0 – M8176 Word 3 Special Internal Relay SMn SM9000 – SM9240 Word 4 Latch Relay Ln L0 – L2032 Word 3 Annunciator Fn F0 – F2032 Word 3 Timer Value TNn TN0 – TN999 Word Counter Value CNn CN0 – CN999 Word Data Register Dn D0 – D8191 Word Special Da

ページ5に含まれる内容の要旨

Series HMI Connection Manual b. The mode switch setting of AJ71UC24-R4 communication is 8 (Form 4), station number can be determined by switch setting X1/X10. After PLC communication mode switch is set, please re-activate the PLC. The protocol is CheckSum and PLC Mode is Form 4. For switch setting of other communication parameter, please refers to Mitsubishi user manual. 2) Parameter is set by the programming software GX Developer, please refers to PLC user manual for set up instruction