Streszczenie treści zawartej na stronie nr. 1
YELLOWJACKET
manual version 2.1
PLUS
Streszczenie treści zawartej na stronie nr. 2
Contents INTRODUCTION................................................................................................. 2 STARTING UP................................................................................................... 2 YELLOWJACKET PLUS ACCESSORIES...................................................................... 2 MAIN SCREEN.................................................................................................. 4 OPTIONS SCREEN.........................
Streszczenie treści zawartej na stronie nr. 3
INTRODUCTION YellowjacketPLUS™ is an 802.11b analysis system consisting of an HP iPAQ PocketPC® coupled with custom hardware and software by BVS. This system contains a variety of features to analyze 802.11b networks including spectrum analysis over all 14 channels (2.401 – 2.495 GHz), a list of AP’s and/or stations over all 14 channels, multi-path and packet-error rate informa- tion for each individual MAC address. The YellowjacketPLUS also contains a “Geiger-counter” feature to locate a
Streszczenie treści zawartej na stronie nr. 4
The Yellowjacket SD Backup Installer card has been included as a courtesy. The card may be used to log data files onto. It can also be used on iPAQs that have never been initially set up at the BVS factory, have had files erased or dam- aged in the ROM or after a hard reset has been performed on an iPAQ. Yellowjacket software that has been erased/lost from RAM may be restored at anytime by accessing the “install” file from the SD Card or Storage Card directory. Always make sure batterie
Streszczenie treści zawartej na stronie nr. 5
Yellowjacket Main Screen Yellowjacket PLUS main screen allows access to all software menus. Use the stylus or the joystick to make a selection. You can back up and access the main screen anytime by pressing the joystick UP, DOWN, LEFT or RIGHT (the direction is indi- cated at the bottom of the page. Note that the firmware and serial number in the upper left corner appears indicating serial connection between the iPAQ and the Yellowjacket receiver. RTC MARKER MODE YellowjacketPLUS uses the i
Streszczenie treści zawartej na stronie nr. 6
Full Spectrum Mode The full spectrum screen has three available TRACES. These traces can be PEAK HOLD and VISIBLE/INVISIBLE. Only one trace can be active at any time. The buttons on the screen below the graph change the settings on the spectrum screen. There is also a PEAK SEARCH button that will put a diamond on the highest point in the spectrum at that time. RSSI and frequency information for that point will then be displayed on top of the graph. The BLINKING HEART on the top right indi
Streszczenie treści zawartej na stronie nr. 7
MAC AP/Station Survey Mode Choose “AP List” mode from the main screen to get to the AP List screen. The first screen will “survey” all 14 channels for available AP’s. This screen will show AP’s ONLY. The single channel mode can show all stations. The record number, absolute channel, whether or not it is authorized (if security is enabled), the MAC address, the SSID (for AP’s), the RSSI, and WEP (privacy enabled bit) are shown for each address. Arrows will appear in the header if more than
Streszczenie treści zawartej na stronie nr. 8
Multipath / Signal Quality Indicator (“Q” Factor) The bar graph on the lower left hand side of the multipath and the delay spread screens is known as the ‘Q’ factor graph. This graph uses a formula to determine the quality of the direct path and reflections of the signal by determining the ‘fatness’ of the main peak compared to the height of the direct path component. As the direct path gets stronger and sharper, the ‘Q’ factor goes up. As the path gets weaker and fatter, the ‘Q’ factor d
Streszczenie treści zawartej na stronie nr. 9
“Geiger-Counter” Mode To find an AP/station using audible sounds as a guide, press up on the joystick to enter the “Geiger-counter” screen. The colors will approach white when nearing and/or pointing directly at an AP or station. The Geiger counter sound will also get stronger with more frequency. Security Screen To go to the security screen, press the security icon from the main screen. The screen shown will appear. You may enter a list of AP’s that are authorized (up to 1000) to be a p
Streszczenie treści zawartej na stronie nr. 10
Utilization Screen The utilization screen shows bandwidth utilization for every 802.11b channel. The top of the screen shows the current channel being scanned (highlighted). The chart below shows the utilization from 0 to 100% for channels 1 thru 14. It is color coded to show the percentages for each data rate, as keyed on the bottom of the screen. The percentages add up the throughput of data at each data rate. For instance, if there were packets at 1Mb/s containing 500,000 bits, then th
Streszczenie treści zawartej na stronie nr. 11
Yellowjacket PLUS GPS Option The GPS screen of the Yellowjacket Plus provides position and timing information from the Global Positioning System of sat- ellites. The Motorola GPS receiver provides accurate informa- tion after synchronizing with at least 3 of the 24 satellites. The Yellowjacket Plus must have a clear view of a good por- tion of the sky in order to communicate with the GPS satel- lites. The GPS receiver should lock within a few minutes. The only exception is when the unit is tu
Streszczenie treści zawartej na stronie nr. 12
Yellowjacket Typical Spectrum Interference Examples INTERFERENCE Narrow Band - Continuous Wave INTERFERENCE Microwave Oven - Blue Trace - Peak Hold Red Trace - Realtime Page 11
Streszczenie treści zawartej na stronie nr. 13
INTERFERENCE - Frequency Hopper (802.11) Blue Trace - Peak Hold Red Trace - Realtime 802.11b DSSS Signal - Blue Trace - Peak Hold Red Trace - Realtime Page 12
Streszczenie treści zawartej na stronie nr. 14
INTERFERENCE-Bluetooth frequency Hopper (strong signal strength) Blue Trace - Peak Hold Red Trace - Realtime Page 13
Streszczenie treści zawartej na stronie nr. 15
Yellowjacket PLUS Pocket PC Software Flow Chart This screen may only be accessed using a YellowjacketplusPLUS with the internal GPS receiver option installed. Page 14
Streszczenie treści zawartej na stronie nr. 16
Troubleshooting • Active Sync not responding - Be sure that all applicable driv- ers are loaded onto your PC. Drivers are included with your IrDA USB adapter on a CD-ROM as well as drivers for Windows 2000, 98, XP and Me in a folder on the red BVS software CD labeled “IR”. • Cannot open Com port or System not responding – If the Yellowjacket PLUS stops responding, try pressing OK and restarting the application. If the Yellowjacket is still not responding, press the small reset button locat
Streszczenie treści zawartej na stronie nr. 17
YELLOWJACKET PLUS BATTERY CHARGING INSTRUCTIONS Please observe the two different battery status lights. When the amber status light on the iPAQ blinks, it is being charged and when it is on solid, it is fully charged. When there is no status light on iPAQ, there is no charge current. The charger status lights (label on back of charging station) only indicate the status of the Ni-MH battery pack inserted into the charger itself. Batteries may be charged using the charger station but NOT ALL
Streszczenie treści zawartej na stronie nr. 18
TIPS BATTERY LIFE The Grasshopper™, Locust™, Yellow Jacket™ and Yellow Jacket Plus (fomally called Scorpion), Beetle™, Cricket™, and Cicada W-LAN receivers use 4 or 5 Ni-MH long-lasting “AA Cells”. 1. Ni-MH batteries do not charge to full capacity the first time they are charged. 2. Ni-MH batteries do not charge to full capacity the first time they are charged after a long period of inactivity. or after a long period of non-use. Cause: When charging Ni-MH batteries for the first time after l
Streszczenie treści zawartej na stronie nr. 19
SOFTWARE INSTALLATION YELLOWJACKET SOFTWARE INSTALLATION FROM A SECURE DIGITAL (SD) CARD Yellowjacket software comes pre-installed on your iPAQ, but as a courtesy, BVS includes a 128MB SD card containing a Yellowjacket software installer should you provide your own iPAQ or lose the factory installed files. This SD card may be used to store Yellowjacket data or other data. Remember you must switch “lock” tab on side of SD card to “unlock” before storing or erasing any data. To install the Yello
Streszczenie treści zawartej na stronie nr. 20
BVS Viewer Utility The BVS Viewer Utility allows users of the YellowJacket series of products to display and print snapshots of full spectrum out- puts. The following steps are taken to display and print a snapshot. STEP 1: PRODUCE A SNAPSHOT While running the YellowJacket or YellowJacket Plus, enter into the fullband spectrum screen. This is the spectrum screen which sweeps the entire band of the receiver. When the desired output is seen on the display, press the camera icon in the men
